Sledovač kriviek série Lambda CS-3000
Špecifikácie
- Model: Curve Tracer CS-3000 series (CS-3100, CS-3200, CS-3300)
- Collector Supply (HV Mode): Max.Peak voltage – 3 kV, Max. Peak current – 15 A, Max. peak power – 390 W
- Collector Supply (HC Mode): Max.PPeakvoltage – 30 V, Max. peak current – 7.5 A, Pulse width – 50 us to 400 us
- Step Generator: Step rate – 1/10 Step, Pulse width range – 50 us to 400 us
- Meranie: Objem kolektoratage range – HV: 50 mV/div to 500 V/div, HC: 50 mV/div to 5 V/div
Návod na použitie produktu
Zberateľská ponuka
For HV mode, set the max. Peak voltage and current according to the specifications. For HC mode, adjust the settings as needed.
Krokový generátor
Set the step rate and pulse width within the specified ranges for accurate measurements.
Meranie
Použite vhodný objem kolektoratage range based on the mode of operation for precise readings.
Ideal for measuring the characteristics of various semiconductors such as IGBTs, MOSFETs, transistors, and diodes etc.
- Maximálny vrchol objtage 3,000V (high voltage režim)
- Maximum peak current 1,000A (CS-3300 high current mode)
- All models equipped with LEAKAGE mode (1pA cursor resolution)
- USB port to save screen data and setup data
- Equipped with La LAN interface for remote control
Easy-to-understand measurement screen
CS-3000 Series Specifications
Collector supply HV mode
| Model | CS-3100-300V * 2 | CS-3100 / CS-3200 / CS-3300 | |||
|---|---|---|---|---|---|
| Režim/polarita | Full wave rectification/ + – , DC/ + – , LEAKAGE/ + – , AC | ||||
| Maximálny vrchol objtage | 300 V | 30 V | 3 kV | 300 V | 30 V |
| Maximálny špičkový prúd (maximum peak pulse current * 1 ) |
750 mA (1.5A * 1 ) |
7.5A (15A * 1 ) |
75 mA (150mA * 1 ) |
750 mA (1.5A * 1 ) |
7.5A (15A * 1 ) |
| Maximálny špičkový výkon | 120mW / 1.2W / 120W / 390W (Cannot be set when using the maximum peak voltage of 3kV) | ||||
| Horizontal axis range | 50mV～500V/div | ||||
- The maximum instantaneous current value that can be generated (varies depending on the target to be measured and conditions), the measurement should be less than or equal to the maximum peak current value.
Collector supply HC mode
| Model | CS-3100 / CS-3100-300V * 2 | CS-3200 | CS-3300 | |||
|---|---|---|---|---|---|---|
| Režim/polarita | Not equipped with HC mode | Pulse/ + – | ||||
| Maximálny vrchol objtage | 40 V | |||||
| Maximálny špičkový prúd | 400A | 40A | 1,000A | 400A | 40A | |
| Maximálny špičkový výkon | 4 kW | 400 W | 10 kW | 4 kW | 400 W | |
| Šírka impulzu | Pulse width is variable at 50µs to 400µs (10µs resolution) | |||||
| Bod merania | The measurement point can be specified (10µs resolution) | |||||
| Vertical axis range | 100mA～50A/div | 100mA～100A/div | ||||
| Testovacie zariadenie | CS-301 | CS-302 | ||||
Spoločné špecifikácie
| Loop correction | Hardvér | Correction ofthe floating capacitance between the collector supply and the ground | |
| softvér | Pseudo-looping through software optimisation | ||
| Generátor krokov | Offset | Rozsah nastavenia | -10 ～ +10 x STEP AMPLITUDE Setting |
| Rozlíšenie | 1% of the STEP AMPLITUDE setting | ||
| Aktuálny režim | Rozsah | 50nA to 200mA per step, 21 steps, 1-2-5 switching | |
| Maximálny prúd | 2A | ||
| Maximálny objemtage | 10V alebo viac | ||
| Voltagrežim e | Rozsah | 50mV to 2V per step, 6 steps, 1-2-5 switching | |
| Maximálny prúd | 500mA～(～8V), 200mA～(～15V), 10mA～(～40V) | ||
| Maximálny objemtage | ±40V | ||
| Kroková rýchlosť | 2x 50Hz or 60Hz (1x in AC mode), pulse interval in HC mode | ||
| Krok impulzu | Šírka impulzu | 50µs～400µs (10µs step) When in HC mode, the pulse width is 100µs wide before and after the pulse of the collector supply |
|
| Počet krokov | 0～20 Step | ||
| AUX výstup | Rozsah | OFF, -40V～+40V (Variable in 100mV steps) | |
| Režim merania | OPAKOVANIE, STOP/JEDNODUCHÉ PREHRÁVANIE, PREHLIADANIE | ||
| Vertikálna os (full scale 10div) |
Zberný prúd | Rozsah | HV mode：1µA/div to 2A/div, 20 steps 1-2-5 switching (HC mode is not included) |
| Presnosť | 2% + 0.05 x VERT/div of readout To this, add the loop correction error for the following maximum peak voltages 0.5µA(30V), 1µA(300V), 6µA(3kV), 12µA(5kV) Specify at least 10% of the maximum peak voltage for 30V, 300V, and 3kV, and at least 30% for 5kV |
||
| Emitor prúd (LEAKAGE) |
Rozsah | 1nA/div～2mA/div, 20 step 1-2-5 switching (Collector supply mode is LEAKAGE) |
|
| Presnosť | 2% + 0.05 x VERT/div + 1nA or less of readout | ||
| Vodorovná os (full scale 10div) |
Zberateľ zvtage |
Rozsah | HC mode：50mV/div to 5V/div, 7 steps 1-2-5 switching (HV mode is not included) |
| Presnosť | 2% + 0.05 x HORIZ/div or less of readout | ||
| Base/ žiarič zvtage |
Rozsah | 50mV/div~5V/div, 7 step 1-2-5 switching | |
| Presnosť | 2% + 0.05 x HORIZ/div or less of readout | ||
| Displej | Displej | 8.4-palcový TFT LCD | |
| Počet údajových bodov | 1,000 points/trace (AC, full wave rectification) 20～1,000 points/trace (SWEEP mode) |
||
| Trace display | Point interpolation display, dot display | ||
| Priemerovanie | OFF, 2 to 255 times | ||
| Vytrvalosť | OFF, SHORT, LONG, Infinite length | ||
| Save internal waveform (REF) | 4 panelov | ||
| Kurzor | BODKA | Vert, Horiz, β or gm | |
| fLINE | Vert, Horiz, 1/grad, intercept | ||
| ZDARMA | Vert, Horiz, β or gm | ||
| OKNO | Vert, Horiz, β or gm in the WINDOW area | ||
| Data save/read | pamäť | Setup：256 pcs, REF：4 screens | |
| Externá pamäť | USB1.1：Setup, waveform, screen hardcopy (BMP, TIFF, PNG) | ||
| Diaľkové ovládanie | Equipped with a remote 10BASE-T/100BASE-TX 1 port via LAN connection | ||
| Napájanie | AC100～240V 50/60Hz, Maximum operating power：500VA (400W), Standby：50VA (7W) | ||
| External dimensions(mm) Hmotnosť |
CS-3100 / CS-3100-300V * 2 | Approx. 424W x 220H x 555D (excluding protrusions and accessories) approx. 28kg (excluding accessories) |
|
| CS-3200, 3300 | Approx. 424W x 354H x 555D (excluding protrusions and accessories) approx. 43kg (excluding accessories) |
||
CS-3100-300V is a made-to-order product.
Štandardné príslušenstvo
| CS-500 Testovací adaptér | |
|---|---|
 |
This is a jig for connecting the part to be measured, provided by the customer, and the fixture. (Standard accessories) |
často kladené otázky
Otázka: Čo mám robiť, ak je šírka impulzu príliš úzka?
A: If the pulse width is narrow, adjust the settings to widen it within the allowable range to generate the max. peak voltage.
Otázka: Ako kalibrovať výstup napájania kolektora?
A: The collector supply output can be calibrated by enabling/disabling the output and adjusting the floating capacity as per the instructions provided.
Dokumenty / zdroje
 |
Sledovač kriviek série Lambda CS-3000 [pdfNávod na obsluhu Sledovač kriviek série CS-3100, CS-3200, CS-3300, CS-3000, sledovač kriviek, sledovač |