Tracciatore di curve Lambda CS-3000 Series
Specifiche
- Model: Curve Tracer CS-3000 series (CS-3100, CS-3200, CS-3300)
- Collector Supply (HV Mode): Max.Peak voltage – 3 kV, Max. Peak current – 15 A, Max. peak power – 390 W
- Collector Supply (HC Mode): Max.PPeakvoltage – 30 V, Max. peak current – 7.5 A, Pulse width – 50 us to 400 us
- Step Generator: Step rate – 1/10 Step, Pulse width range – 50 us to 400 us
- Misurazione: Volume del collettoretage range – HV: 50 mV/div to 500 V/div, HC: 50 mV/div to 5 V/div
Istruzioni per l'uso del prodotto
Fornitura da collezione
For HV mode, set the max. Peak voltage and current according to the specifications. For HC mode, adjust the settings as needed.
Generatore di passi
Set the step rate and pulse width within the specified ranges for accurate measurements.
Misurazione
Utilizzare il volume del collettore appropriatotage range based on the mode of operation for precise readings.
Ideal for measuring the characteristics of various semiconductors such as IGBTs, MOSFETs, transistors, and diodes etc.
- Volume massimo di piccotage 3,000V (high voltagmodalità e)
- Maximum peak current 1,000A (CS-3300 high current mode)
- All models equipped with LEAKAGE mode (1pA cursor resolution)
- USB port to save screen data and setup data
- Equipped with La LAN interface for remote control
Easy-to-understand measurement screen
CS-3000 Series Specifications
Collector supply HV mode
| Modello | CS-3100-300V * 2 | CS-3100 / CS-3200 / CS-3300 | |||
|---|---|---|---|---|---|
| Modalità/polarità | Full wave rectification/ + – , DC/ + – , LEAKAGE/ + – , AC | ||||
| Volume massimo di piccotage | 300V | 30V | 3kV | 300V | 30V |
| Massima corrente di picco (maximum peak pulse current * 1 ) |
750mA (1.5A * 1 ) |
7.5A (15A * 1 ) |
75mA (150mA * 1 ) |
750mA (1.5A * 1 ) |
7.5A (15A * 1 ) |
| Massima potenza di picco | 120mW / 1.2W / 120W / 390W (Cannot be set when using the maximum peak voltage of 3kV) | ||||
| Horizontal axis range | 50mV～500V/div | ||||
- The maximum instantaneous current value that can be generated (varies depending on the target to be measured and conditions), the measurement should be less than or equal to the maximum peak current value.
Collector supply HC mode
| Modello | CS-3100 / CS-3100-300V * 2 | CS-3200 | CS-3300 | |||
|---|---|---|---|---|---|---|
| Modalità/polarità | Not equipped with HC mode | Pulse/ + – | ||||
| Volume massimo di piccotage | 40V | |||||
| Massima corrente di picco | 400A | 40A | 1,000A | 400A | 40A | |
| Massima potenza di picco | 4 kW | 400W | 10 kW | 4 kW | 400W | |
| Larghezza di impulso | Pulse width is variable at 50µs to 400µs (10µs resolution) | |||||
| Punto di misurazione | The measurement point can be specified (10µs resolution) | |||||
| Vertical axis range | 100mA～50A/div | 100mA～100A/div | ||||
| Dispositivo di prova | CS-301 | CS-302 | ||||
Specifiche comuni
| Loop correction | Hardware | Correction ofthe floating capacitance between the collector supply and the ground | |
| Software | Pseudo-looping through software optimisation | ||
| Generatore di passi | Offset | Campo di regolazione | -10 ～ +10 x STEP AMPLITUDE Setting |
| Risoluzione | 1% of the STEP AMPLITUDE setting | ||
| Modalità corrente | Allineare | 50nA to 200mA per step, 21 steps, 1-2-5 switching | |
| Corrente massima | 2A | ||
| Volume massimotage | 10 V o più | ||
| Voltagmodalità e | Allineare | 50mV to 2V per step, 6 steps, 1-2-5 switching | |
| Corrente massima | 500mA～(～8V), 200mA～(～15V), 10mA～(～40V) | ||
| Volume massimotage | ±40 V | ||
| Velocità del passo | 2x 50Hz or 60Hz (1x in AC mode), pulse interval in HC mode | ||
| Passo di impulso | Larghezza di impulso | 50µs～400µs (10µs step) When in HC mode, the pulse width is 100µs wide before and after the pulse of the collector supply |
|
| Numero di passi | 0～20 Step | ||
| Uscita AUX | Allineare | OFF, -40V～+40V (Variable in 100mV steps) | |
| Modalità di misurazione | RIPETI, STOP/SINGOLO, SPAZZA | ||
| Asse verticale (full scale 10div) |
Corrente del collettore | Allineare | HV mode：1µA/div to 2A/div, 20 steps 1-2-5 switching (HC mode is not included) |
| Precisione | 2% + 0.05 x VERT/div of readout To this, add the loop correction error for the following maximum peak voltages 0.5µA(30V), 1µA(300V), 6µA(3kV), 12µA(5kV) Specify at least 10% of the maximum peak voltage for 30V, 300V, and 3kV, and at least 30% for 5kV |
||
| Emettitore attuale (LEAKAGE) |
Allineare | 1nA/div～2mA/div, 20 step 1-2-5 switching (Collector supply mode is LEAKAGE) |
|
| Precisione | 2% + 0.05 x VERT/div + 1nA or less of readout | ||
| Asse orizzontale (full scale 10div) |
Collettore volumetage |
Allineare | HC mode：50mV/div to 5V/div, 7 steps 1-2-5 switching (HV mode is not included) |
| Precisione | 2% + 0.05 x HORIZ/div or less of readout | ||
| Base/ emettitore volumetage |
Allineare | 50mV/div~5V/div, 7 step 1-2-5 switching | |
| Precisione | 2% + 0.05 x HORIZ/div or less of readout | ||
| Display | Display | 8.4-inch TFT LCD | |
| Numero di punti dati | 1,000 points/trace (AC, full wave rectification) 20～1,000 points/trace (SWEEP mode) |
||
| Trace display | Point interpolation display, dot display | ||
| Media | OFF, 2 to 255 times | ||
| Persistenza | OFF, SHORT, LONG, Infinite length | ||
| Save internal waveform (REF) | 4 pannelli | ||
| Cursore | PUNTO | Vert, Horiz, β or gm | |
| fLINEA | Vert, Horiz, 1/grad, intercept | ||
| GRATUITO | Vert, Horiz, β or gm | ||
| FINESTRA | Vert, Horiz, β or gm in the WINDOW area | ||
| Data save/read | Memoria | Setup：256 pcs, REF：4 screens | |
| Memoria esterna | USB1.1：Setup, waveform, screen hardcopy (BMP, TIFF, PNG) | ||
| Remoto | Equipped with a remote 10BASE-T/100BASE-TX 1 port via LAN connection | ||
| Alimentazione elettrica | AC100～240V 50/60Hz, Maximum operating power：500VA (400W), Standby：50VA (7W) | ||
| External dimensions(mm) Peso |
CS-3100 / CS-3100-300V * 2 | Approx. 424W x 220H x 555D (excluding protrusions and accessories) approx. 28kg (excluding accessories) |
|
| CS-3200, 3300 | Approx. 424W x 354H x 555D (excluding protrusions and accessories) approx. 43kg (excluding accessories) |
||
CS-3100-300V is a made-to-order product.
Accessori standard
| CS-500 Adattatore di prova | |
|---|---|
 |
This is a jig for connecting the part to be measured, provided by the customer, and the fixture. (Standard accessories) |
Domande frequenti
D: Cosa devo fare se la larghezza dell'impulso è troppo stretta?
A: If the pulse width is narrow, adjust the settings to widen it within the allowable range to generate the max. peak voltage.
D: Come calibrare l'uscita di alimentazione del collettore?
A: The collector supply output can be calibrated by enabling/disabling the output and adjusting the floating capacity as per the instructions provided.
Documenti / Risorse
 |
Tracciatore di curve Lambda CS-3000 Series [pdf] Manuale di istruzioni Tracciatore di curve serie CS-3100, CS-3200, CS-3300, CS-3000, Tracciatore di curve, Tracciatore |