Lambda CS-3000 시리즈 커브 트레이서
명세서
- Model: Curve Tracer CS-3000 series (CS-3100, CS-3200, CS-3300)
- Collector Supply (HV Mode): Max.Peak voltage – 3 kV, Max. Peak current – 15 A, Max. peak power – 390 W
- Collector Supply (HC Mode): Max.PPeakvoltage – 30 V, Max. peak current – 7.5 A, Pulse width – 50 us to 400 us
- Step Generator: Step rate – 1/10 Step, Pulse width range – 50 us to 400 us
- 측정: 수집기 볼륨tage range – HV: 50 mV/div to 500 V/div, HC: 50 mV/div to 5 V/div
제품 사용 지침
수집가 공급
For HV mode, set the max. Peak voltage and current according to the specifications. For HC mode, adjust the settings as needed.
스텝 생성기
Set the step rate and pulse width within the specified ranges for accurate measurements.
측정
적절한 수집기 볼륨을 사용하세요tage range based on the mode of operation for precise readings.
Ideal for measuring the characteristics of various semiconductors such as IGBTs, MOSFETs, transistors, and diodes etc.
- 최대 피크 볼륨tage 3,000V (high voltage 모드)
- Maximum peak current 1,000A (CS-3300 high current mode)
- All models equipped with LEAKAGE mode (1pA cursor resolution)
- USB port to save screen data and setup data
- Equipped with La LAN interface for remote control
Easy-to-understand measurement screen
CS-3000 Series Specifications
Collector supply HV mode
| 모델 | CS-3100-300V * 2 | CS-3100 / CS-3200 / CS-3300 | |||
|---|---|---|---|---|---|
| 모드/극성 | Full wave rectification/ + – , DC/ + – , LEAKAGE/ + – , AC | ||||
| 최대 피크 볼륨tage | 300V | 30V | 3kV | 300V | 30V |
| 최대 피크 전류 (maximum peak pulse current * 1 ) |
750mA (1.5A * 1 ) |
7.5A (15A * 1 ) |
75mA (150mA * 1 ) |
750mA (1.5A * 1 ) |
7.5A (15A * 1 ) |
| 최대 피크 전력 | 120mW / 1.2W / 120W / 390W (Cannot be set when using the maximum peak voltage of 3kV) | ||||
| Horizontal axis range | 50mV～500V/div | ||||
- The maximum instantaneous current value that can be generated (varies depending on the target to be measured and conditions), the measurement should be less than or equal to the maximum peak current value.
Collector supply HC mode
| 모델 | CS-3100 / CS-3100-300V * 2 | CS-3200 | CS-3300 | |||
|---|---|---|---|---|---|---|
| 모드/극성 | Not equipped with HC mode | Pulse/ + – | ||||
| 최대 피크 볼륨tage | 40V | |||||
| 최대 피크 전류 | 400A | 40A | 1,000A | 400A | 40A | |
| 최대 피크 전력 | 4kW | 400와트 | 10kW | 4kW | 400와트 | |
| 펄스 폭 | Pulse width is variable at 50µs to 400µs (10µs resolution) | |||||
| 측정점 | The measurement point can be specified (10µs resolution) | |||||
| Vertical axis range | 100mA～50A/div | 100mA～100A/div | ||||
| 테스트 픽스처 | CS-301 | CS-302 | ||||
공통 사양
| Loop correction | 하드웨어 | Correction ofthe floating capacitance between the collector supply and the ground | |
| 소프트웨어 | Pseudo-looping through software optimisation | ||
| 스텝 생성기 | 오프셋 | 설정 범위 | -10 ～ +10 x STEP AMPLITUDE Setting |
| 해결 | 1% of the STEP AMPLITUDE setting | ||
| 현재 모드 | 범위 | 50nA to 200mA per step, 21 steps, 1-2-5 switching | |
| 최대 전류 | 2A | ||
| 최대 볼륨tage | 10V 이상 | ||
| 권tag전자 모드 | 범위 | 50mV to 2V per step, 6 steps, 1-2-5 switching | |
| 최대 전류 | 500mA～(～8V), 200mA～(～15V), 10mA～(～40V) | ||
| 최대 볼륨tage | ±40V | ||
| 스텝 속도 | 2x 50Hz or 60Hz (1x in AC mode), pulse interval in HC mode | ||
| 펄스 스텝 | 펄스 폭 | 50µs～400µs (10µs step) When in HC mode, the pulse width is 100µs wide before and after the pulse of the collector supply |
|
| 걸음 수 | 0～20 Step | ||
| AUX 출력 | 범위 | OFF, -40V～+40V (Variable in 100mV steps) | |
| 측정 모드 | 반복, 정지/단일, 스윕 | ||
| 수직축 (full scale 10div) |
수집기 전류 | 범위 | HV mode：1µA/div to 2A/div, 20 steps 1-2-5 switching (HC mode is not included) |
| 정확성 | 2% + 0.05 x VERT/div of readout To this, add the loop correction error for the following maximum peak voltages 0.5µA(30V), 1µA(300V), 6µA(3kV), 12µA(5kV) Specify at least 10% of the maximum peak voltage for 30V, 300V, and 3kV, and at least 30% for 5kV |
||
| 방출기 현재의 (LEAKAGE) |
범위 | 1nA/div～2mA/div, 20 step 1-2-5 switching (Collector supply mode is LEAKAGE) |
|
| 정확성 | 2% + 0.05 x VERT/div + 1nA or less of readout | ||
| 수평축 (full scale 10div) |
수집기 권tage |
범위 | HC mode：50mV/div to 5V/div, 7 steps 1-2-5 switching (HV mode is not included) |
| 정확성 | 2% + 0.05 x HORIZ/div or less of readout | ||
| Base/ 방출기 권tage |
범위 | 50mV/div~5V/div, 7 step 1-2-5 switching | |
| 정확성 | 2% + 0.05 x HORIZ/div or less of readout | ||
| 표시하다 | 표시하다 | 8.4 인치 TFT LCD | |
| 데이터 포인트 수 | 1,000 points/trace (AC, full wave rectification) 20～1,000 points/trace (SWEEP mode) |
||
| Trace display | Point interpolation display, dot display | ||
| 평균화 | OFF, 2 to 255 times | ||
| 고집 | OFF, SHORT, LONG, Infinite length | ||
| Save internal waveform (REF) | 4- 패널 | ||
| 커서 | 점 | Vert, Horiz, β or gm | |
| f라인 | Vert, Horiz, 1/grad, intercept | ||
| 무료 | Vert, Horiz, β or gm | ||
| 창문 | Vert, Horiz, β or gm in the WINDOW area | ||
| Data save/read | 메모리 | Setup：256 pcs, REF：4 screens | |
| 외부 메모리 | USB1.1：Setup, waveform, screen hardcopy (BMP, TIFF, PNG) | ||
| 원격 | Equipped with a remote 10BASE-T/100BASE-TX 1 port via LAN connection | ||
| 전원 공급 | AC100～240V 50/60Hz, Maximum operating power：500VA (400W), Standby：50VA (7W) | ||
| External dimensions(mm) 무게 |
CS-3100 / CS-3100-300V * 2 | Approx. 424W x 220H x 555D (excluding protrusions and accessories) approx. 28kg (excluding accessories) |
|
| CS-3200, 3300 | Approx. 424W x 354H x 555D (excluding protrusions and accessories) approx. 43kg (excluding accessories) |
||
CS-3100-300V is a made-to-order product.
표준 액세서리
| CS-500 테스트 어댑터 | |
|---|---|
 |
This is a jig for connecting the part to be measured, provided by the customer, and the fixture. (Standard accessories) |
자주 묻는 질문
Q: 펄스 폭이 너무 좁은 경우 어떻게 해야 하나요?
A: If the pulse width is narrow, adjust the settings to widen it within the allowable range to generate the max. peak voltage.
질문: 수집기 공급 출력을 보정하는 방법은 무엇입니까?
A: The collector supply output can be calibrated by enabling/disabling the output and adjusting the floating capacity as per the instructions provided.
문서 / 리소스
 |
Lambda CS-3000 시리즈 커브 트레이서 [PDF 파일] 사용설명서 CS-3100, CS-3200, CS-3300, CS-3000 시리즈 커브 트레이서, 커브 트레이서, 트레이서 |