KOLINK ANL-INT Citadel Mesh Midi Tower Case User Manual

Remove the left side panel by pulling on the pull tab & swinging the door outwards, then lift off the hinges at the back of the case.
Remove the right side pane by removing the two rear thrum screws and sliding the panel backwards

MOTHERBOARD INSTALLA

INSTALLATION MOTHERBOARD

Align your motherboard with the chassis to locate where the stand-offs should be installed Once done, remove the motherboard and fasten stand-offs accordingly
Insert your motherboard I/O plate into the cutout at the rear of the case

Place your motherboard into the chassis, making sure the rear ports fit into the I/O plate
Use the provided motherboard screws to attach your motherboard to the chassis

FAMPIANARANA FAMPIANARANA

FAMPIANARANA FAMPIANARANA

Place PSU in the bottom rear of the case, within the PSU shroud
Ampifanaraho ireo lavaka ary arotsaho amin'ny visy

FAMPIANARANA KARATSY GRAPHICS/PCI-E

FAMPIANARANA KARATSY GRAPHICS/PCI-E

Esory ny fonon'ny slot PCI-E aoriana raha ilaina (arakaraka ny haben'ny karatrao)

Carefully position and slide your PCI-E card into place, then secure with the add-on card screws supplied If mounting vertically, attach the vertical GPU mount to the PSU shroud, attach the Klink PCI-E Riser Cable (Sold separately). remove the rear PCI-E slot covers and put the card into place, mounting to the PCI-E Riser cable mount securely
Remember to attach the other end of the PCI-E Riser cable to your motherboards PCI-E 16x slot

2.5″ SDD INSTALLATION (F)

Fametrahana SSD 2.5″ (eo anoloana)

Align your drive over the screw holes and secure with screws from the rear

2.5″ SDD fametrahana (R)

2.5″ SSD FAMPIANARANA (REO)
Place your SSD on top of the HDD bracket and secure with screws

Fametrahana HDD 3.5″

Fametrahana HDD 3.5″

Slide the drive into/onto the 3,5″ bay at the rear of the case
Secure the drive on the both sides using the provided screws and hand tighten

TOP FAN INSTALATION

TOP FAN INSTALATION

Remove the dust filter from the top of the case
Align your fan(s) to the screw holes on the top of the chassis and secure with screws

Replace your dust filter once secured

FAMPIANARANA FANAMPINY/VARIANA

FAMPIANARANA FANAMPINY/VARIANA

Align your fan to the screw holes on the chassis and secure with screws

FAMPIANARANA RADIATOR MANANA RANO

FAMPIANARANA RADIATOR MANANA RANO

Ampifandraiso amin'ny radiatera ny mpankafy, ary apetaho ao anaty chassis ny radiatera amin'ny alàlan'ny fametahana visy avy any ivelany.

Fametrahana PANEL I/O

Fametrahana PANEL I/O
Carefully check the labelling of each connector from the 1/0 panel to identify their function
Cross reference with the motherboard manual to locate where each wire should be installed, then secure one at a time, Please ensure they are installed in the correct polarity to avoid non-function or damage

Documents / Loharano

KOLINK ANL-INT Citadel Mesh Midi Tower Case [pdf] Boky Torolàlana
ANL-INT, ANL-INT Citadel Mesh Midi Tower Case, Citadel Mesh Midi Tower Case, Mesh Midi Tower Case, Midi Tower Case, Tower Case

References

User Manual

ACCESSORIES PACK VONITENY

FANALANA PANEL