Trazador de curvas Lambda serie CS-3000
Especificacións
- Model: Curve Tracer CS-3000 series (CS-3100, CS-3200, CS-3300)
- Collector Supply (HV Mode): Max.Peak voltage – 3 kV, Max. Peak current – 15 A, Max. peak power – 390 W
- Collector Supply (HC Mode): Max.PPeakvoltage – 30 V, Max. peak current – 7.5 A, Pulse width – 50 us to 400 us
- Step Generator: Step rate – 1/10 Step, Pulse width range – 50 us to 400 us
- Medición: Vol. do colectortage range – HV: 50 mV/div to 500 V/div, HC: 50 mV/div to 5 V/div
Instrucións de uso do produto
Suministro de coleccionistas
For HV mode, set the max. Peak voltage and current according to the specifications. For HC mode, adjust the settings as needed.
Xerador de pasos
Set the step rate and pulse width within the specified ranges for accurate measurements.
Medición
Usa o volume de colector axeitadotage range based on the mode of operation for precise readings.
Ideal for measuring the characteristics of various semiconductors such as IGBTs, MOSFETs, transistors, and diodes etc.
- Vol. pico máximotage 3,000V (high voltagmodo e)
- Maximum peak current 1,000A (CS-3300 high current mode)
- All models equipped with LEAKAGE mode (1pA cursor resolution)
- USB port to save screen data and setup data
- Equipped with La LAN interface for remote control
Easy-to-understand measurement screen
CS-3000 Series Specifications
Collector supply HV mode
| Modelo | CS-3100-300V * 2 | CS-3100 / CS-3200 / CS-3300 | |||
|---|---|---|---|---|---|
| Modo/polaridade | Full wave rectification/ + – , DC/ + – , LEAKAGE/ + – , AC | ||||
| Vol. pico máximotage | 300 V | 30 V | 3 kV | 300 V | 30 V |
| Corriente máxima máxima (maximum peak pulse current * 1 ) |
750 mA (1.5A * 1 ) |
7.5A (15A * 1 ) |
75 mA (150mA * 1 ) |
750 mA (1.5A * 1 ) |
7.5A (15A * 1 ) |
| Potencia máxima máxima | 120mW / 1.2W / 120W / 390W (Cannot be set when using the maximum peak voltage of 3kV) | ||||
| Horizontal axis range | 50mV～500V/div | ||||
- The maximum instantaneous current value that can be generated (varies depending on the target to be measured and conditions), the measurement should be less than or equal to the maximum peak current value.
Collector supply HC mode
| Modelo | CS-3100 / CS-3100-300V * 2 | CS-3200 | CS-3300 | |||
|---|---|---|---|---|---|---|
| Modo/polaridade | Not equipped with HC mode | Pulse/ + – | ||||
| Vol. pico máximotage | 40 V | |||||
| Corriente máxima máxima | 400A | 40A | 1,000A | 400A | 40A | |
| Potencia máxima máxima | 4 kW | 400 W | 10 kW | 4 kW | 400 W | |
| Ancho de pulso | Pulse width is variable at 50µs to 400µs (10µs resolution) | |||||
| Punto de medición | The measurement point can be specified (10µs resolution) | |||||
| Vertical axis range | 100mA～50A/div | 100mA～100A/div | ||||
| Accesorio de proba | CS-301 | CS-302 | ||||
Especificacións comúns
| Loop correction | Hardware | Correction ofthe floating capacitance between the collector supply and the ground | |
| Software | Pseudo-looping through software optimisation | ||
| Xerador de pasos | Offset | Rango de configuración | -10 ～ +10 x STEP AMPLITUDE Setting |
| Resolución | 1% of the STEP AMPLITUDE setting | ||
| Modo actual | Rango | 50nA to 200mA per step, 21 steps, 1-2-5 switching | |
| Corriente máxima | 2A | ||
| Vol. Máximotage | 10 V ou máis | ||
| Voltagmodo e | Rango | 50mV to 2V per step, 6 steps, 1-2-5 switching | |
| Corriente máxima | 500mA～(～8V), 200mA～(～15V), 10mA～(～40V) | ||
| Vol. Máximotage | ± 40 V | ||
| Velocidade de pasos | 2x 50Hz or 60Hz (1x in AC mode), pulse interval in HC mode | ||
| Paso de pulso | Ancho de pulso | 50µs～400µs (10µs step) When in HC mode, the pulse width is 100µs wide before and after the pulse of the collector supply |
|
| Número de pasos | 0～20 Step | ||
| Saída AUX | Rango | OFF, -40V～+40V (Variable in 100mV steps) | |
| Modo de medición | REPETIR, PARAR/ÚNICO, BARRIDO | ||
| Eixo vertical (full scale 10div) |
Corrente do colector | Rango | HV mode：1µA/div to 2A/div, 20 steps 1-2-5 switching (HC mode is not included) |
| Precisión | 2% + 0.05 x VERT/div of readout To this, add the loop correction error for the following maximum peak voltages 0.5µA(30V), 1µA(300V), 6µA(3kV), 12µA(5kV) Specify at least 10% of the maximum peak voltage for 30V, 300V, and 3kV, and at least 30% for 5kV |
||
| Emisor actual (LEAKAGE) |
Rango | 1nA/div～2mA/div, 20 step 1-2-5 switching (Collector supply mode is LEAKAGE) |
|
| Precisión | 2% + 0.05 x VERT/div + 1nA or less of readout | ||
| Eixo horizontal (full scale 10div) |
Coleccionista voltage |
Rango | HC mode：50mV/div to 5V/div, 7 steps 1-2-5 switching (HV mode is not included) |
| Precisión | 2% + 0.05 x HORIZ/div or less of readout | ||
| Base/ emisor voltage |
Rango | 50mV/div~5V/div, 7 step 1-2-5 switching | |
| Precisión | 2% + 0.05 x HORIZ/div or less of readout | ||
| Mostrar | Mostrar | LCD TFT de 8.4 polgadas | |
| Número de puntos de datos | 1,000 points/trace (AC, full wave rectification) 20～1,000 points/trace (SWEEP mode) |
||
| Trace display | Point interpolation display, dot display | ||
| Promediando | OFF, 2 to 255 times | ||
| Persistencia | OFF, SHORT, LONG, Infinite length | ||
| Save internal waveform (REF) | 4 paneis | ||
| Cursor | DOT | Vert, Horiz, β or gm | |
| fLINE | Vert, Horiz, 1/grad, intercept | ||
| GRATIS | Vert, Horiz, β or gm | ||
| XANÁ | Vert, Horiz, β or gm in the WINDOW area | ||
| Data save/read | Memoria | Setup：256 pcs, REF：4 screens | |
| Memoria externa | USB1.1：Setup, waveform, screen hardcopy (BMP, TIFF, PNG) | ||
| Mando a distancia | Equipped with a remote 10BASE-T/100BASE-TX 1 port via LAN connection | ||
| Fonte de alimentación | AC100～240V 50/60Hz, Maximum operating power：500VA (400W), Standby：50VA (7W) | ||
| External dimensions(mm) Peso |
CS-3100 / CS-3100-300V * 2 | Approx. 424W x 220H x 555D (excluding protrusions and accessories) approx. 28kg (excluding accessories) |
|
| CS-3200, 3300 | Approx. 424W x 354H x 555D (excluding protrusions and accessories) approx. 43kg (excluding accessories) |
||
CS-3100-300V is a made-to-order product.
Accesorios estándar
| CS-500 Adaptador de proba | |
|---|---|
 |
This is a jig for connecting the part to be measured, provided by the customer, and the fixture. (Standard accessories) |
Preguntas frecuentes
P: Que debo facer se o ancho do pulso é demasiado estreito?
A: If the pulse width is narrow, adjust the settings to widen it within the allowable range to generate the max. peak voltage.
P: Como calibrar a saída de subministración do colector?
A: The collector supply output can be calibrated by enabling/disabling the output and adjusting the floating capacity as per the instructions provided.
Documentos/Recursos
 |
Trazador de curvas Lambda serie CS-3000 [pdfManual de instrucións Trazador de curvas da serie CS-3100, CS-3200, CS-3300, CS-3000, Trazador de curvas, Trazador |