Lambda CS-3000 Series Curve Tracer
Spesifikasi
- Model: Curve Tracer CS-3000 series (CS-3100, CS-3200, CS-3300)
- Collector Supply (HV Mode): Max.Peak voltage – 3 kV, Max. Peak current – 15 A, Max. peak power – 390 W
- Collector Supply (HC Mode): Max.PPeakvoltage – 30 V, Max. peak current – 7.5 A, Pulse width – 50 us to 400 us
- Step Generator: Step rate – 1/10 Step, Pulse width range – 50 us to 400 us
- Pengukuran: Kolektor voltage range – HV: 50 mV/div to 500 V/div, HC: 50 mV/div to 5 V/div
Pandhuan Panggunaan Produk
Pasokan Kolektor
For HV mode, set the max. Peak voltage and current according to the specifications. For HC mode, adjust the settings as needed.
Step Generator
Set the step rate and pulse width within the specified ranges for accurate measurements.
Pangukuran
Gunakake kolektor voltage range based on the mode of operation for precise readings.
Ideal for measuring the characteristics of various semiconductors such as IGBTs, MOSFETs, transistors, and diodes etc.
- Puncak maksimum voltage 3,000V (high voltage modus)
- Maximum peak current 1,000A (CS-3300 high current mode)
- All models equipped with LEAKAGE mode (1pA cursor resolution)
- USB port to save screen data and setup data
- Equipped with La LAN interface for remote control
Easy-to-understand measurement screen
CS-3000 Series Specifications
Collector supply HV mode
Model | CS-3100-300V * 2 | CS-3100 / CS-3200 / CS-3300 | |||
---|---|---|---|---|---|
Mode / polaritas | Full wave rectification/ + – , DC/ + – , LEAKAGE/ + – , AC | ||||
Puncak maksimum voltage | 300V | 30V | 3 kV | 300V | 30V |
Arus puncak maksimum (maximum peak pulse current * 1 ) |
750mA (1.5A * 1 ) |
7.5A (15A * 1 ) |
75mA (150mA * 1 ) |
750mA (1.5A * 1 ) |
7.5A (15A * 1 ) |
Daya puncak maksimal | 120mW / 1.2W / 120W / 390W (Cannot be set when using the maximum peak voltage of 3kV) | ||||
Horizontal axis range | 50mV~500V/div |
- The maximum instantaneous current value that can be generated (varies depending on the target to be measured and conditions), the measurement should be less than or equal to the maximum peak current value.
Collector supply HC mode
Model | CS-3100 / CS-3100-300V * 2 | CS-3200 | CS-3300 | |||
---|---|---|---|---|---|---|
Mode / polaritas | Not equipped with HC mode | Pulse/ + – | ||||
Puncak maksimum voltage | 40V | |||||
Arus puncak maksimum | 400A | 40A | 1,000A | 400A | 40A | |
Daya puncak maksimal | 4 kW | 400W | 10 kW | 4 kW | 400W | |
Jembar pulsa | Pulse width is variable at 50µs to 400µs (10µs resolution) | |||||
Titik pangukuran | The measurement point can be specified (10µs resolution) | |||||
Vertical axis range | 100mA~50A/div | 100mA~100A/div | ||||
Piranti tes | CS-301 | CS-302 |
Spesifikasi Umum
Loop correction | Hardware | Correction ofthe floating capacitance between the collector supply and the ground | |
Piranti lunak | Pseudo-looping through software optimisation | ||
Generator langkah | Offset | Range setelan | -10 ~ +10 x STEP AMPLITUDE Setting |
Resolusi | 1% of the STEP AMPLITUDE setting | ||
Mode saiki | Range | 50nA to 200mA per step, 21 steps, 1-2-5 switching | |
Saiki maksimum | 2A | ||
Vol maksimumtage | 10V utawa luwih | ||
Voltagmodus e | Range | 50mV to 2V per step, 6 steps, 1-2-5 switching | |
Saiki maksimum | 500mA~(~8V), 200mA~(~15V), 10mA~(~40V) | ||
Vol maksimumtage | ± 40V | ||
Tingkat langkah | 2x 50Hz or 60Hz (1x in AC mode), pulse interval in HC mode | ||
Langkah pulsa | Jembar pulsa | 50µs~400µs (10µs step) When in HC mode, the pulse width is 100µs wide before and after the pulse of the collector supply |
|
Jumlah langkah | 0~20 Step | ||
Output AUX | Range | OFF, -40V~+40V (Variable in 100mV steps) | |
Mode pangukuran | REPEAT, STOP/SINGLE, SWEEP | ||
Sumbu vertikal (full scale 10div) |
Kolektor arus | Range | HV mode:1µA/div to 2A/div, 20 steps 1-2-5 switching (HC mode is not included) |
Akurasi | 2% + 0.05 x VERT/div of readout To this, add the loop correction error for the following maximum peak voltages 0.5µA(30V), 1µA(300V), 6µA(3kV), 12µA(5kV) Specify at least 10% of the maximum peak voltage for 30V, 300V, and 3kV, and at least 30% for 5kV |
||
Emitter saiki (LEAKAGE) |
Range | 1nA/div~2mA/div, 20 step 1-2-5 switching (Collector supply mode is LEAKAGE) |
|
Akurasi | 2% + 0.05 x VERT/div + 1nA or less of readout | ||
Sumbu horisontal (full scale 10div) |
Kolektor voltage |
Range | HC mode:50mV/div to 5V/div, 7 steps 1-2-5 switching (HV mode is not included) |
Akurasi | 2% + 0.05 x HORIZ/div or less of readout | ||
Base/ emitor voltage |
Range | 50mV/div~5V/div, 7 step 1-2-5 switching | |
Akurasi | 2% + 0.05 x HORIZ/div or less of readout | ||
Tampilan | Tampilan | LCD TFT 8.4-inch | |
Jumlah titik data | 1,000 points/trace (AC, full wave rectification) 20~1,000 points/trace (SWEEP mode) |
||
Trace display | Point interpolation display, dot display | ||
Rata-rata | OFF, 2 to 255 times | ||
Ketekunan | OFF, SHORT, LONG, Infinite length | ||
Save internal waveform (REF) | 4 panel | ||
Kursor | DOT | Vert, Horiz, β or gm | |
fLINE | Vert, Horiz, 1/grad, intercept | ||
GRATIS | Vert, Horiz, β or gm | ||
JENDELA | Vert, Horiz, β or gm in the WINDOW area | ||
Data save/read | Memori | Setup:256 pcs, REF:4 screens | |
Memori eksternal | USB1.1:Setup, waveform, screen hardcopy (BMP, TIFF, PNG) | ||
remot | Equipped with a remote 10BASE-T/100BASE-TX 1 port via LAN connection | ||
sumber daya | AC100~240V 50/60Hz, Maximum operating power:500VA (400W), Standby:50VA (7W) | ||
External dimensions(mm) Bobot |
CS-3100 / CS-3100-300V * 2 | Approx. 424W x 220H x 555D (excluding protrusions and accessories) approx. 28kg (excluding accessories) |
|
CS-3200, 3300 | Approx. 424W x 354H x 555D (excluding protrusions and accessories) approx. 43kg (excluding accessories) |
CS-3100-300V is a made-to-order product.
Aksesoris Standar
CS-500 Test adaptor | |
---|---|
![]() |
This is a jig for connecting the part to be measured, provided by the customer, and the fixture. (Standard accessories) |
Pitakonan
P: Apa sing kudu daklakoni yen lebar pulsa sempit banget?
A: If the pulse width is narrow, adjust the settings to widen it within the allowable range to generate the max. peak voltage.
P: Kepiye cara kalibrasi output pasokan kolektor?
A: The collector supply output can be calibrated by enabling/disabling the output and adjusting the floating capacity as per the instructions provided.
Dokumen / Sumber Daya
![]() |
Lambda CS-3000 Series Curve Tracer [pdf] Instruksi Manual CS-3100, CS-3200, CS-3300, CS-3000 Series Curve Tracer, Curve Tracer, Tracer |