Traċċatur tal-Kurva tas-Serje Lambda CS-3000
Speċifikazzjonijiet
- Model: Curve Tracer CS-3000 series (CS-3100, CS-3200, CS-3300)
- Collector Supply (HV Mode): Max.Peak voltage – 3 kV, Max. Peak current – 15 A, Max. peak power – 390 W
- Collector Supply (HC Mode): Max.PPeakvoltage – 30 V, Max. peak current – 7.5 A, Pulse width – 50 us to 400 us
- Step Generator: Step rate – 1/10 Step, Pulse width range – 50 us to 400 us
- Kejl: Volum tal-kolletturtage range – HV: 50 mV/div to 500 V/div, HC: 50 mV/div to 5 V/div
Istruzzjonijiet għall-Użu tal-Prodott
Provvista tal-Kollettur
For HV mode, set the max. Peak voltage and current according to the specifications. For HC mode, adjust the settings as needed.
Pass Ġeneratur
Set the step rate and pulse width within the specified ranges for accurate measurements.
Kejl
Uża l-volum xieraq tal-kolletturtage range based on the mode of operation for precise readings.
Ideal for measuring the characteristics of various semiconductors such as IGBTs, MOSFETs, transistors, and diodes etc.
- Vol massimu massimutage 3,000V (high voltagmodalità e)
- Maximum peak current 1,000A (CS-3300 high current mode)
- All models equipped with LEAKAGE mode (1pA cursor resolution)
- USB port to save screen data and setup data
- Equipped with La LAN interface for remote control
Easy-to-understand measurement screen
CS-3000 Series Specifications
Collector supply HV mode
Mudell | CS-3100-300V * 2 | CS-3100 / CS-3200 / CS-3300 | |||
---|---|---|---|---|---|
Modalità/polarità | Full wave rectification/ + – , DC/ + – , LEAKAGE/ + – , AC | ||||
Vol massimu massimutage | 300V | 30V | 3kV | 300V | 30V |
Kurrent massimu massimu (maximum peak pulse current * 1 ) |
750mA (1.5A * 1 ) |
7.5A (15A * 1 ) |
75mA (150mA * 1 ) |
750mA (1.5A * 1 ) |
7.5A (15A * 1 ) |
L-ogħla qawwa massima | 120mW / 1.2W / 120W / 390W (Cannot be set when using the maximum peak voltage of 3kV) | ||||
Horizontal axis range | 50mV~500V/div |
- The maximum instantaneous current value that can be generated (varies depending on the target to be measured and conditions), the measurement should be less than or equal to the maximum peak current value.
Collector supply HC mode
Mudell | CS-3100 / CS-3100-300V * 2 | CS-3200 | CS-3300 | |||
---|---|---|---|---|---|---|
Modalità/polarità | Not equipped with HC mode | Pulse/ + – | ||||
Vol massimu massimutage | 40V | |||||
Kurrent massimu massimu | 400A | 40A | 1,000A | 400A | 40A | |
L-ogħla qawwa massima | 4kW | 400W | 10kW | 4kW | 400W | |
Wisa 'tal-polz | Pulse width is variable at 50µs to 400µs (10µs resolution) | |||||
Punt tal-kejl | The measurement point can be specified (10µs resolution) | |||||
Vertical axis range | 100mA~50A/div | 100mA~100A/div | ||||
Apparat tat-test | CS-301 | CS-302 |
Speċifikazzjonijiet Komuni
Loop correction | Ħardwer | Correction ofthe floating capacitance between the collector supply and the ground | |
Software | Pseudo-looping through software optimisation | ||
Ġeneratur tal-passi | Offset | Firxa tal-issettjar | -10 ~ +10 x STEP AMPLITUDE Setting |
Riżoluzzjoni | 1% of the STEP AMPLITUDE setting | ||
Modalità kurrenti | Firxa | 50nA to 200mA per step, 21 steps, 1-2-5 switching | |
Kurrent massimu | 2A | ||
Vol massimutage | 10V jew aktar | ||
Voltagmodalità e | Firxa | 50mV to 2V per step, 6 steps, 1-2-5 switching | |
Kurrent massimu | 500mA~(~8V), 200mA~(~15V), 10mA~(~40V) | ||
Vol massimutage | ± 40V | ||
Rata tal-pass | 2x 50Hz or 60Hz (1x in AC mode), pulse interval in HC mode | ||
Pass tal-polz | Wisa 'tal-polz | 50µs~400µs (10µs step) When in HC mode, the pulse width is 100µs wide before and after the pulse of the collector supply |
|
Numru ta' passi | 0~20 Step | ||
Ħruġ AUX | Firxa | OFF, -40V~+40V (Variable in 100mV steps) | |
Mod tal-kejl | IRREPETI, WAQQAF/SINGOLA, KNIS | ||
Assi vertikali (full scale 10div) |
Kurrent tal-kollettur | Firxa | HV mode:1µA/div to 2A/div, 20 steps 1-2-5 switching (HC mode is not included) |
Eżattezza | 2% + 0.05 x VERT/div of readout To this, add the loop correction error for the following maximum peak voltages 0.5µA(30V), 1µA(300V), 6µA(3kV), 12µA(5kV) Specify at least 10% of the maximum peak voltage for 30V, 300V, and 3kV, and at least 30% for 5kV |
||
Emettitur kurrenti (LEAKAGE) |
Firxa | 1nA/div~2mA/div, 20 step 1-2-5 switching (Collector supply mode is LEAKAGE) |
|
Eżattezza | 2% + 0.05 x VERT/div + 1nA or less of readout | ||
Assi orizzontali (full scale 10div) |
Kollettur voltage |
Firxa | HC mode:50mV/div to 5V/div, 7 steps 1-2-5 switching (HV mode is not included) |
Eżattezza | 2% + 0.05 x HORIZ/div or less of readout | ||
Base/ emitter voltage |
Firxa | 50mV/div~5V/div, 7 step 1-2-5 switching | |
Eżattezza | 2% + 0.05 x HORIZ/div or less of readout | ||
Wiri | Wiri | TFT LCD ta '8.4 pulzieri | |
Numru ta' punti tad-dejta | 1,000 points/trace (AC, full wave rectification) 20~1,000 points/trace (SWEEP mode) |
||
Trace display | Point interpolation display, dot display | ||
Il-medja | OFF, 2 to 255 times | ||
Persistenza | OFF, SHORT, LONG, Infinite length | ||
Save internal waveform (REF) | 4-Panew | ||
Cursor | DOT | Vert, Horiz, β or gm | |
fLINE | Vert, Horiz, 1/grad, intercept | ||
B'XEJN | Vert, Horiz, β or gm | ||
TIEQA | Vert, Horiz, β or gm in the WINDOW area | ||
Data save/read | Memorja | Setup:256 pcs, REF:4 screens | |
Memorja esterna | USB1.1:Setup, waveform, screen hardcopy (BMP, TIFF, PNG) | ||
Remote | Equipped with a remote 10BASE-T/100BASE-TX 1 port via LAN connection | ||
Provvista ta' enerġija | AC100~240V 50/60Hz, Maximum operating power:500VA (400W), Standby:50VA (7W) | ||
External dimensions(mm) Piż |
CS-3100 / CS-3100-300V * 2 | Approx. 424W x 220H x 555D (excluding protrusions and accessories) approx. 28kg (excluding accessories) |
|
CS-3200, 3300 | Approx. 424W x 354H x 555D (excluding protrusions and accessories) approx. 43kg (excluding accessories) |
CS-3100-300V is a made-to-order product.
Aċċessorji Standard
CS-500 Adapter tat-test | |
---|---|
![]() |
This is a jig for connecting the part to be measured, provided by the customer, and the fixture. (Standard accessories) |
FAQs
M: X'għandi nagħmel jekk il-wisa' tal-polz tkun dejqa wisq?
A: If the pulse width is narrow, adjust the settings to widen it within the allowable range to generate the max. peak voltage.
M: Kif tikkalibra l-output tal-provvista tal-kollettur?
A: The collector supply output can be calibrated by enabling/disabling the output and adjusting the floating capacity as per the instructions provided.
Dokumenti / Riżorsi
![]() |
Traċċatur tal-Kurva tas-Serje Lambda CS-3000 [pdfManwal tal-Istruzzjonijiet Traċċatur tal-Kurva tas-Serje CS-3100, CS-3200, CS-3300, CS-3000, Traċċatur tal-Kurva, Traċċatur |