ليمبڊا سي ايس-3000 سيريز ڪرو ٽريسر
وضاحتون
- Model: Curve Tracer CS-3000 series (CS-3100, CS-3200, CS-3300)
- Collector Supply (HV Mode): Max.Peak voltage – 3 kV, Max. Peak current – 15 A, Max. peak power – 390 W
- Collector Supply (HC Mode): Max.PPeakvoltage – 30 V, Max. peak current – 7.5 A, Pulse width – 50 us to 400 us
- Step Generator: Step rate – 1/10 Step, Pulse width range – 50 us to 400 us
- ماپ: ڪليڪٽر جلدtage range – HV: 50 mV/div to 500 V/div, HC: 50 mV/div to 5 V/div
پيداوار جي استعمال جون هدايتون
ڪليڪٽر سپلاءِ
For HV mode, set the max. Peak voltage and current according to the specifications. For HC mode, adjust the settings as needed.
قدم جنريٽر
Set the step rate and pulse width within the specified ranges for accurate measurements.
ماپ
مناسب ڪليڪٽر واليم استعمال ڪريوtage range based on the mode of operation for precise readings.
Ideal for measuring the characteristics of various semiconductors such as IGBTs, MOSFETs, transistors, and diodes etc.
- وڌ ۾ وڌ چوٽي حجمtage 3,000V (high voltagاي موڊ)
- Maximum peak current 1,000A (CS-3300 high current mode)
- All models equipped with LEAKAGE mode (1pA cursor resolution)
- USB port to save screen data and setup data
- Equipped with La LAN interface for remote control
Easy-to-understand measurement screen
CS-3000 Series Specifications
Collector supply HV mode
| ماڊل | CS-3100-300V * 2 | CS-3100 / CS-3200 / CS-3300 | |||
|---|---|---|---|---|---|
| موڊ/پولارٽي | Full wave rectification/ + – , DC/ + – , LEAKAGE/ + – , AC | ||||
| وڌ ۾ وڌ چوٽي حجمtage | 300V | 30V | 3kV | 300V | 30V |
| وڌ ۾ وڌ چوٽي موجوده (maximum peak pulse current * 1 ) |
750 ايم اي (1.5A * 1 ) |
7.5A (15A * 1 ) |
75 ايم اي (150mA * 1 ) |
750 ايم اي (1.5A * 1 ) |
7.5A (15A * 1 ) |
| وڌ ۾ وڌ طاقت | 120mW / 1.2W / 120W / 390W (Cannot be set when using the maximum peak voltage of 3kV) | ||||
| Horizontal axis range | 50mV～500V/div | ||||
- The maximum instantaneous current value that can be generated (varies depending on the target to be measured and conditions), the measurement should be less than or equal to the maximum peak current value.
Collector supply HC mode
| ماڊل | CS-3100 / CS-3100-300V * 2 | CS-3200 | CS-3300 | |||
|---|---|---|---|---|---|---|
| موڊ/پولارٽي | Not equipped with HC mode | Pulse/ + – | ||||
| وڌ ۾ وڌ چوٽي حجمtage | 40V | |||||
| وڌ ۾ وڌ چوٽي موجوده | 400A | 40A | 1,000A | 400A | 40A | |
| وڌ ۾ وڌ طاقت | 4 ڪلوواٽ | 400W | 10 ڪلوواٽ | 4 ڪلوواٽ | 400W | |
| نبض جي ويڪر | Pulse width is variable at 50µs to 400µs (10µs resolution) | |||||
| ماپ جو نقطو | The measurement point can be specified (10µs resolution) | |||||
| Vertical axis range | 100mA～50A/div | 100mA～100A/div | ||||
| ٽيسٽ فڪسچر | CS-301 | CS-302 | ||||
عام وضاحتون
| Loop correction | هارڊويئر | Correction ofthe floating capacitance between the collector supply and the ground | |
| سافٽ ويئر | Pseudo-looping through software optimisation | ||
| قدم جنريٽر | آفسيٽ | حد مقرر ڪرڻ | -10 ～ +10 x STEP AMPLITUDE Setting |
| قرارداد | 1% of the STEP AMPLITUDE setting | ||
| موجوده موڊ | حد | 50nA to 200mA per step, 21 steps, 1-2-5 switching | |
| وڌ ۾ وڌ موجوده | 2A | ||
| وimum ۾ و voltage | 10V يا وڌيڪ | ||
| جلدtagاي موڊ | حد | 50mV to 2V per step, 6 steps, 1-2-5 switching | |
| وڌ ۾ وڌ موجوده | 500mA～(～8V), 200mA～(～15V), 10mA～(～40V) | ||
| وimum ۾ و voltage | ±40V | ||
| قدم جي شرح | 2x 50Hz or 60Hz (1x in AC mode), pulse interval in HC mode | ||
| نبض جو قدم | نبض جي ويڪر | 50µs～400µs (10µs step) When in HC mode, the pulse width is 100µs wide before and after the pulse of the collector supply |
|
| قدمن جو تعداد | 0～20 Step | ||
| AUX پيداوار | حد | OFF, -40V～+40V (Variable in 100mV steps) | |
| ماپ جو طريقو | ورجايو، روڪيو/اڪيلو، صاف ڪريو | ||
| Vertical axis (full scale 10div) |
ڪليڪٽر ڪرنٽ | حد | HV mode：1µA/div to 2A/div, 20 steps 1-2-5 switching (HC mode is not included) |
| درستگي | 2% + 0.05 x VERT/div of readout To this, add the loop correction error for the following maximum peak voltages 0.5µA(30V), 1µA(300V), 6µA(3kV), 12µA(5kV) Specify at least 10% of the maximum peak voltage for 30V, 300V, and 3kV, and at least 30% for 5kV |
||
| ايميٽر موجوده (LEAKAGE) |
حد | 1nA/div～2mA/div, 20 step 1-2-5 switching (Collector supply mode is LEAKAGE) |
|
| درستگي | 2% + 0.05 x VERT/div + 1nA or less of readout | ||
| افقي محور (full scale 10div) |
ڪليڪٽر جلدtage |
حد | HC mode：50mV/div to 5V/div, 7 steps 1-2-5 switching (HV mode is not included) |
| درستگي | 2% + 0.05 x HORIZ/div or less of readout | ||
| Base/ خارج ڪندڙ جلدtage |
حد | 50mV/div~5V/div, 7 step 1-2-5 switching | |
| درستگي | 2% + 0.05 x HORIZ/div or less of readout | ||
| ڏيکاريو | ڏيکاريو | 8.4 انچ TFT LCD | |
| ڊيٽا پوائنٽن جو تعداد | 1,000 points/trace (AC, full wave rectification) 20～1,000 points/trace (SWEEP mode) |
||
| Trace display | Point interpolation display, dot display | ||
| سراسري | OFF, 2 to 255 times | ||
| استقامت | OFF, SHORT, LONG, Infinite length | ||
| Save internal waveform (REF) | 4-پينل | ||
| ڪسر | ڊي او ٽي | Vert, Horiz, β or gm | |
| fLINE | Vert, Horiz, 1/grad, intercept | ||
| واندو | Vert, Horiz, β or gm | ||
| ونڊو | Vert, Horiz, β or gm in the WINDOW area | ||
| Data save/read | ياداشت | Setup：256 pcs, REF：4 screens | |
| خارجي ياداشت | USB1.1：Setup, waveform, screen hardcopy (BMP, TIFF, PNG) | ||
| ريموٽ | Equipped with a remote 10BASE-T/100BASE-TX 1 port via LAN connection | ||
| بجلي جي فراهمي | AC100～240V 50/60Hz, Maximum operating power：500VA (400W), Standby：50VA (7W) | ||
| External dimensions(mm) وزن |
CS-3100 / CS-3100-300V * 2 | Approx. 424W x 220H x 555D (excluding protrusions and accessories) approx. 28kg (excluding accessories) |
|
| سي ايس-3200، 3300 | Approx. 424W x 354H x 555D (excluding protrusions and accessories) approx. 43kg (excluding accessories) |
||
CS-3100-300V is a made-to-order product.
معياري لوازمات
| CS-500 ٽيسٽ اڊاپٽر | |
|---|---|
 |
This is a jig for connecting the part to be measured, provided by the customer, and the fixture. (Standard accessories) |
FAQs
سوال: جيڪڏهن نبض جي ويڪر تمام گهڻي تنگ هجي ته مون کي ڇا ڪرڻ گهرجي؟
A: If the pulse width is narrow, adjust the settings to widen it within the allowable range to generate the max. peak voltage.
سوال: ڪليڪٽر سپلاءِ آئوٽ پُٽ کي ڪيئن ڪيليبريٽ ڪجي؟
A: The collector supply output can be calibrated by enabling/disabling the output and adjusting the floating capacity as per the instructions provided.
دستاويز / وسيلا
 |
ليمبڊا سي ايس-3000 سيريز ڪرو ٽريسر [pdf] هدايت نامو CS-3100، CS-3200، CS-3300، CS-3000 سيريز ڪرو ٽريسر، ڪرو ٽريسر، ٽريسر |