Traçador de corbes Lambda sèrie CS-3000
Especificacions
- Model: Curve Tracer CS-3000 series (CS-3100, CS-3200, CS-3300)
- Collector Supply (HV Mode): Max.Peak voltage – 3 kV, Max. Peak current – 15 A, Max. peak power – 390 W
- Collector Supply (HC Mode): Max.PPeakvoltage – 30 V, Max. peak current – 7.5 A, Pulse width – 50 us to 400 us
- Step Generator: Step rate – 1/10 Step, Pulse width range – 50 us to 400 us
- Mesura: Volum del col·lectortage range – HV: 50 mV/div to 500 V/div, HC: 50 mV/div to 5 V/div
Instruccions d'ús del producte
Subministrament de col·leccionistes
For HV mode, set the max. Peak voltage and current according to the specifications. For HC mode, adjust the settings as needed.
Generador de passos
Set the step rate and pulse width within the specified ranges for accurate measurements.
Mesurament
Utilitzeu el volum de col·lector adequattage range based on the mode of operation for precise readings.
Ideal for measuring the characteristics of various semiconductors such as IGBTs, MOSFETs, transistors, and diodes etc.
- Vol màxim màximtage 3,000V (high voltagmode e)
- Maximum peak current 1,000A (CS-3300 high current mode)
- All models equipped with LEAKAGE mode (1pA cursor resolution)
- USB port to save screen data and setup data
- Equipped with La LAN interface for remote control
Easy-to-understand measurement screen
CS-3000 Series Specifications
Collector supply HV mode
| Model | CS-3100-300V * 2 | CS-3100 / CS-3200 / CS-3300 | |||
|---|---|---|---|---|---|
| Mode/polaritat | Full wave rectification/ + – , DC/ + – , LEAKAGE/ + – , AC | ||||
| Vol màxim màximtage | 300 V | 30 V | 3kV | 300 V | 30 V |
| Corrent màxima màxima (maximum peak pulse current * 1 ) |
750 mA (1.5A * 1 ) |
7.5A (15A * 1 ) |
75 mA (150mA * 1 ) |
750 mA (1.5A * 1 ) |
7.5A (15A * 1 ) |
| Potència màxima màxima | 120mW / 1.2W / 120W / 390W (Cannot be set when using the maximum peak voltage of 3kV) | ||||
| Horizontal axis range | 50mV～500V/div | ||||
- The maximum instantaneous current value that can be generated (varies depending on the target to be measured and conditions), the measurement should be less than or equal to the maximum peak current value.
Collector supply HC mode
| Model | CS-3100 / CS-3100-300V * 2 | CS-3200 | CS-3300 | |||
|---|---|---|---|---|---|---|
| Mode/polaritat | Not equipped with HC mode | Pulse/ + – | ||||
| Vol màxim màximtage | 40 V | |||||
| Corrent màxima màxima | 400A | 40A | 1,000A | 400A | 40A | |
| Potència màxima màxima | 4 kW | 400W | 10 kW | 4 kW | 400W | |
| Amplada del pols | Pulse width is variable at 50µs to 400µs (10µs resolution) | |||||
| Punt de mesura | The measurement point can be specified (10µs resolution) | |||||
| Vertical axis range | 100mA～50A/div | 100mA～100A/div | ||||
| Equip de prova | CS-301 | CS-302 | ||||
Especificacions comunes
| Loop correction | Maquinari | Correction ofthe floating capacitance between the collector supply and the ground | |
| Programari | Pseudo-looping through software optimisation | ||
| Generador de passos | Offset | Interval de configuració | -10 ～ +10 x STEP AMPLITUDE Setting |
| Resolució | 1% of the STEP AMPLITUDE setting | ||
| Mode actual | Interval | 50nA to 200mA per step, 21 steps, 1-2-5 switching | |
| Corrent màxima | 2A | ||
| Volum màximtage | 10 V o més | ||
| Voltagmode e | Interval | 50mV to 2V per step, 6 steps, 1-2-5 switching | |
| Corrent màxima | 500mA～(～8V), 200mA～(～15V), 10mA～(～40V) | ||
| Volum màximtage | ± 40 V | ||
| Velocitat de pas | 2x 50Hz or 60Hz (1x in AC mode), pulse interval in HC mode | ||
| Pas de pols | Amplada del pols | 50µs～400µs (10µs step) When in HC mode, the pulse width is 100µs wide before and after the pulse of the collector supply |
|
| Nombre de passos | 0～20 Step | ||
| Sortida AUX | Interval | OFF, -40V～+40V (Variable in 100mV steps) | |
| Mode de mesura | REPETIR, ATURAR/SINGLE, ESCOMBRAR | ||
| Eix vertical (full scale 10div) |
Corrent del col·lector | Interval | HV mode：1µA/div to 2A/div, 20 steps 1-2-5 switching (HC mode is not included) |
| Precisió | 2% + 0.05 x VERT/div of readout To this, add the loop correction error for the following maximum peak voltages 0.5µA(30V), 1µA(300V), 6µA(3kV), 12µA(5kV) Specify at least 10% of the maximum peak voltage for 30V, 300V, and 3kV, and at least 30% for 5kV |
||
| Emissor actual (LEAKAGE) |
Interval | 1nA/div～2mA/div, 20 step 1-2-5 switching (Collector supply mode is LEAKAGE) |
|
| Precisió | 2% + 0.05 x VERT/div + 1nA or less of readout | ||
| Eix horitzontal (full scale 10div) |
Col·leccionista voltage |
Interval | HC mode：50mV/div to 5V/div, 7 steps 1-2-5 switching (HV mode is not included) |
| Precisió | 2% + 0.05 x HORIZ/div or less of readout | ||
| Base/ emissor voltage |
Interval | 50mV/div~5V/div, 7 step 1-2-5 switching | |
| Precisió | 2% + 0.05 x HORIZ/div or less of readout | ||
| Mostra | Mostra | LCD TFT de 8.4 polzades | |
| Nombre de punts de dades | 1,000 points/trace (AC, full wave rectification) 20～1,000 points/trace (SWEEP mode) |
||
| Trace display | Point interpolation display, dot display | ||
| Mitjana | OFF, 2 to 255 times | ||
| La persistència | OFF, SHORT, LONG, Infinite length | ||
| Save internal waveform (REF) | 4-Tauler | ||
| Cursor | DOT | Vert, Horiz, β or gm | |
| fLINE | Vert, Horiz, 1/grad, intercept | ||
| GRATIS | Vert, Horiz, β or gm | ||
| FINESTRA | Vert, Horiz, β or gm in the WINDOW area | ||
| Data save/read | Memòria | Setup：256 pcs, REF：4 screens | |
| Memòria externa | USB1.1：Setup, waveform, screen hardcopy (BMP, TIFF, PNG) | ||
| Remot | Equipped with a remote 10BASE-T/100BASE-TX 1 port via LAN connection | ||
| Font d'alimentació | AC100～240V 50/60Hz, Maximum operating power：500VA (400W), Standby：50VA (7W) | ||
| External dimensions(mm) Pes |
CS-3100 / CS-3100-300V * 2 | Approx. 424W x 220H x 555D (excluding protrusions and accessories) approx. 28kg (excluding accessories) |
|
| CS-3200, 3300 | Approx. 424W x 354H x 555D (excluding protrusions and accessories) approx. 43kg (excluding accessories) |
||
CS-3100-300V is a made-to-order product.
Accessoris estàndard
| CS-500 Adaptador de prova | |
|---|---|
 |
This is a jig for connecting the part to be measured, provided by the customer, and the fixture. (Standard accessories) |
Preguntes freqüents
P: Què he de fer si l'amplada del pols és massa estreta?
A: If the pulse width is narrow, adjust the settings to widen it within the allowable range to generate the max. peak voltage.
P: Com es calibra la sortida de subministrament del col·lector?
A: The collector supply output can be calibrated by enabling/disabling the output and adjusting the floating capacity as per the instructions provided.
Documents/Recursos
 |
Traçador de corbes Lambda sèrie CS-3000 [pdfManual d'instruccions Traçador de corbes de la sèrie CS-3100, CS-3200, CS-3300, CS-3000, Traçador de corbes, Traçador |