Lambda CS-3000 Series Curve Tracer
ຂໍ້ມູນຈໍາເພາະ
- Model: Curve Tracer CS-3000 series (CS-3100, CS-3200, CS-3300)
- Collector Supply (HV Mode): Max.Peak voltage – 3 kV, Max. Peak current – 15 A, Max. peak power – 390 W
- Collector Supply (HC Mode): Max.PPeakvoltage – 30 V, Max. peak current – 7.5 A, Pulse width – 50 us to 400 us
- Step Generator: Step rate – 1/10 Step, Pulse width range – 50 us to 400 us
- ການວັດແທກ: ຜູ້ເກັບ voltage range – HV: 50 mV/div to 500 V/div, HC: 50 mV/div to 5 V/div
ຄໍາແນະນໍາການນໍາໃຊ້ຜະລິດຕະພັນ
ການສະໜອງສະສົມ
For HV mode, set the max. Peak voltage and current according to the specifications. For HC mode, adjust the settings as needed.
ຂັ້ນຕອນການຜະລິດ
Set the step rate and pulse width within the specified ranges for accurate measurements.
ການວັດແທກ
ໃຊ້ຕົວເກັບລວບລວມທີ່ເຫມາະສົມtage range based on the mode of operation for precise readings.
Ideal for measuring the characteristics of various semiconductors such as IGBTs, MOSFETs, transistors, and diodes etc.
- ລະດັບສູງສຸດສູງສຸດtage 3,000V (high voltagໂໝດ e)
- Maximum peak current 1,000A (CS-3300 high current mode)
- All models equipped with LEAKAGE mode (1pA cursor resolution)
- USB port to save screen data and setup data
- Equipped with La LAN interface for remote control
Easy-to-understand measurement screen
CS-3000 Series Specifications
Collector supply HV mode
| ຕົວແບບ | CS-3100-300V * 2 | CS-3100 / CS-3200 / CS-3300 | |||
|---|---|---|---|---|---|
| ໂໝດ/ຂົ້ວ | Full wave rectification/ + – , DC/ + – , LEAKAGE/ + – , AC | ||||
| ລະດັບສູງສຸດສູງສຸດtage | 300V | 30V | 3kV | 300V | 30V |
| ກະແສໄຟຟ້າສູງສຸດ (maximum peak pulse current * 1 ) |
750mA (1.5A * 1 ) |
7.5A (15A * 1 ) |
75mA (150mA * 1 ) |
750mA (1.5A * 1 ) |
7.5A (15A * 1 ) |
| ພະລັງງານສູງສຸດ | 120mW / 1.2W / 120W / 390W (Cannot be set when using the maximum peak voltage of 3kV) | ||||
| Horizontal axis range | 50mV～500V/div | ||||
- The maximum instantaneous current value that can be generated (varies depending on the target to be measured and conditions), the measurement should be less than or equal to the maximum peak current value.
Collector supply HC mode
| ຕົວແບບ | CS-3100 / CS-3100-300V * 2 | CS-3200 | CS-3300 | |||
|---|---|---|---|---|---|---|
| ໂໝດ/ຂົ້ວ | Not equipped with HC mode | Pulse/ + – | ||||
| ລະດັບສູງສຸດສູງສຸດtage | 40V | |||||
| ກະແສໄຟຟ້າສູງສຸດ | 400A | 40A | 1,000A | 400A | 40A | |
| ພະລັງງານສູງສຸດ | 4kW | 400W | 10kW | 4kW | 400W | |
| ຄວາມກວ້າງຂອງກຳມະຈອນ | Pulse width is variable at 50µs to 400µs (10µs resolution) | |||||
| ຈຸດວັດແທກ | The measurement point can be specified (10µs resolution) | |||||
| Vertical axis range | 100mA～50A/div | 100mA～100A/div | ||||
| ການທົດສອບ fixture | CS-301 | CS-302 | ||||
ຂໍ້ມູນຈໍາເພາະທົ່ວໄປ
| Loop correction | ຮາດແວ | Correction ofthe floating capacitance between the collector supply and the ground | |
| ຊອບແວ | Pseudo-looping through software optimisation | ||
| ຂັ້ນຕອນການຜະລິດ | ຊົດເຊີຍ | ໄລຍະການຕັ້ງຄ່າ | -10 ～ +10 x STEP AMPLITUDE Setting |
| ຄວາມລະອຽດ | 1% of the STEP AMPLITUDE setting | ||
| ໂໝດ ປະຈຸບັນ | ຊ່ວງ | 50nA to 200mA per step, 21 steps, 1-2-5 switching | |
| ປະຈຸບັນສູງສຸດ | 2A | ||
| ສູງສຸດ voltage | 10V ຫຼືຫຼາຍກວ່ານັ້ນ | ||
| ສະບັບtagຮູບແບບ e | ຊ່ວງ | 50mV to 2V per step, 6 steps, 1-2-5 switching | |
| ປະຈຸບັນສູງສຸດ | 500mA～(～8V), 200mA～(～15V), 10mA～(～40V) | ||
| ສູງສຸດ voltage | ± 40V | ||
| ອັດຕາຂັ້ນຕອນ | 2x 50Hz or 60Hz (1x in AC mode), pulse interval in HC mode | ||
| ຂັ້ນຕອນກໍາມະຈອນ | ຄວາມກວ້າງຂອງກຳມະຈອນ | 50µs～400µs (10µs step) When in HC mode, the pulse width is 100µs wide before and after the pulse of the collector supply |
|
| ຈໍານວນຂັ້ນຕອນ | 0～20 Step | ||
| ຜົນຜະລິດ AUX | ຊ່ວງ | OFF, -40V～+40V (Variable in 100mV steps) | |
| ຮູບແບບການວັດແທກ | ເຮັດຊ້ຳ, ຢຸດ/ດຽວ, ປັດ | ||
| ແກນຕັ້ງ (full scale 10div) |
ປະຈຸບັນນັກສະສົມ | ຊ່ວງ | HV mode：1µA/div to 2A/div, 20 steps 1-2-5 switching (HC mode is not included) |
| ຄວາມຖືກຕ້ອງ | 2% + 0.05 x VERT/div of readout To this, add the loop correction error for the following maximum peak voltages 0.5µA(30V), 1µA(300V), 6µA(3kV), 12µA(5kV) Specify at least 10% of the maximum peak voltage for 30V, 300V, and 3kV, and at least 30% for 5kV |
||
| ຜູ້ສົ່ງສານ ປະຈຸບັນ (LEAKAGE) |
ຊ່ວງ | 1nA/div～2mA/div, 20 step 1-2-5 switching (Collector supply mode is LEAKAGE) |
|
| ຄວາມຖືກຕ້ອງ | 2% + 0.05 x VERT/div + 1nA or less of readout | ||
| ແກນລວງນອນ (full scale 10div) |
ນັກສະສົມ voltage |
ຊ່ວງ | HC mode：50mV/div to 5V/div, 7 steps 1-2-5 switching (HV mode is not included) |
| ຄວາມຖືກຕ້ອງ | 2% + 0.05 x HORIZ/div or less of readout | ||
| Base/ emitter voltage |
ຊ່ວງ | 50mV/div~5V/div, 7 step 1-2-5 switching | |
| ຄວາມຖືກຕ້ອງ | 2% + 0.05 x HORIZ/div or less of readout | ||
| ຈໍສະແດງຜົນ | ຈໍສະແດງຜົນ | ໜ້າ ຈໍ LCD ຂະ ໜາດ 8.4 ນີ້ວ | |
| ຈໍານວນຈຸດຂໍ້ມູນ | 1,000 points/trace (AC, full wave rectification) 20～1,000 points/trace (SWEEP mode) |
||
| Trace display | Point interpolation display, dot display | ||
| ສະເລ່ຍ | OFF, 2 to 255 times | ||
| ຄວາມຄົງທົນ | OFF, SHORT, LONG, Infinite length | ||
| Save internal waveform (REF) | 4 ກະດານ | ||
| ຕົວກະພິບ | DOT | Vert, Horiz, β or gm | |
| fLINE | Vert, Horiz, 1/grad, intercept | ||
| ຟຣີ | Vert, Horiz, β or gm | ||
| ປ່ອງຢ້ຽມ | Vert, Horiz, β or gm in the WINDOW area | ||
| Data save/read | ຄວາມຊົງຈໍາ | Setup：256 pcs, REF：4 screens | |
| ໜ່ວຍຄວາມຈຳພາຍນອກ | USB1.1：Setup, waveform, screen hardcopy (BMP, TIFF, PNG) | ||
| ໄລຍະໄກ | Equipped with a remote 10BASE-T/100BASE-TX 1 port via LAN connection | ||
| ການສະຫນອງພະລັງງານ | AC100～240V 50/60Hz, Maximum operating power：500VA (400W), Standby：50VA (7W) | ||
| External dimensions(mm) ນ້ຳໜັກ |
CS-3100 / CS-3100-300V * 2 | Approx. 424W x 220H x 555D (excluding protrusions and accessories) approx. 28kg (excluding accessories) |
|
| CS-3200, 3300 | Approx. 424W x 354H x 555D (excluding protrusions and accessories) approx. 43kg (excluding accessories) |
||
CS-3100-300V is a made-to-order product.
ອຸປະກອນເສີມມາດຕະຖານ
| CS-500 ທົດສອບອະແດບເຕີ | |
|---|---|
 |
This is a jig for connecting the part to be measured, provided by the customer, and the fixture. (Standard accessories) |
FAQs
ຖາມ: ຂ້ອຍຄວນເຮັດແນວໃດຖ້າຄວາມກວ້າງຂອງກໍາມະຈອນແຄບເກີນໄປ?
A: If the pulse width is narrow, adjust the settings to widen it within the allowable range to generate the max. peak voltage.
ຖາມ: ວິທີການປັບຜົນຜະລິດການສະຫນອງຂອງຜູ້ເກັບລວບລວມ?
A: The collector supply output can be calibrated by enabling/disabling the output and adjusting the floating capacity as per the instructions provided.
ເອກະສານ / ຊັບພະຍາກອນ
 |
Lambda CS-3000 Series Curve Tracer [pdf] ຄູ່ມືການສອນ CS-3100, CS-3200, CS-3300, CS-3000 Series Curve Tracer, Curve Tracer, Tracer |