Lambda CS-3000 Series Curve Tracer
ਨਿਰਧਾਰਨ
- Model: Curve Tracer CS-3000 series (CS-3100, CS-3200, CS-3300)
- Collector Supply (HV Mode): Max.Peak voltage – 3 kV, Max. Peak current – 15 A, Max. peak power – 390 W
- Collector Supply (HC Mode): Max.PPeakvoltage – 30 V, Max. peak current – 7.5 A, Pulse width – 50 us to 400 us
- Step Generator: Step rate – 1/10 Step, Pulse width range – 50 us to 400 us
- Measurement: Collector voltage range – HV: 50 mV/div to 500 V/div, HC: 50 mV/div to 5 V/div
ਉਤਪਾਦ ਵਰਤੋਂ ਨਿਰਦੇਸ਼
Collector Supply
For HV mode, set the max. Peak voltage and current according to the specifications. For HC mode, adjust the settings as needed.
ਸਟੈਪ ਜੇਨਰੇਟਰ
Set the step rate and pulse width within the specified ranges for accurate measurements.
ਮਾਪ
Use the appropriate collector voltage range based on the mode of operation for precise readings.
Ideal for measuring the characteristics of various semiconductors such as IGBTs, MOSFETs, transistors, and diodes etc.
- ਅਧਿਕਤਮ ਪੀਕ ਵੋਲtage 3,000V (high voltage ਮੋਡ)
- Maximum peak current 1,000A (CS-3300 high current mode)
- All models equipped with LEAKAGE mode (1pA cursor resolution)
- USB port to save screen data and setup data
- Equipped with La LAN interface for remote control
Easy-to-understand measurement screen
CS-3000 Series Specifications
Collector supply HV mode
| ਮਾਡਲ | CS-3100-300V * 2 | CS-3100 / CS-3200 / CS-3300 | |||
|---|---|---|---|---|---|
| Mode/polarity | Full wave rectification/ + – , DC/ + – , LEAKAGE/ + – , AC | ||||
| ਅਧਿਕਤਮ ਪੀਕ ਵੋਲtage | 300 ਵੀ | 30 ਵੀ | 3kV | 300 ਵੀ | 30 ਵੀ |
| ਅਧਿਕਤਮ ਸਿਖਰ ਮੌਜੂਦਾ (maximum peak pulse current * 1 ) |
750mA (1.5A * 1 ) |
7.5 ਏ (15A * 1 ) |
75mA (150mA * 1 ) |
750mA (1.5A * 1 ) |
7.5 ਏ (15A * 1 ) |
| ਅਧਿਕਤਮ ਪੀਕ ਪਾਵਰ | 120mW / 1.2W / 120W / 390W (Cannot be set when using the maximum peak voltage of 3kV) | ||||
| Horizontal axis range | 50mV～500V/div | ||||
- The maximum instantaneous current value that can be generated (varies depending on the target to be measured and conditions), the measurement should be less than or equal to the maximum peak current value.
Collector supply HC mode
| ਮਾਡਲ | CS-3100 / CS-3100-300V * 2 | CS-3200 | CS-3300 | |||
|---|---|---|---|---|---|---|
| Mode/polarity | Not equipped with HC mode | Pulse/ + – | ||||
| ਅਧਿਕਤਮ ਪੀਕ ਵੋਲtage | 40 ਵੀ | |||||
| ਅਧਿਕਤਮ ਸਿਖਰ ਮੌਜੂਦਾ | 400 ਏ | 40 ਏ | 1,000 ਏ | 400 ਏ | 40 ਏ | |
| ਅਧਿਕਤਮ ਪੀਕ ਪਾਵਰ | 4 ਕਿਲੋਵਾਟ | 400 ਡਬਲਯੂ | 10 ਕਿਲੋਵਾਟ | 4 ਕਿਲੋਵਾਟ | 400 ਡਬਲਯੂ | |
| ਪਲਸ ਚੌੜਾਈ | Pulse width is variable at 50µs to 400µs (10µs resolution) | |||||
| ਮਾਪ ਬਿੰਦੂ | The measurement point can be specified (10µs resolution) | |||||
| Vertical axis range | 100mA～50A/div | 100mA～100A/div | ||||
| ਟੈਸਟ ਫਿਕਸਚਰ | CS-301 | CS-302 | ||||
ਆਮ ਨਿਰਧਾਰਨ
| Loop correction | ਹਾਰਡਵੇਅਰ | Correction ofthe floating capacitance between the collector supply and the ground | |
| ਸਾਫਟਵੇਅਰ | Pseudo-looping through software optimisation | ||
| Step generator | ਆਫਸੈੱਟ | ਸੈੱਟਿੰਗ ਰੇਂਜ | -10 ～ +10 x STEP AMPLITUDE Setting |
| ਮਤਾ | 1% of the STEP AMPLITUDE setting | ||
| ਮੌਜੂਦਾ .ੰਗ | ਰੇਂਜ | 50nA to 200mA per step, 21 steps, 1-2-5 switching | |
| ਅਧਿਕਤਮ ਮੌਜੂਦਾ | 2A | ||
| ਵੱਧ ਤੋਂ ਵੱਧ ਵਾਲੀਅਮtage | 10V ਜਾਂ ਵੱਧ | ||
| ਵੋਲtagਈ ਮੋਡ | ਰੇਂਜ | 50mV to 2V per step, 6 steps, 1-2-5 switching | |
| ਅਧਿਕਤਮ ਮੌਜੂਦਾ | 500mA～(～8V), 200mA～(～15V), 10mA～(～40V) | ||
| ਵੱਧ ਤੋਂ ਵੱਧ ਵਾਲੀਅਮtage | ±40V | ||
| ਕਦਮ ਦਰ | 2x 50Hz or 60Hz (1x in AC mode), pulse interval in HC mode | ||
| Pulse step | ਪਲਸ ਚੌੜਾਈ | 50µs～400µs (10µs step) When in HC mode, the pulse width is 100µs wide before and after the pulse of the collector supply |
|
| ਕਦਮਾਂ ਦੀ ਸੰਖਿਆ | 0～20 Step | ||
| AUX ਆਉਟਪੁੱਟ | ਰੇਂਜ | OFF, -40V～+40V (Variable in 100mV steps) | |
| ਮਾਪ ਮੋਡ | REPEAT, STOP/SINGLE, SWEEP | ||
| ਲੰਬਕਾਰੀ ਧੁਰਾ (full scale 10div) |
ਕੁਲੈਕਟਰ ਕਰੰਟ | ਰੇਂਜ | HV mode：1µA/div to 2A/div, 20 steps 1-2-5 switching (HC mode is not included) |
| ਸ਼ੁੱਧਤਾ | 2% + 0.05 x VERT/div of readout To this, add the loop correction error for the following maximum peak voltages 0.5µA(30V), 1µA(300V), 6µA(3kV), 12µA(5kV) Specify at least 10% of the maximum peak voltage for 30V, 300V, and 3kV, and at least 30% for 5kV |
||
| ਐਮੀਟਰ ਮੌਜੂਦਾ (LEAKAGE) |
ਰੇਂਜ | 1nA/div～2mA/div, 20 step 1-2-5 switching (Collector supply mode is LEAKAGE) |
|
| ਸ਼ੁੱਧਤਾ | 2% + 0.05 x VERT/div + 1nA or less of readout | ||
| ਹਰੀਜ਼ੱਟਲ ਧੁਰਾ (full scale 10div) |
ਕੁਲੈਕਟਰ voltage |
ਰੇਂਜ | HC mode：50mV/div to 5V/div, 7 steps 1-2-5 switching (HV mode is not included) |
| ਸ਼ੁੱਧਤਾ | 2% + 0.05 x HORIZ/div or less of readout | ||
| Base/ emitter voltage |
ਰੇਂਜ | 50mV/div~5V/div, 7 step 1-2-5 switching | |
| ਸ਼ੁੱਧਤਾ | 2% + 0.05 x HORIZ/div or less of readout | ||
| ਡਿਸਪਲੇ | ਡਿਸਪਲੇ | 8.4 ਇੰਚ ਟੀ.ਐਫ.ਟੀ.ਐੱਲ.ਸੀ.ਡੀ. | |
| ਡਾਟਾ ਪੁਆਇੰਟਾਂ ਦੀ ਗਿਣਤੀ | 1,000 points/trace (AC, full wave rectification) 20～1,000 points/trace (SWEEP mode) |
||
| Trace display | Point interpolation display, dot display | ||
| ਔਸਤ | OFF, 2 to 255 times | ||
| ਦ੍ਰਿੜਤਾ | OFF, SHORT, LONG, Infinite length | ||
| Save internal waveform (REF) | 4-ਪੈਨਲ | ||
| ਕਰਸਰ | ਡੀ.ਓ.ਟੀ | Vert, Horiz, β or gm | |
| fLINE | Vert, Horiz, 1/grad, intercept | ||
| ਮੁਫ਼ਤ | Vert, Horiz, β or gm | ||
| ਵਿੰਡੋ | Vert, Horiz, β or gm in the WINDOW area | ||
| Data save/read | ਮੈਮੋਰੀ | Setup：256 pcs, REF：4 screens | |
| ਬਾਹਰੀ ਮੈਮੋਰੀ | USB1.1：Setup, waveform, screen hardcopy (BMP, TIFF, PNG) | ||
| ਰਿਮੋਟ | Equipped with a remote 10BASE-T/100BASE-TX 1 port via LAN connection | ||
| ਬਿਜਲੀ ਦੀ ਸਪਲਾਈ | AC100～240V 50/60Hz, Maximum operating power：500VA (400W), Standby：50VA (7W) | ||
| External dimensions(mm) ਭਾਰ |
CS-3100 / CS-3100-300V * 2 | Approx. 424W x 220H x 555D (excluding protrusions and accessories) approx. 28kg (excluding accessories) |
|
| CS-3200, 3300 | Approx. 424W x 354H x 555D (excluding protrusions and accessories) approx. 43kg (excluding accessories) |
||
CS-3100-300V is a made-to-order product.
ਮਿਆਰੀ ਸਹਾਇਕ
| CS-500 ਟੈਸਟ ਅਡਾਪਟਰ | |
|---|---|
 |
This is a jig for connecting the part to be measured, provided by the customer, and the fixture. (Standard accessories) |
ਅਕਸਰ ਪੁੱਛੇ ਜਾਂਦੇ ਸਵਾਲ
Q: What should I do if the pulse width is too narrow?
A: If the pulse width is narrow, adjust the settings to widen it within the allowable range to generate the max. peak voltage.
Q: How to calibrate the collector supply output?
A: The collector supply output can be calibrated by enabling/disabling the output and adjusting the floating capacity as per the instructions provided.
ਦਸਤਾਵੇਜ਼ / ਸਰੋਤ
 |
Lambda CS-3000 Series Curve Tracer [pdf] ਹਦਾਇਤ ਮੈਨੂਅਲ CS-3100, CS-3200, CS-3300, CS-3000 Series Curve Tracer, Curve Tracer, Tracer |