Lambda CS-3000 Series Curve Tracer
Техникалық сипаттамалар
- Model: Curve Tracer CS-3000 series (CS-3100, CS-3200, CS-3300)
- Collector Supply (HV Mode): Max.Peak voltage – 3 kV, Max. Peak current – 15 A, Max. peak power – 390 W
- Collector Supply (HC Mode): Max.PPeakvoltage – 30 V, Max. peak current – 7.5 A, Pulse width – 50 us to 400 us
- Step Generator: Step rate – 1/10 Step, Pulse width range – 50 us to 400 us
- Өлшем: Коллектор томtage range – HV: 50 mV/div to 500 V/div, HC: 50 mV/div to 5 V/div
Өнімді пайдалану нұсқаулары
Коллекторды жабдықтау
For HV mode, set the max. Peak voltage and current according to the specifications. For HC mode, adjust the settings as needed.
Қадам генераторы
Set the step rate and pulse width within the specified ranges for accurate measurements.
Өлшеу
Тиісті коллектордың томын пайдаланыңызtage range based on the mode of operation for precise readings.
Ideal for measuring the characteristics of various semiconductors such as IGBTs, MOSFETs, transistors, and diodes etc.
- Максималды шыңы томtage 3,000V (high voltage режимі)
- Maximum peak current 1,000A (CS-3300 high current mode)
- All models equipped with LEAKAGE mode (1pA cursor resolution)
- USB port to save screen data and setup data
- Equipped with La LAN interface for remote control
Easy-to-understand measurement screen
CS-3000 Series Specifications
Collector supply HV mode
Үлгі | CS-3100-300V * 2 | CS-3100 / CS-3200 / CS-3300 | |||
---|---|---|---|---|---|
Режим/полярлық | Full wave rectification/ + – , DC/ + – , LEAKAGE/ + – , AC | ||||
Максималды шыңы томtage | 300В | 30В | 3кВ | 300В | 30В |
Максималды ток күші (maximum peak pulse current * 1 ) |
750мА (1.5A * 1 ) |
7.5A (15A * 1 ) |
75мА (150mA * 1 ) |
750мА (1.5A * 1 ) |
7.5A (15A * 1 ) |
Максималды қуат | 120mW / 1.2W / 120W / 390W (Cannot be set when using the maximum peak voltage of 3kV) | ||||
Horizontal axis range | 50mV~500V/div |
- The maximum instantaneous current value that can be generated (varies depending on the target to be measured and conditions), the measurement should be less than or equal to the maximum peak current value.
Collector supply HC mode
Үлгі | CS-3100 / CS-3100-300V * 2 | CS-3200 | CS-3300 | |||
---|---|---|---|---|---|---|
Режим/полярлық | Not equipped with HC mode | Pulse/ + – | ||||
Максималды шыңы томtage | 40В | |||||
Максималды ток күші | 400A | 40A | 1,000A | 400A | 40A | |
Максималды қуат | 4кВт | 400 Вт | 10кВт | 4кВт | 400 Вт | |
Импульс ені | Pulse width is variable at 50µs to 400µs (10µs resolution) | |||||
Өлшеу нүктесі | The measurement point can be specified (10µs resolution) | |||||
Vertical axis range | 100mA~50A/div | 100mA~100A/div | ||||
Сынақ қондырғысы | CS-301 | CS-302 |
Жалпы сипаттамалар
Loop correction | Аппараттық құрал | Correction ofthe floating capacitance between the collector supply and the ground | |
Бағдарламалық қамтамасыз ету | Pseudo-looping through software optimisation | ||
Қадам генераторы | Офсет | Параметр диапазоны | -10 ~ +10 x STEP AMPLITUDE Setting |
Ажыратымдылық | 1% of the STEP AMPLITUDE setting | ||
Ағымдағы режим | Ауқым | 50nA to 200mA per step, 21 steps, 1-2-5 switching | |
Максималды ток | 2A | ||
Ең үлкен көлемtage | 10 В немесе одан көп | ||
Тtage режимі | Ауқым | 50mV to 2V per step, 6 steps, 1-2-5 switching | |
Максималды ток | 500mA~(~8V), 200mA~(~15V), 10mA~(~40V) | ||
Ең үлкен көлемtage | ±40 В | ||
Қадам жылдамдығы | 2x 50Hz or 60Hz (1x in AC mode), pulse interval in HC mode | ||
Импульстік қадам | Импульс ені | 50µs~400µs (10µs step) When in HC mode, the pulse width is 100µs wide before and after the pulse of the collector supply |
|
Қадамдар саны | 0~20 Step | ||
AUX шығысы | Ауқым | OFF, -40V~+40V (Variable in 100mV steps) | |
Өлшеу режимі | ҚАЙТАЛАУ, ТОҚТАТУ/БЕКІЛІК, сыпыру | ||
Тік ось (full scale 10div) |
Коллекторлық ток | Ауқым | HV mode:1µA/div to 2A/div, 20 steps 1-2-5 switching (HC mode is not included) |
Дәлдік | 2% + 0.05 x VERT/div of readout To this, add the loop correction error for the following maximum peak voltages 0.5µA(30V), 1µA(300V), 6µA(3kV), 12µA(5kV) Specify at least 10% of the maximum peak voltage for 30V, 300V, and 3kV, and at least 30% for 5kV |
||
Эмитент ток (LEAKAGE) |
Ауқым | 1nA/div~2mA/div, 20 step 1-2-5 switching (Collector supply mode is LEAKAGE) |
|
Дәлдік | 2% + 0.05 x VERT/div + 1nA or less of readout | ||
Көлденең ось (full scale 10div) |
Коллекционер томtage |
Ауқым | HC mode:50mV/div to 5V/div, 7 steps 1-2-5 switching (HV mode is not included) |
Дәлдік | 2% + 0.05 x HORIZ/div or less of readout | ||
Base/ эмитент томtage |
Ауқым | 50mV/div~5V/div, 7 step 1-2-5 switching | |
Дәлдік | 2% + 0.05 x HORIZ/div or less of readout | ||
Дисплей | Дисплей | 8.4 дюймдік TFT LCD | |
Деректер нүктелерінің саны | 1,000 points/trace (AC, full wave rectification) 20~1,000 points/trace (SWEEP mode) |
||
Trace display | Point interpolation display, dot display | ||
Орташа алу | OFF, 2 to 255 times | ||
Табандылық | OFF, SHORT, LONG, Infinite length | ||
Save internal waveform (REF) | 4-панель | ||
Курсор | DOT | Vert, Horiz, β or gm | |
fLINE | Vert, Horiz, 1/grad, intercept | ||
ТЕГІН | Vert, Horiz, β or gm | ||
ТЕРЕЗЕ | Vert, Horiz, β or gm in the WINDOW area | ||
Data save/read | Жад | Setup:256 pcs, REF:4 screens | |
Сыртқы жады | USB1.1:Setup, waveform, screen hardcopy (BMP, TIFF, PNG) | ||
Қашықтан | Equipped with a remote 10BASE-T/100BASE-TX 1 port via LAN connection | ||
Нәр беруші | AC100~240V 50/60Hz, Maximum operating power:500VA (400W), Standby:50VA (7W) | ||
External dimensions(mm) Салмағы |
CS-3100 / CS-3100-300V * 2 | Approx. 424W x 220H x 555D (excluding protrusions and accessories) approx. 28kg (excluding accessories) |
|
CS-3200, 3300 | Approx. 424W x 354H x 555D (excluding protrusions and accessories) approx. 43kg (excluding accessories) |
CS-3100-300V is a made-to-order product.
Стандартты аксессуарлар
CS-500 Сынақ адаптері | |
---|---|
![]() |
This is a jig for connecting the part to be measured, provided by the customer, and the fixture. (Standard accessories) |
Жиі қойылатын сұрақтар
С: Импульс ені тым тар болса, не істеуім керек?
A: If the pulse width is narrow, adjust the settings to widen it within the allowable range to generate the max. peak voltage.
С: Коллектордың шығысын қалай калибрлеуге болады?
A: The collector supply output can be calibrated by enabling/disabling the output and adjusting the floating capacity as per the instructions provided.
Құжаттар / Ресурстар
![]() |
Lambda CS-3000 Series Curve Tracer [pdf] Instruction Manual Curve Tracer, Curve Tracer, Curve Tracer |