Lambda CS-3000-serien kurvspårare
Specifikationer
- Model: Curve Tracer CS-3000 series (CS-3100, CS-3200, CS-3300)
- Collector Supply (HV Mode): Max.Peak voltage – 3 kV, Max. Peak current – 15 A, Max. peak power – 390 W
- Collector Supply (HC Mode): Max.PPeakvoltage – 30 V, Max. peak current – 7.5 A, Pulse width – 50 us to 400 us
- Step Generator: Step rate – 1/10 Step, Pulse width range – 50 us to 400 us
- Mätning: Kollektorvolymtage range – HV: 50 mV/div to 500 V/div, HC: 50 mV/div to 5 V/div
Produktanvändningsinstruktioner
Kollektorförsörjning
For HV mode, set the max. Peak voltage and current according to the specifications. For HC mode, adjust the settings as needed.
Steggenerator
Set the step rate and pulse width within the specified ranges for accurate measurements.
Mått
Använd lämplig uppsamlarvolymtage range based on the mode of operation for precise readings.
Ideal for measuring the characteristics of various semiconductors such as IGBTs, MOSFETs, transistors, and diodes etc.
- Maximal peak voltage 3,000V (high voltage-läge)
- Maximum peak current 1,000A (CS-3300 high current mode)
- All models equipped with LEAKAGE mode (1pA cursor resolution)
- USB port to save screen data and setup data
- Equipped with La LAN interface for remote control
Easy-to-understand measurement screen
CS-3000 Series Specifications
Collector supply HV mode
| Modell | CS-3100-300V * 2 | CS-3100 / CS-3200 / CS-3300 | |||
|---|---|---|---|---|---|
| Läge/polaritet | Full wave rectification/ + – , DC/ + – , LEAKAGE/ + – , AC | ||||
| Maximal peak voltage | 300V | 30V | 3 kV | 300V | 30V |
| Maximal toppström (maximum peak pulse current * 1 ) |
750mA (1.5A * 1 ) |
7.5A (15A * 1 ) |
75mA (150mA * 1 ) |
750mA (1.5A * 1 ) |
7.5A (15A * 1 ) |
| Maximal toppeffekt | 120mW / 1.2W / 120W / 390W (Cannot be set when using the maximum peak voltage of 3kV) | ||||
| Horizontal axis range | 50mV～500V/div | ||||
- The maximum instantaneous current value that can be generated (varies depending on the target to be measured and conditions), the measurement should be less than or equal to the maximum peak current value.
Collector supply HC mode
| Modell | CS-3100 / CS-3100-300V * 2 | CS-3200 | CS-3300 | |||
|---|---|---|---|---|---|---|
| Läge/polaritet | Not equipped with HC mode | Pulse/ + – | ||||
| Maximal peak voltage | 40V | |||||
| Maximal toppström | 400A | 40A | 1,000A | 400A | 40A | |
| Maximal toppeffekt | 4kW | 400W | 10kW | 4kW | 400W | |
| Pulsbredd | Pulse width is variable at 50µs to 400µs (10µs resolution) | |||||
| Mätpunkt | The measurement point can be specified (10µs resolution) | |||||
| Vertical axis range | 100mA～50A/div | 100mA～100A/div | ||||
| Testfixtur | CS-301 | CS-302 | ||||
Vanliga specifikationer
| Loop correction | Hårdvara | Correction ofthe floating capacitance between the collector supply and the ground | |
| Programvara | Pseudo-looping through software optimisation | ||
| Steggenerator | Offset | Inställningsområde | -10 ～ +10 x STEP AMPLITUDE Setting |
| Upplösning | 1% of the STEP AMPLITUDE setting | ||
| Aktuellt läge | Räckvidd | 50nA to 200mA per step, 21 steps, 1-2-5 switching | |
| Maximal ström | 2A | ||
| Max volymtage | 10V eller mer | ||
| Voltage -läge | Räckvidd | 50mV to 2V per step, 6 steps, 1-2-5 switching | |
| Maximal ström | 500mA～(～8V), 200mA～(～15V), 10mA～(～40V) | ||
| Max volymtage | ±40V | ||
| Steghastighet | 2x 50Hz or 60Hz (1x in AC mode), pulse interval in HC mode | ||
| Pulssteg | Pulsbredd | 50µs～400µs (10µs step) When in HC mode, the pulse width is 100µs wide before and after the pulse of the collector supply |
|
| Antal steg | 0～20 Step | ||
| AUX-utgång | Räckvidd | OFF, -40V～+40V (Variable in 100mV steps) | |
| Mätläge | UPPREPA, STOPP/ENSKEL, SVEP | ||
| Vertikal axel (full scale 10div) |
Samlarström | Räckvidd | HV mode：1µA/div to 2A/div, 20 steps 1-2-5 switching (HC mode is not included) |
| Noggrannhet | 2% + 0.05 x VERT/div of readout To this, add the loop correction error for the following maximum peak voltages 0.5µA(30V), 1µA(300V), 6µA(3kV), 12µA(5kV) Specify at least 10% of the maximum peak voltage for 30V, 300V, and 3kV, and at least 30% for 5kV |
||
| Sändare nuvarande (LEAKAGE) |
Räckvidd | 1nA/div～2mA/div, 20 step 1-2-5 switching (Collector supply mode is LEAKAGE) |
|
| Noggrannhet | 2% + 0.05 x VERT/div + 1nA or less of readout | ||
| Horisontell axel (full scale 10div) |
Samlare voltage |
Räckvidd | HC mode：50mV/div to 5V/div, 7 steps 1-2-5 switching (HV mode is not included) |
| Noggrannhet | 2% + 0.05 x HORIZ/div or less of readout | ||
| Base/ utsändare voltage |
Räckvidd | 50mV/div~5V/div, 7 step 1-2-5 switching | |
| Noggrannhet | 2% + 0.05 x HORIZ/div or less of readout | ||
| Visa | Visa | 8.4-tums TFT LCD-skärm | |
| Antal datapunkter | 1,000 points/trace (AC, full wave rectification) 20～1,000 points/trace (SWEEP mode) |
||
| Trace display | Point interpolation display, dot display | ||
| Medelvärde | OFF, 2 to 255 times | ||
| Uthållighet | OFF, SHORT, LONG, Infinite length | ||
| Save internal waveform (REF) | 4 panel | ||
| Markör | PUNKT | Vert, Horiz, β or gm | |
| fLINE | Vert, Horiz, 1/grad, intercept | ||
| GRATIS | Vert, Horiz, β or gm | ||
| FÖNSTER | Vert, Horiz, β or gm in the WINDOW area | ||
| Data save/read | Minne | Setup：256 pcs, REF：4 screens | |
| Externt minne | USB1.1：Setup, waveform, screen hardcopy (BMP, TIFF, PNG) | ||
| Avlägsen | Equipped with a remote 10BASE-T/100BASE-TX 1 port via LAN connection | ||
| Strömförsörjning | AC100～240V 50/60Hz, Maximum operating power：500VA (400W), Standby：50VA (7W) | ||
| External dimensions(mm) Vikt |
CS-3100 / CS-3100-300V * 2 | Approx. 424W x 220H x 555D (excluding protrusions and accessories) approx. 28kg (excluding accessories) |
|
| CS-3200, 3300 | Approx. 424W x 354H x 555D (excluding protrusions and accessories) approx. 43kg (excluding accessories) |
||
CS-3100-300V is a made-to-order product.
Standardtillbehör
| CS-500 Testa adapter | |
|---|---|
 |
This is a jig for connecting the part to be measured, provided by the customer, and the fixture. (Standard accessories) |
Vanliga frågor
F: Vad ska jag göra om pulsbredden är för smal?
A: If the pulse width is narrow, adjust the settings to widen it within the allowable range to generate the max. peak voltage.
F: Hur kalibrerar man kollektorns matningsutgång?
A: The collector supply output can be calibrated by enabling/disabling the output and adjusting the floating capacity as per the instructions provided.
Dokument/resurser
 |
Lambda CS-3000-serien kurvspårare [pdf] Bruksanvisning CS-3100, CS-3200, CS-3300, CS-3000-serien Kurvspårare, Kurvspårare, Spårare |