CITADEL MESH
MIDI TOWER CASE
MANUAL pamaké
eusi
nyumput
Eusi PACK AKSESORI
PANEL miceun
Hareup / sisi panyabutan panel
- Take off the front panel by pulling carefully from the bottom of the panel
- Remove the left side panel by pulling on the pull tab & swinging the door outwards, then lift off the hinges at the back of the case.
- Remove the right side pane by removing the two rear thrum screws and sliding the panel backwards
MOTHERBOARD INSTALLA
INSTALASI MOTHERBOARD
- Align your motherboard with the chassis to locate where the stand-offs should be installed Once done, remove the motherboard and fasten stand-offs accordingly
- Insert your motherboard I/O plate into the cutout at the rear of the case
- Place your motherboard into the chassis, making sure the rear ports fit into the I/O plate
- Use the provided motherboard screws to attach your motherboard to the chassis
INSTALASI POWER SUPPLY
INSTALASI POWER SUPPLY
- Place PSU in the bottom rear of the case, within the PSU shroud
- Align liang jeung aman jeung screws
KARTU GRAFIK / INSTALASI KARTU PCI-E
KARTU GRAFIK / INSTALASI KARTU PCI-E
- Cabut panutup slot PCI-E pungkur upami diperyogikeun (gumantung kana ukuran slot kartu anjeun)
- Carefully position and slide your PCI-E card into place, then secure with the add-on card screws supplied If mounting vertically, attach the vertical GPU mount to the PSU shroud, attach the Klink PCI-E Riser Cable (Sold separately). remove the rear PCI-E slot covers and put the card into place, mounting to the PCI-E Riser cable mount securely
- Remember to attach the other end of the PCI-E Riser cable to your motherboards PCI-E 16x slot
2.5″ SDD INSTALLATION (F)
INSTALASI SSD 2.5″ (hareup)
- Align your drive over the screw holes and secure with screws from the rear
2.5″ INSTALASI SDD (R)
INSTALASI SSD 2.5″ (GORENG)
Place your SSD on top of the HDD bracket and secure with screws
3.5″ pamasangan HDD
3.5″ pamasangan HDD
- Slide the drive into/onto the 3,5″ bay at the rear of the case
- Secure the drive on the both sides using the provided screws and hand tighten
INSTALASI kipas TOP
INSTALASI kipas TOP
- Remove the dust filter from the top of the case
- Align your fan(s) to the screw holes on the top of the chassis and secure with screws
- Replace your dust filter once secured
INSTALASI kipas hareup / tukang
INSTALASI kipas hareup / tukang
- Align your fan to the screw holes on the chassis and secure with screws
INSTALASI RADIATOR WATERCOOLING
INSTALASI RADIATOR WATERCOOLING
- Amankeun kipas kana radiator, teras pasangkeun radiator di jero sasis ku cara ngamankeun sekrup ti luar.
INSTALASI PANEL I/O
INSTALASI PANEL I/O
Carefully check the labelling of each connector from the 1/0 panel to identify their function
Cross reference with the motherboard manual to locate where each wire should be installed, then secure one at a time, Please ensure they are installed in the correct polarity to avoid non-function or damage
Dokumén / Sumberdaya
 |
KOLINK ANL-INT Citadel Mesh Midi Tower Case [pdf] Manual pamaké ANL-INT, ANL-INT Citadel Mesh Midi Tower Case, Citadel Mesh Midi Tower Case, Mesh Midi Tower Case, Midi Tower Case, Tower Case |