Sledilnik krivulj serije Lambda CS-3000
Specifikacije
- Model: Curve Tracer CS-3000 series (CS-3100, CS-3200, CS-3300)
- Collector Supply (HV Mode): Max.Peak voltage – 3 kV, Max. Peak current – 15 A, Max. peak power – 390 W
- Collector Supply (HC Mode): Max.PPeakvoltage – 30 V, Max. peak current – 7.5 A, Pulse width – 50 us to 400 us
- Step Generator: Step rate – 1/10 Step, Pulse width range – 50 us to 400 us
- Meritev: Volumen zbiralnikatage range – HV: 50 mV/div to 500 V/div, HC: 50 mV/div to 5 V/div
Navodila za uporabo izdelka
Zbirateljska dobava
For HV mode, set the max. Peak voltage and current according to the specifications. For HC mode, adjust the settings as needed.
Generator korakov
Set the step rate and pulse width within the specified ranges for accurate measurements.
Merjenje
Uporabite ustrezno količino zbiralnikatage range based on the mode of operation for precise readings.
Ideal for measuring the characteristics of various semiconductors such as IGBTs, MOSFETs, transistors, and diodes etc.
- Najvišja voltage 3,000V (high voltage način)
- Maximum peak current 1,000A (CS-3300 high current mode)
- All models equipped with LEAKAGE mode (1pA cursor resolution)
- USB port to save screen data and setup data
- Equipped with La LAN interface for remote control
Easy-to-understand measurement screen
CS-3000 Series Specifications
Collector supply HV mode
| Model | CS-3100-300V * 2 | CS-3100 / CS-3200 / CS-3300 | |||
|---|---|---|---|---|---|
| Način/polarnost | Full wave rectification/ + – , DC/ + – , LEAKAGE/ + – , AC | ||||
| Najvišja voltage | 300 V | 30 V | 3kV | 300 V | 30 V |
| Največji vršni tok (maximum peak pulse current * 1 ) |
750mA (1.5A * 1 ) |
7.5A (15A * 1 ) |
75mA (150mA * 1 ) |
750mA (1.5A * 1 ) |
7.5A (15A * 1 ) |
| Največja največja moč | 120mW / 1.2W / 120W / 390W (Cannot be set when using the maximum peak voltage of 3kV) | ||||
| Horizontal axis range | 50mV～500V/div | ||||
- The maximum instantaneous current value that can be generated (varies depending on the target to be measured and conditions), the measurement should be less than or equal to the maximum peak current value.
Collector supply HC mode
| Model | CS-3100 / CS-3100-300V * 2 | CS-3200 | CS-3300 | |||
|---|---|---|---|---|---|---|
| Način/polarnost | Not equipped with HC mode | Pulse/ + – | ||||
| Najvišja voltage | 40 V | |||||
| Največji vršni tok | 400A | 40A | 1,000A | 400A | 40A | |
| Največja največja moč | 4 kW | 400 W | 10 kW | 4 kW | 400 W | |
| Širina impulza | Pulse width is variable at 50µs to 400µs (10µs resolution) | |||||
| Merilna točka | The measurement point can be specified (10µs resolution) | |||||
| Vertical axis range | 100mA～50A/div | 100mA～100A/div | ||||
| Testna naprava | CS-301 | CS-302 | ||||
Skupne specifikacije
| Loop correction | Strojna oprema | Correction ofthe floating capacitance between the collector supply and the ground | |
| Programska oprema | Pseudo-looping through software optimisation | ||
| Generator korakov | Odmik | Območje nastavitve | -10 ～ +10 x STEP AMPLITUDE Setting |
| Resolucija | 1% of the STEP AMPLITUDE setting | ||
| Trenutni način | Razpon | 50nA to 200mA per step, 21 steps, 1-2-5 switching | |
| Največji tok | 2A | ||
| Največja voltage | 10 V ali več | ||
| voltage način | Razpon | 50mV to 2V per step, 6 steps, 1-2-5 switching | |
| Največji tok | 500mA～(～8V), 200mA～(～15V), 10mA～(～40V) | ||
| Največja voltage | ±40V | ||
| Stopnja koraka | 2x 50Hz or 60Hz (1x in AC mode), pulse interval in HC mode | ||
| Korak impulza | Širina impulza | 50µs～400µs (10µs step) When in HC mode, the pulse width is 100µs wide before and after the pulse of the collector supply |
|
| Število korakov | 0～20 Step | ||
| AUX izhod | Razpon | OFF, -40V～+40V (Variable in 100mV steps) | |
| Način merjenja | PONAVLJANJE, STOP/ENOJNO, PREMIKANJE | ||
| Navpična os (full scale 10div) |
Kolektorski tok | Razpon | HV mode：1µA/div to 2A/div, 20 steps 1-2-5 switching (HC mode is not included) |
| Natančnost | 2% + 0.05 x VERT/div of readout To this, add the loop correction error for the following maximum peak voltages 0.5µA(30V), 1µA(300V), 6µA(3kV), 12µA(5kV) Specify at least 10% of the maximum peak voltage for 30V, 300V, and 3kV, and at least 30% for 5kV |
||
| Oddajnik trenutno (LEAKAGE) |
Razpon | 1nA/div～2mA/div, 20 step 1-2-5 switching (Collector supply mode is LEAKAGE) |
|
| Natančnost | 2% + 0.05 x VERT/div + 1nA or less of readout | ||
| Vodoravna os (full scale 10div) |
Zbiralec voltage |
Razpon | HC mode：50mV/div to 5V/div, 7 steps 1-2-5 switching (HV mode is not included) |
| Natančnost | 2% + 0.05 x HORIZ/div or less of readout | ||
| Base/ oddajnik voltage |
Razpon | 50mV/div~5V/div, 7 step 1-2-5 switching | |
| Natančnost | 2% + 0.05 x HORIZ/div or less of readout | ||
| Zaslon | Zaslon | 8.4-palčni TFT LCD | |
| Število podatkovnih točk | 1,000 points/trace (AC, full wave rectification) 20～1,000 points/trace (SWEEP mode) |
||
| Trace display | Point interpolation display, dot display | ||
| Povprečenje | OFF, 2 to 255 times | ||
| Vztrajnost | OFF, SHORT, LONG, Infinite length | ||
| Save internal waveform (REF) | 4-plošča | ||
| Kazalec | DOT | Vert, Horiz, β or gm | |
| fLINE | Vert, Horiz, 1/grad, intercept | ||
| BREZPLAČNO | Vert, Horiz, β or gm | ||
| OKNO | Vert, Horiz, β or gm in the WINDOW area | ||
| Data save/read | Spomin | Setup：256 pcs, REF：4 screens | |
| Zunanji pomnilnik | USB1.1：Setup, waveform, screen hardcopy (BMP, TIFF, PNG) | ||
| Daljinsko | Equipped with a remote 10BASE-T/100BASE-TX 1 port via LAN connection | ||
| Napajanje | AC100～240V 50/60Hz, Maximum operating power：500VA (400W), Standby：50VA (7W) | ||
| External dimensions(mm) Teža |
CS-3100 / CS-3100-300V * 2 | Approx. 424W x 220H x 555D (excluding protrusions and accessories) approx. 28kg (excluding accessories) |
|
| CS-3200, 3300 | Approx. 424W x 354H x 555D (excluding protrusions and accessories) approx. 43kg (excluding accessories) |
||
CS-3100-300V is a made-to-order product.
Standardni dodatki
| CS-500 Testni adapter | |
|---|---|
 |
This is a jig for connecting the part to be measured, provided by the customer, and the fixture. (Standard accessories) |
pogosta vprašanja
V: Kaj naj storim, če je širina impulza preozka?
A: If the pulse width is narrow, adjust the settings to widen it within the allowable range to generate the max. peak voltage.
V: Kako kalibrirati izhod napajanja kolektorja?
A: The collector supply output can be calibrated by enabling/disabling the output and adjusting the floating capacity as per the instructions provided.
Dokumenti / Viri
 |
Sledilnik krivulj serije Lambda CS-3000 [pdf] Navodila za uporabo Sledilnik krivulj serije CS-3100, CS-3200, CS-3300, CS-3000, sledilnik krivulj, sledilnik |