Lambda CS-3000 Series Curve Tracer
Mga detalye
- Model: Curve Tracer CS-3000 series (CS-3100, CS-3200, CS-3300)
- Collector Supply (HV Mode): Max.Peak voltage – 3 kV, Max. Peak current – 15 A, Max. peak power – 390 W
- Collector Supply (HC Mode): Max.PPeakvoltage – 30 V, Max. peak current – 7.5 A, Pulse width – 50 us to 400 us
- Step Generator: Step rate – 1/10 Step, Pulse width range – 50 us to 400 us
- Pagsukod: Kolektor voltage range – HV: 50 mV/div to 500 V/div, HC: 50 mV/div to 5 V/div
Mga Instruksyon sa Paggamit sa Produkto
Supply sa Kolektor
For HV mode, set the max. Peak voltage and current according to the specifications. For HC mode, adjust the settings as needed.
Lakang Generator
Set the step rate and pulse width within the specified ranges for accurate measurements.
Pagsukod
Gamita ang angay nga kolektor voltage range based on the mode of operation for precise readings.
Ideal for measuring the characteristics of various semiconductors such as IGBTs, MOSFETs, transistors, and diodes etc.
- Kinatas-ang peak voltage 3,000V (high voltage mode)
- Maximum peak current 1,000A (CS-3300 high current mode)
- All models equipped with LEAKAGE mode (1pA cursor resolution)
- USB port to save screen data and setup data
- Equipped with La LAN interface for remote control
Easy-to-understand measurement screen
CS-3000 Series Specifications
Collector supply HV mode
| Modelo | CS-3100-300V * 2 | CS-3100 / CS-3200 / CS-3300 | |||
|---|---|---|---|---|---|
| Mode/polarity | Full wave rectification/ + – , DC/ + – , LEAKAGE/ + – , AC | ||||
| Kinatas-ang peak voltage | 300V | 30V | 3kV | 300V | 30V |
| Maximum nga peak kasamtangan (maximum peak pulse current * 1 ) |
750mA (1.5A * 1 ) |
7.5A (15A * 1 ) |
75mA (150mA * 1 ) |
750mA (1.5A * 1 ) |
7.5A (15A * 1 ) |
| Maximum nga peak power | 120mW / 1.2W / 120W / 390W (Cannot be set when using the maximum peak voltage of 3kV) | ||||
| Horizontal axis range | 50mV～500V/div | ||||
- The maximum instantaneous current value that can be generated (varies depending on the target to be measured and conditions), the measurement should be less than or equal to the maximum peak current value.
Collector supply HC mode
| Modelo | CS-3100 / CS-3100-300V * 2 | CS-3200 | CS-3300 | |||
|---|---|---|---|---|---|---|
| Mode/polarity | Not equipped with HC mode | Pulse/ + – | ||||
| Kinatas-ang peak voltage | 40V | |||||
| Maximum nga peak kasamtangan | 400A | 40A | 1,000A | 400A | 40A | |
| Maximum nga peak power | 4kW | 400W | 10kW | 4kW | 400W | |
| Pulse gilapdon | Pulse width is variable at 50µs to 400µs (10µs resolution) | |||||
| Punto sa pagsukod | The measurement point can be specified (10µs resolution) | |||||
| Vertical axis range | 100mA～50A/div | 100mA～100A/div | ||||
| Test fixture | CS-301 | CS-302 | ||||
Komon nga mga Detalye
| Loop correction | Hardware | Correction ofthe floating capacitance between the collector supply and the ground | |
| Software | Pseudo-looping through software optimisation | ||
| Step generator | Offset | Gitakda nga range | -10 ～ +10 x STEP AMPLITUDE Setting |
| Resolusyon | 1% of the STEP AMPLITUDE setting | ||
| Karon nga mode | Sakop | 50nA to 200mA per step, 21 steps, 1-2-5 switching | |
| Maximum nga kasamtangan | 2A | ||
| Maximum nga voltage | 10V o labaw pa | ||
| Voltage modus | Sakop | 50mV to 2V per step, 6 steps, 1-2-5 switching | |
| Maximum nga kasamtangan | 500mA～(～8V), 200mA～(～15V), 10mA～(～40V) | ||
| Maximum nga voltage | ± 40V | ||
| Lakang rate | 2x 50Hz or 60Hz (1x in AC mode), pulse interval in HC mode | ||
| Lakang sa pulso | Pulse gilapdon | 50µs～400µs (10µs step) When in HC mode, the pulse width is 100µs wide before and after the pulse of the collector supply |
|
| Gidaghanon sa mga lakang | 0～20 Step | ||
| AUX nga output | Sakop | OFF, -40V～+40V (Variable in 100mV steps) | |
| Mode sa pagsukod | REPEAT, STOP/SINGLE, SWEEP | ||
| Bertikal nga axis (full scale 10div) |
Kolektor kasamtangan | Sakop | HV mode：1µA/div to 2A/div, 20 steps 1-2-5 switching (HC mode is not included) |
| Pagkatukma | 2% + 0.05 x VERT/div of readout To this, add the loop correction error for the following maximum peak voltages 0.5µA(30V), 1µA(300V), 6µA(3kV), 12µA(5kV) Specify at least 10% of the maximum peak voltage for 30V, 300V, and 3kV, and at least 30% for 5kV |
||
| Emitter kasamtangan (LEAKAGE) |
Sakop | 1nA/div～2mA/div, 20 step 1-2-5 switching (Collector supply mode is LEAKAGE) |
|
| Pagkatukma | 2% + 0.05 x VERT/div + 1nA or less of readout | ||
| Horizontal nga axis (full scale 10div) |
Kolektor voltage |
Sakop | HC mode：50mV/div to 5V/div, 7 steps 1-2-5 switching (HV mode is not included) |
| Pagkatukma | 2% + 0.05 x HORIZ/div or less of readout | ||
| Base/ emitter voltage |
Sakop | 50mV/div~5V/div, 7 step 1-2-5 switching | |
| Pagkatukma | 2% + 0.05 x HORIZ/div or less of readout | ||
| Pagpakita | Pagpakita | 8.4-pulgada nga TFT LCD | |
| Gidaghanon sa mga punto sa datos | 1,000 points/trace (AC, full wave rectification) 20～1,000 points/trace (SWEEP mode) |
||
| Trace display | Point interpolation display, dot display | ||
| Nag-aberids | OFF, 2 to 255 times | ||
| Paglahutay | OFF, SHORT, LONG, Infinite length | ||
| Save internal waveform (REF) | 4 panel | ||
| Cursor | DOT | Vert, Horiz, β or gm | |
| fLINE | Vert, Horiz, 1/grad, intercept | ||
| LIBRE | Vert, Horiz, β or gm | ||
| WINDOW | Vert, Horiz, β or gm in the WINDOW area | ||
| Data save/read | Memorya | Setup：256 pcs, REF：4 screens | |
| External memory | USB1.1：Setup, waveform, screen hardcopy (BMP, TIFF, PNG) | ||
| Hilit nga | Equipped with a remote 10BASE-T/100BASE-TX 1 port via LAN connection | ||
| suplay sa kuryente | AC100～240V 50/60Hz, Maximum operating power：500VA (400W), Standby：50VA (7W) | ||
| External dimensions(mm) Timbang |
CS-3100 / CS-3100-300V * 2 | Approx. 424W x 220H x 555D (excluding protrusions and accessories) approx. 28kg (excluding accessories) |
|
| CS-3200, 3300 | Approx. 424W x 354H x 555D (excluding protrusions and accessories) approx. 43kg (excluding accessories) |
||
CS-3100-300V is a made-to-order product.
Standard nga mga Kagamitan
| CS-500 Pagsulay adapter | |
|---|---|
 |
This is a jig for connecting the part to be measured, provided by the customer, and the fixture. (Standard accessories) |
Mga FAQ
Q: Unsa ang akong buhaton kung ang gilapdon sa pulso pig-ot kaayo?
A: If the pulse width is narrow, adjust the settings to widen it within the allowable range to generate the max. peak voltage.
Q: Giunsa pag-calibrate ang output sa suplay sa kolektor?
A: The collector supply output can be calibrated by enabling/disabling the output and adjusting the floating capacity as per the instructions provided.
Mga Dokumento / Mga Kapanguhaan
 |
Lambda CS-3000 Series Curve Tracer [pdf] Manwal sa Instruksyon CS-3100, CS-3200, CS-3300, CS-3000 Series Curve Tracer, Curve Tracer, Tracer |