Lambda CS-3000 Series Curve Tracer
तपशील
- Model: Curve Tracer CS-3000 series (CS-3100, CS-3200, CS-3300)
- Collector Supply (HV Mode): Max.Peak voltage – 3 kV, Max. Peak current – 15 A, Max. peak power – 390 W
- Collector Supply (HC Mode): Max.PPeakvoltage – 30 V, Max. peak current – 7.5 A, Pulse width – 50 us to 400 us
- Step Generator: Step rate – 1/10 Step, Pulse width range – 50 us to 400 us
- Measurement: Collector voltage range – HV: 50 mV/div to 500 V/div, HC: 50 mV/div to 5 V/div
उत्पादन वापर सूचना
Collector Supply
For HV mode, set the max. Peak voltage and current according to the specifications. For HC mode, adjust the settings as needed.
स्टेप जनरेटर
Set the step rate and pulse width within the specified ranges for accurate measurements.
मोजमाप
Use the appropriate collector voltage range based on the mode of operation for precise readings.
Ideal for measuring the characteristics of various semiconductors such as IGBTs, MOSFETs, transistors, and diodes etc.
- कमाल शिखर खंडtage 3,000V (high voltagई मोड)
- Maximum peak current 1,000A (CS-3300 high current mode)
- All models equipped with LEAKAGE mode (1pA cursor resolution)
- USB port to save screen data and setup data
- Equipped with La LAN interface for remote control
Easy-to-understand measurement screen
CS-3000 Series Specifications
Collector supply HV mode
| मॉडेल | CS-3100-300V * 2 | CS-3100 / CS-3200 / CS-3300 | |||
|---|---|---|---|---|---|
| Mode/polarity | Full wave rectification/ + – , DC/ + – , LEAKAGE/ + – , AC | ||||
| कमाल शिखर खंडtage | 300V | 30V | 3kV | 300V | 30V |
| कमाल शिखर वर्तमान (maximum peak pulse current * 1 ) |
750mA (1.5A * 1 ) |
7.5A (15A * 1 ) |
75mA (150mA * 1 ) |
750mA (1.5A * 1 ) |
7.5A (15A * 1 ) |
| कमाल शिखर शक्ती | 120mW / 1.2W / 120W / 390W (Cannot be set when using the maximum peak voltage of 3kV) | ||||
| Horizontal axis range | 50mV～500V/div | ||||
- The maximum instantaneous current value that can be generated (varies depending on the target to be measured and conditions), the measurement should be less than or equal to the maximum peak current value.
Collector supply HC mode
| मॉडेल | CS-3100 / CS-3100-300V * 2 | CS-3200 | CS-3300 | |||
|---|---|---|---|---|---|---|
| Mode/polarity | Not equipped with HC mode | Pulse/ + – | ||||
| कमाल शिखर खंडtage | 40V | |||||
| कमाल शिखर वर्तमान | 400A | 40A | 1,000A | 400A | 40A | |
| कमाल शिखर शक्ती | 4kW | 400W | 10kW | 4kW | 400W | |
| नाडी रुंदी | Pulse width is variable at 50µs to 400µs (10µs resolution) | |||||
| मापन बिंदू | The measurement point can be specified (10µs resolution) | |||||
| Vertical axis range | 100mA～50A/div | 100mA～100A/div | ||||
| चाचणी फिक्स्चर | CS-301 | CS-302 | ||||
सामान्य तपशील
| Loop correction | हार्डवेअर | Correction ofthe floating capacitance between the collector supply and the ground | |
| सॉफ्टवेअर | Pseudo-looping through software optimisation | ||
| Step generator | ऑफसेट | सेटिंग श्रेणी | -10 ～ +10 x STEP AMPLITUDE Setting |
| ठराव | 1% of the STEP AMPLITUDE setting | ||
| सद्य मोड | श्रेणी | 50nA to 200mA per step, 21 steps, 1-2-5 switching | |
| कमाल वर्तमान | 2A | ||
| जास्तीत जास्त खंडtage | 10V किंवा अधिक | ||
| खंडtagई मोड | श्रेणी | 50mV to 2V per step, 6 steps, 1-2-5 switching | |
| कमाल वर्तमान | 500mA～(～8V), 200mA～(～15V), 10mA～(～40V) | ||
| जास्तीत जास्त खंडtage | ±40V | ||
| चरण दर | 2x 50Hz or 60Hz (1x in AC mode), pulse interval in HC mode | ||
| Pulse step | नाडी रुंदी | 50µs～400µs (10µs step) When in HC mode, the pulse width is 100µs wide before and after the pulse of the collector supply |
|
| पायऱ्यांची संख्या | 0～20 Step | ||
| औक्स आउटपुट | श्रेणी | OFF, -40V～+40V (Variable in 100mV steps) | |
| मापन मोड | REPEAT, STOP/SINGLE, SWEEP | ||
| उभ्या अक्ष (full scale 10div) |
जिल्हाधिकारी वर्तमान | श्रेणी | HV mode：1µA/div to 2A/div, 20 steps 1-2-5 switching (HC mode is not included) |
| अचूकता | 2% + 0.05 x VERT/div of readout To this, add the loop correction error for the following maximum peak voltages 0.5µA(30V), 1µA(300V), 6µA(3kV), 12µA(5kV) Specify at least 10% of the maximum peak voltage for 30V, 300V, and 3kV, and at least 30% for 5kV |
||
| उत्सर्जक वर्तमान (LEAKAGE) |
श्रेणी | 1nA/div～2mA/div, 20 step 1-2-5 switching (Collector supply mode is LEAKAGE) |
|
| अचूकता | 2% + 0.05 x VERT/div + 1nA or less of readout | ||
| क्षैतिज अक्ष (full scale 10div) |
कलेक्टर खंडtage |
श्रेणी | HC mode：50mV/div to 5V/div, 7 steps 1-2-5 switching (HV mode is not included) |
| अचूकता | 2% + 0.05 x HORIZ/div or less of readout | ||
| Base/ उत्सर्जक खंडtage |
श्रेणी | 50mV/div~5V/div, 7 step 1-2-5 switching | |
| अचूकता | 2% + 0.05 x HORIZ/div or less of readout | ||
| डिस्प्ले | डिस्प्ले | 8.4 इंच टीएफटी एलसीडी | |
| डेटा पॉइंट्सची संख्या | 1,000 points/trace (AC, full wave rectification) 20～1,000 points/trace (SWEEP mode) |
||
| Trace display | Point interpolation display, dot display | ||
| सरासरी | OFF, 2 to 255 times | ||
| चिकाटी | OFF, SHORT, LONG, Infinite length | ||
| Save internal waveform (REF) | 4 पॅनेल | ||
| कर्सर | DOT | Vert, Horiz, β or gm | |
| fLINE | Vert, Horiz, 1/grad, intercept | ||
| मोफत | Vert, Horiz, β or gm | ||
| विंडो | Vert, Horiz, β or gm in the WINDOW area | ||
| Data save/read | स्मृती | Setup：256 pcs, REF：4 screens | |
| बाह्य स्मृती | USB1.1：Setup, waveform, screen hardcopy (BMP, TIFF, PNG) | ||
| रिमोट | Equipped with a remote 10BASE-T/100BASE-TX 1 port via LAN connection | ||
| वीज पुरवठा | AC100～240V 50/60Hz, Maximum operating power：500VA (400W), Standby：50VA (7W) | ||
| External dimensions(mm) वजन |
CS-3100 / CS-3100-300V * 2 | Approx. 424W x 220H x 555D (excluding protrusions and accessories) approx. 28kg (excluding accessories) |
|
| CS-3200, 3300 | Approx. 424W x 354H x 555D (excluding protrusions and accessories) approx. 43kg (excluding accessories) |
||
CS-3100-300V is a made-to-order product.
मानक ॲक्सेसरीज
| CS-500 चाचणी ॲडॉप्टर | |
|---|---|
 |
This is a jig for connecting the part to be measured, provided by the customer, and the fixture. (Standard accessories) |
वारंवार विचारले जाणारे प्रश्न
Q: What should I do if the pulse width is too narrow?
A: If the pulse width is narrow, adjust the settings to widen it within the allowable range to generate the max. peak voltage.
Q: How to calibrate the collector supply output?
A: The collector supply output can be calibrated by enabling/disabling the output and adjusting the floating capacity as per the instructions provided.
कागदपत्रे / संसाधने
 |
Lambda CS-3000 Series Curve Tracer [pdf] सूचना पुस्तिका CS-3100, CS-3200, CS-3300, CS-3000 Series Curve Tracer, Curve Tracer, Tracer |