Trasè Koub Lambda CS-3000 Seri
Espesifikasyon
- Model: Curve Tracer CS-3000 series (CS-3100, CS-3200, CS-3300)
- Collector Supply (HV Mode): Max.Peak voltage – 3 kV, Max. Peak current – 15 A, Max. peak power – 390 W
- Collector Supply (HC Mode): Max.PPeakvoltage – 30 V, Max. peak current – 7.5 A, Pulse width – 50 us to 400 us
- Step Generator: Step rate – 1/10 Step, Pulse width range – 50 us to 400 us
- Mezi: Volim kolektètage range – HV: 50 mV/div to 500 V/div, HC: 50 mV/div to 5 V/div
Enstriksyon Itilizasyon Pwodwi
Pwovizyon pou Kolektè
For HV mode, set the max. Peak voltage and current according to the specifications. For HC mode, adjust the settings as needed.
Etap dèlko
Set the step rate and pulse width within the specified ranges for accurate measurements.
Mezi
Sèvi ak volim kolektè ki apwopriye atage range based on the mode of operation for precise readings.
Ideal for measuring the characteristics of various semiconductors such as IGBTs, MOSFETs, transistors, and diodes etc.
- Vol pik maksimòmtage 3,000V (high voltage mòd)
- Maximum peak current 1,000A (CS-3300 high current mode)
- All models equipped with LEAKAGE mode (1pA cursor resolution)
- USB port to save screen data and setup data
- Equipped with La LAN interface for remote control
Easy-to-understand measurement screen
CS-3000 Series Specifications
Collector supply HV mode
| Modèl | CS-3100-300V * 2 | CS-3100 / CS-3200 / CS-3300 | |||
|---|---|---|---|---|---|
| Mòd/polarite | Full wave rectification/ + – , DC/ + – , LEAKAGE/ + – , AC | ||||
| Vol pik maksimòmtage | 300V | 30V | 3kV | 300V | 30V |
| Maksimòm pik aktyèl (maximum peak pulse current * 1 ) |
750mA (1.5A * 1 ) |
7.5A (15A * 1 ) |
75mA (150mA * 1 ) |
750mA (1.5A * 1 ) |
7.5A (15A * 1 ) |
| Maksimòm pik pouvwa | 120mW / 1.2W / 120W / 390W (Cannot be set when using the maximum peak voltage of 3kV) | ||||
| Horizontal axis range | 50mV～500V/div | ||||
- The maximum instantaneous current value that can be generated (varies depending on the target to be measured and conditions), the measurement should be less than or equal to the maximum peak current value.
Collector supply HC mode
| Modèl | CS-3100 / CS-3100-300V * 2 | CS-3200 | CS-3300 | |||
|---|---|---|---|---|---|---|
| Mòd/polarite | Not equipped with HC mode | Pulse/ + – | ||||
| Vol pik maksimòmtage | 40V | |||||
| Maksimòm pik aktyèl | 400A | 40A | 1,000A | 400A | 40A | |
| Maksimòm pik pouvwa | 4kW | 400W | 10kW | 4kW | 400W | |
| Lajè batman kè | Pulse width is variable at 50µs to 400µs (10µs resolution) | |||||
| Pwen mezi | The measurement point can be specified (10µs resolution) | |||||
| Vertical axis range | 100mA～50A/div | 100mA～100A/div | ||||
| Aparèy tès la | CS-301 | CS-302 | ||||
Espesifikasyon komen
| Loop correction | Materyèl | Correction ofthe floating capacitance between the collector supply and the ground | |
| Lojisyèl | Pseudo-looping through software optimisation | ||
| Jeneratè etap | Desantre | Anviwònman ranje | -10 ～ +10 x STEP AMPLITUDE Setting |
| Rezolisyon | 1% of the STEP AMPLITUDE setting | ||
| Kouran mòd | Range | 50nA to 200mA per step, 21 steps, 1-2-5 switching | |
| Maksimòm aktyèl | 2A | ||
| Vol maksimòmtage | 10V oswa plis | ||
| Voltage mòd | Range | 50mV to 2V per step, 6 steps, 1-2-5 switching | |
| Maksimòm aktyèl | 500mA～(～8V), 200mA～(～15V), 10mA～(～40V) | ||
| Vol maksimòmtage | ± 40V | ||
| Etap pousantaj | 2x 50Hz or 60Hz (1x in AC mode), pulse interval in HC mode | ||
| Etap pulsasyon | Lajè batman kè | 50µs～400µs (10µs step) When in HC mode, the pulse width is 100µs wide before and after the pulse of the collector supply |
|
| Kantite etap | 0～20 Step | ||
| AUX pwodiksyon | Range | OFF, -40V～+40V (Variable in 100mV steps) | |
| Mòd mezi | REPETE, ARÈ/SINGLE, BALAY | ||
| Aks vètikal (full scale 10div) |
Pèseptè aktyèl | Range | HV mode：1µA/div to 2A/div, 20 steps 1-2-5 switching (HC mode is not included) |
| Presizyon | 2% + 0.05 x VERT/div of readout To this, add the loop correction error for the following maximum peak voltages 0.5µA(30V), 1µA(300V), 6µA(3kV), 12µA(5kV) Specify at least 10% of the maximum peak voltage for 30V, 300V, and 3kV, and at least 30% for 5kV |
||
| Emetè aktyèl (LEAKAGE) |
Range | 1nA/div～2mA/div, 20 step 1-2-5 switching (Collector supply mode is LEAKAGE) |
|
| Presizyon | 2% + 0.05 x VERT/div + 1nA or less of readout | ||
| Aks orizontal (full scale 10div) |
Pèseptè voltage |
Range | HC mode：50mV/div to 5V/div, 7 steps 1-2-5 switching (HV mode is not included) |
| Presizyon | 2% + 0.05 x HORIZ/div or less of readout | ||
| Base/ emeteur voltage |
Range | 50mV/div~5V/div, 7 step 1-2-5 switching | |
| Presizyon | 2% + 0.05 x HORIZ/div or less of readout | ||
| Ekspozisyon | Ekspozisyon | 8.4-pous TFT LCD | |
| Kantite pwen done yo | 1,000 points/trace (AC, full wave rectification) 20～1,000 points/trace (SWEEP mode) |
||
| Trace display | Point interpolation display, dot display | ||
| Mwayèn | OFF, 2 to 255 times | ||
| Pèsistans | OFF, SHORT, LONG, Infinite length | ||
| Save internal waveform (REF) | 4 panèl | ||
| Kurseur | DOT | Vert, Horiz, β or gm | |
| fLINE | Vert, Horiz, 1/grad, intercept | ||
| GRATIS | Vert, Horiz, β or gm | ||
| FENÈT | Vert, Horiz, β or gm in the WINDOW area | ||
| Data save/read | memwa | Setup：256 pcs, REF：4 screens | |
| memwa ekstèn | USB1.1：Setup, waveform, screen hardcopy (BMP, TIFF, PNG) | ||
| Remote | Equipped with a remote 10BASE-T/100BASE-TX 1 port via LAN connection | ||
| Ekipman pou pouvwa | AC100～240V 50/60Hz, Maximum operating power：500VA (400W), Standby：50VA (7W) | ||
| External dimensions(mm) Pwa |
CS-3100 / CS-3100-300V * 2 | Approx. 424W x 220H x 555D (excluding protrusions and accessories) approx. 28kg (excluding accessories) |
|
| CS-3200, 3300 | Approx. 424W x 354H x 555D (excluding protrusions and accessories) approx. 43kg (excluding accessories) |
||
CS-3100-300V is a made-to-order product.
Pwodwi pou Telefòn Creole
| CS-500 Adaptè tès la | |
|---|---|
 |
This is a jig for connecting the part to be measured, provided by the customer, and the fixture. (Standard accessories) |
FAQ
K: Kisa mwen ta dwe fè si lajè pulsasyon an twò etwat?
A: If the pulse width is narrow, adjust the settings to widen it within the allowable range to generate the max. peak voltage.
K: Kijan pou kalibre pwodiksyon ekipman pou kolektè a?
A: The collector supply output can be calibrated by enabling/disabling the output and adjusting the floating capacity as per the instructions provided.
Dokiman / Resous
 |
Trasè Koub Lambda CS-3000 Seri [pdfManyèl Enstriksyon CS-3100, CS-3200, CS-3300, Trasè Koub Seri CS-3000, Trasè Koub, Trasè |