Lambda CS-3000 Series Curve Tracer
លក្ខណៈបច្ចេកទេស
- Model: Curve Tracer CS-3000 series (CS-3100, CS-3200, CS-3300)
- Collector Supply (HV Mode): Max.Peak voltage – 3 kV, Max. Peak current – 15 A, Max. peak power – 390 W
- Collector Supply (HC Mode): Max.PPeakvoltage – 30 V, Max. peak current – 7.5 A, Pulse width – 50 us to 400 us
- Step Generator: Step rate – 1/10 Step, Pulse width range – 50 us to 400 us
- ការវាស់វែង៖ អ្នកប្រមូលលេខtage range – HV: 50 mV/div to 500 V/div, HC: 50 mV/div to 5 V/div
ការណែនាំអំពីការប្រើប្រាស់ផលិតផល
ការផ្គត់ផ្គង់អ្នកប្រមូល
For HV mode, set the max. Peak voltage and current according to the specifications. For HC mode, adjust the settings as needed.
ម៉ាស៊ីនភ្លើងជំហាន
Set the step rate and pulse width within the specified ranges for accurate measurements.
ការវាស់វែង
ប្រើវ៉ុលប្រមូលដែលសមរម្យtage range based on the mode of operation for precise readings.
Ideal for measuring the characteristics of various semiconductors such as IGBTs, MOSFETs, transistors, and diodes etc.
- វ៉ុលកំពូលអតិបរមាtage 3,000V (high voltagរបៀបអ៊ី)
- Maximum peak current 1,000A (CS-3300 high current mode)
- All models equipped with LEAKAGE mode (1pA cursor resolution)
- USB port to save screen data and setup data
- Equipped with La LAN interface for remote control
Easy-to-understand measurement screen
CS-3000 Series Specifications
Collector supply HV mode
| គំរូ | CS-3100-300V * 2 | CS-3100 / CS-3200 / CS-3300 | |||
|---|---|---|---|---|---|
| របៀប/ប៉ូល | Full wave rectification/ + – , DC/ + – , LEAKAGE/ + – , AC | ||||
| វ៉ុលកំពូលអតិបរមាtage | 300V | 30V | 3kV | 300V | 30V |
| ចរន្តអតិបរមា (maximum peak pulse current * 1 ) |
750 mA (1.5A * 1 ) |
7.5A (15A * 1 ) |
75 mA (150mA * 1 ) |
750 mA (1.5A * 1 ) |
7.5A (15A * 1 ) |
| ថាមពលអតិបរមា | 120mW / 1.2W / 120W / 390W (Cannot be set when using the maximum peak voltage of 3kV) | ||||
| Horizontal axis range | 50mV～500V/div | ||||
- The maximum instantaneous current value that can be generated (varies depending on the target to be measured and conditions), the measurement should be less than or equal to the maximum peak current value.
Collector supply HC mode
| គំរូ | CS-3100 / CS-3100-300V * 2 | CS-3200 | CS-3300 | |||
|---|---|---|---|---|---|---|
| របៀប/ប៉ូល | Not equipped with HC mode | Pulse/ + – | ||||
| វ៉ុលកំពូលអតិបរមាtage | 40V | |||||
| ចរន្តអតិបរមា | 400A | 40A | 1,000A | 400A | 40A | |
| ថាមពលអតិបរមា | 4 kW | 400 វ៉ | 10 kW | 4 kW | 400 វ៉ | |
| ទទឹងជីពចរ | Pulse width is variable at 50µs to 400µs (10µs resolution) | |||||
| ចំណុចវាស់វែង | The measurement point can be specified (10µs resolution) | |||||
| Vertical axis range | 100mA～50A/div | 100mA～100A/div | ||||
| ឧបករណ៍សាកល្បង | CS-301 | CS-302 | ||||
លក្ខណៈបច្ចេកទេសទូទៅ
| Loop correction | ផ្នែករឹង | Correction ofthe floating capacitance between the collector supply and the ground | |
| កម្មវិធី | Pseudo-looping through software optimisation | ||
| ម៉ាស៊ីនភ្លើងជំហាន | អុហ្វសិត | ជួរកំណត់ | -10 ～ +10 x STEP AMPLITUDE Setting |
| ដំណោះស្រាយ | 1% of the STEP AMPLITUDE setting | ||
| របៀបបច្ចុប្បន្ន | ជួរ | 50nA to 200mA per step, 21 steps, 1-2-5 switching | |
| ចរន្តអតិបរមា | 2A | ||
| វ៉ុលអតិបរមាtage | 10V ឬច្រើនជាងនេះ។ | ||
| វ៉ុលtagរបៀបអ៊ី | ជួរ | 50mV to 2V per step, 6 steps, 1-2-5 switching | |
| ចរន្តអតិបរមា | 500mA～(～8V), 200mA～(～15V), 10mA～(～40V) | ||
| វ៉ុលអតិបរមាtage | ± 40V | ||
| អត្រាជំហាន | 2x 50Hz or 60Hz (1x in AC mode), pulse interval in HC mode | ||
| ជំហានជីពចរ | ទទឹងជីពចរ | 50µs～400µs (10µs step) When in HC mode, the pulse width is 100µs wide before and after the pulse of the collector supply |
|
| ចំនួនជំហាន | ជំហាន ០ ដល់ ៩៩៩៩៩៩៩ | ||
| លទ្ធផល AUX | ជួរ | OFF, -40V～+40V (Variable in 100mV steps) | |
| របៀបវាស់វែង | ធ្វើម្តងទៀត បញ្ឈប់/នៅលីវ អូស | ||
| អ័ក្សបញ្ឈរ (full scale 10div) |
អ្នកប្រមូលបច្ចុប្បន្ន | ជួរ | HV mode：1µA/div to 2A/div, 20 steps 1-2-5 switching (HC mode is not included) |
| ភាពត្រឹមត្រូវ | 2% + 0.05 x VERT/div of readout To this, add the loop correction error for the following maximum peak voltages 0.5µA(30V), 1µA(300V), 6µA(3kV), 12µA(5kV) Specify at least 10% of the maximum peak voltage for 30V, 300V, and 3kV, and at least 30% for 5kV |
||
| អ្នកបញ្ចេញ បច្ចុប្បន្ន (LEAKAGE) |
ជួរ | 1nA/div～2mA/div, 20 step 1-2-5 switching (Collector supply mode is LEAKAGE) |
|
| ភាពត្រឹមត្រូវ | 2% + 0.05 x VERT/div + 1nA or less of readout | ||
| អ័ក្សផ្តេក (full scale 10div) |
អ្នកប្រមូល វ៉ុលtage |
ជួរ | HC mode：50mV/div to 5V/div, 7 steps 1-2-5 switching (HV mode is not included) |
| ភាពត្រឹមត្រូវ | 2% + 0.05 x HORIZ/div or less of readout | ||
| Base/ អ្នកបញ្ចេញ វ៉ុលtage |
ជួរ | 50mV/div~5V/div, 7 step 1-2-5 switching | |
| ភាពត្រឹមត្រូវ | 2% + 0.05 x HORIZ/div or less of readout | ||
| បង្ហាញ | បង្ហាញ | អេក្រង់ LCD TFT 8.4 អ៊ីញ | |
| ចំនួនចំណុចទិន្នន័យ | 1,000 points/trace (AC, full wave rectification) 20～1,000 points/trace (SWEEP mode) |
||
| Trace display | Point interpolation display, dot display | ||
| មធ្យម | OFF, 2 to 255 times | ||
| ការតស៊ូ | OFF, SHORT, LONG, Infinite length | ||
| Save internal waveform (REF) | 4 បន្ទះ | ||
| ទស្សន៍ទ្រនិច | DOT | Vert, Horiz, β or gm | |
| fLINE | Vert, Horiz, 1/grad, intercept | ||
| ឥតគិតថ្លៃ | Vert, Horiz, β or gm | ||
| បង្អួច | Vert, Horiz, β or gm in the WINDOW area | ||
| Data save/read | ការចងចាំ | Setup：256 pcs, REF：4 screens | |
| អង្គចងចាំខាងក្រៅ | USB1.1：Setup, waveform, screen hardcopy (BMP, TIFF, PNG) | ||
| ពីចម្ងាយ | Equipped with a remote 10BASE-T/100BASE-TX 1 port via LAN connection | ||
| ការផ្គត់ផ្គង់ថាមពល | AC100～240V 50/60Hz, Maximum operating power：500VA (400W), Standby：50VA (7W) | ||
| External dimensions(mm) ទម្ងន់ |
CS-3100 / CS-3100-300V * 2 | Approx. 424W x 220H x 555D (excluding protrusions and accessories) approx. 28kg (excluding accessories) |
|
| CS-3200, ៩ | Approx. 424W x 354H x 555D (excluding protrusions and accessories) approx. 43kg (excluding accessories) |
||
CS-3100-300V is a made-to-order product.
គ្រឿងបន្លាស់ស្តង់ដារ
| CS-500 អាដាប់ទ័រសាកល្បង | |
|---|---|
 |
This is a jig for connecting the part to be measured, provided by the customer, and the fixture. (Standard accessories) |
សំណួរគេសួរញឹកញាប់
សំណួរ: តើខ្ញុំគួរធ្វើដូចម្តេចប្រសិនបើទទឹងជីពចរតូចចង្អៀត?
A: If the pulse width is narrow, adjust the settings to widen it within the allowable range to generate the max. peak voltage.
សំណួរ: តើធ្វើដូចម្តេចដើម្បីក្រិតតាមខ្នាតទិន្នផលផ្គត់ផ្គង់អ្នកប្រមូល?
A: The collector supply output can be calibrated by enabling/disabling the output and adjusting the floating capacity as per the instructions provided.
ឯកសារ/ធនធាន
 |
Lambda CS-3000 Series Curve Tracer [pdf] សៀវភៅណែនាំ CS-3100, CS-3200, CS-3300, CS-3000 Series Curve Tracer, Curve Tracer, Tracer |