INCWADI YOKUFAKA
I-ZD-IN
IZIXWAYISO ZOKUQALA
Igama ISEXWAYISO elandulelwa uphawu 
ibonisa izimo noma izenzo ezibeka ukuphepha komsebenzisi engcupheni.
Igama elithi ATTENTION elandulelwa uphawu ibonisa izimo noma izenzo ezingase zilimaze ithuluzi noma okokusebenza okuxhunyiwe. Iwaranti izoba ize futhi ize uma kwenzeka sisetshenziswa ngendlela engafanele noma tampehambisana nemojuli noma izisetshenziswa ezihlinzekwe umenzi njengoba kudingeka ukuze zisebenze kahle, futhi uma imiyalelo equkethwe kule ncwajana ingalandelwa.
|
ISEXWAYISO: Okuqukethwe okugcwele kwaleli bhukwana kumele kufundwe ngaphambi kwanoma yikuphi ukusebenza. Imojula kumele isetshenziswe kuphela ngabasebenza ngogesi abaqeqeshiwe. Amadokhumenti athile atholakala nge-QR-CODE eboniswe ekhasini 1. |
 |
Imojuli kumele ilungiswe futhi izingxenye ezilimele zithathelwe indawo uMkhiqizi. Umkhiqizo uyazwela ekukhishweni kwe-electrostatic. Thatha izinyathelo ezifanele ngesikhathi sokusebenza. |
 |
Ukulahlwa kwemfucuza kagesi ne-elekthronikhi (kusebenza e-European Union nakwamanye amazwe anokugaywa kabusha). Uphawu olusemkhiqizweni noma emaphaketheni awo lubonisa ukuthi umkhiqizo kufanele unikezelwe esikhungweni sokuqoqwa kwempahla esigunyazwe ukuvuselela imfucuza kagesi neye-elekthronikhi. |
UKUHLELWA KWEMODULI
IZIMPAWU NGE-LED PHAMBILI
| I-LED | ISIMO | Incazelo ye-LED |
| I-PWR Green | ON | Idivayisi inikwe amandla ngendlela efanele |
| YEHLULEKA ophuzi | ON | Iphutha noma iphutha |
| YEHLULEKA ophuzi | Iyabaneka | Ukusethwa okungalungile |
| I-RX Ebomvu | ON | Ukuhlola ukuxhumeka |
| I-RX Ebomvu | Iyabaneka | Ukwamukelwa kwephakethe kuqediwe |
| I-TX Ebomvu | Iyabaneka | Ukudluliswa kwephakethe kuqediwe |
IMICIMBI YOBUCHWEPHESHE
| IZIQINISEKISO |  https://www.seneca.it/products/z-d-in/doc/CE_declaration |
| UKUHLANGANISA |  |
| UKUNIKEZWA KWAMANDLA KAGESI | Voltage: 10 ÷ 40Vdc; 19 ÷ 28Vac; 50 ÷ 60Hz Ukumuncwa: Okujwayelekile: 1.5W @ 24Vdc, Ubukhulu: 2.5W |
| SEBENZISA | Sebenzisa ezindaweni ezine-pollution degree 2. Iyunithi yokuphakela amandla kufanele ibe isigaba 2. |
| IZIMO ZEMVELO | Izinga lokushisa: -10÷ + 65°C Umswakamo: 30%÷ 90% ku-40°C ukunganciphisi. Ukuphakama: Kufika ku-2,000 m ngaphezu kwezinga lolwandle Izinga lokushisa lesitoreji: -20÷ + 85°C Izinga lokuvikela: IP20. |
| UMHLANGANO | I-IEC EN60715, 35mm DIN ujantshi endaweni mpo. |
| IZIXHUMANO | Izindlela ezi-3 zamatheminali ngezikulufu ezikhiphekayo, iphimbo elingu-5mm, isigaba esingu-2.5mm2 Isixhumi sangemuva se-IDC10 sebha ye-DIN 46277 |
| IZIMPAWU | |
| Uhlobo olusekelwe okokufaka: |
Reed, Contatto, proximity PNP, NPN (ngokumelana kwangaphandle) |
| Inani leziteshi: | I-5 (4+ 1) izenzela amandla ku-16Vdc |
| Ubuningi beTotalizer imvamisa |
I-100 Hz yamashaneli asuka ku-1 kuye ku-5 10 kHz kuphela okokufaka 5 (ngemuva kokusetha) |
| UL (Isimo sicinyiwe) | 0 ÷ 10 Vdc, I <2mA |
| UH (isimo IVULIWE) | 12 ÷ 30 Vdc; mina > 3mA |
| Okwamanje kumunyiwe | 3mA (kokufaka ngakunye okusebenzayo) |
| Ukuvikelwa | Ngokusebenzisa izicindezeli ze-TVS zesikhashana ezingama-600 W/ms. |
UKULUNGISWA KWEZILUNGISELELO ZEFEKTHI
| Wonke ama-DIP ashintsha ukungena | VALIWE |
| Imingcele yokuxhumana ye-Modbus protocol: | 38400 8, N, 1 Ikheli 1 |
| Ukuguqulwa kwesimo sokufaka: | IKHUBAZIWE |
| Isihlungi sedijithali | 3ms |
| Ama-Totalizers | Ibala ukuya ekukhuleni |
| Isiteshi 5 ngo-10 kHz | Ikhutshaziwe |
| Isikhathi se-Modbus latency | 5ms |
IMITHETHO YOKUXHUMANA kwe-Modbus
- Faka amamojula kuloliwe we-DIN (120 max)
- Xhuma amamojula akude usebenzisa izintambo zobude obufanele. Ithebula elilandelayo libonisa idatha yobude bekhebula:
- Ubude bebhasi: ubude obukhulu benethiwekhi ye-Modbus ngokuya nge-Baud Rate. Lobu ubude bezintambo ezixhuma amamojula amabili akude kakhulu (bheka Umdwebo 1).
- Ubude bokuphuma: ubude obukhulu bokuphuma kwe-2 m (bona Umdwebo 1).
Umdwebo 1
| Ubude bebhasi | Ubude bokuphuma |
| 1200 m | 2 m |
Ukuze uthole ukusebenza okuphezulu, kunconywa ukusebenzisa izintambo ezikhethekile ezivikelwe, njenge-BELDEN 9841.
I-IDC10 Connector
Ukunikezwa kwamandla kanye nesixhumi esibonakalayo se-Modbus kuyatholakala kusetshenziswa ibhasi likaloliwe i-Seneca DIN, ngesixhumi esingemuva se-IDC10, noma isisetshenziswa se-Z-PC-DINAL2-17.5.
Isixhumi Sangemuva (IDC 10)
Incazelo yamaphinikhodi ahlukahlukene kusixhumi se-IDC10 iboniswa esithombeni uma ufisa ukunikeza amasignali ngokuqondile ngaso.
UKUSETHA I-DIP-Switchches
Isikhundla samaswishi e-DIP sichaza imingcele yokuxhumana ye-Modbus yemojuli: Ikheli kanye ne-Baud Rate
Ithebula elilandelayo libonisa amanani we-Baud Rate kanye nekheli ngokuya ngokuhlelwa kwamaswishi e-DIP:
| Isimo se-DIP-Shintsha | |||||
| SW1 POSITION | I-BAUD RATE |
SW1 POSITION | IKHELI | POSITION | I-TERMINATOR |
| 1 2 3 4 5 6 7 8 | 3 4 5 6 7 8 | 10 | |||
| ————– |
9600 |  |
#1 | |
Ikhutshaziwe |
| ———— |
19200 | |
#2 | |
Inikwe amandla |
| ———– |
38400 | ••••••• | #… | ||
| ———– |
57600 | |
#63 | ||
| ——- |
Kusuka EEPROM |
|
Kusuka EEPROM |
||
Qaphela: Uma ukushintsha kwe-DIP koku-3 kuye ku-8 KUVALIWE, izilungiselelo zokuxhumana zithathwa ezinhlelweni (EEPROM).
Qaphela 2: Ulayini we-RS485 kufanele unqanyulwe kuphela ekugcineni kolayini wokuxhumana.
Izilungiselelo zama-dip-switch kumele zihambisane nezilungiselelo ezikumarejista.
Incazelo yamarejista iyatholakala KU-MANUAL YOMSEBENZISI.
IZIXHUMANO ZIKAgesi
Ukunikezwa kwamandla kagesi:
Imikhawulo ephezulu akumele yeqiwe ukuze kugwenywe umonakalo omkhulu kumojuli.
Uma umthombo wokuphakelwa kukagesi ungavikelekile ekulayishweni ngokweqile, i-fuse yokuphepha kufanele ifakwe entanjeni yokuphakelwa kukagesi enevelu elifanele lokho okudingwa yisimo.
I-Modbus RS485
Ukuxhumana kokuxhumana kwe-RS485 kusetshenziswa i-MODBUS master system njengenye indlela yebhasi le-Z-PC-DINx.
QAPHELA: Inkomba ye-polarity ye-RS485 yokuxhuma ayimisiwe futhi kwamanye amadivaysi ingase ihlanekezelwe.
IZIMPAWU
IZILUNGISELELO ZOKUFAKA:
Izilungiselelo ezizenzakalelayo:
Okokufaka #1: 0 – 100 Hz (16BIT)
Okokufaka #2: 0 – 100 Hz (16BIT)
Okokufaka #3: 0 – 100 Hz (16BIT)
Okokufaka #4: 0 – 100 Hz (16BIT)
Okokufaka #5: 0 – 100 Hz (16BIT)
Okokufaka #5 kungasethwa njengethothali:
Okokufaka #5: 0 – 10 kHz (32BIT)
QAPHELA
Imikhawulo ephezulu yokunikezwa kwamandla akumele yeqiwe, njengoba lokhu kungase kubangele umonakalo omkhulu kumojuli. Vala imojuli ngaphambi kokuxhuma okokufaka nokuphumayo.
Ukuze uhlangabezane nezidingo ze-electromagnetic immune immune:
- sebenzisa izintambo zesignali ezivikelekile;
- xhuma isihlangu kusistimu yomhlaba yezinsimbi ezithandwayo;
- i-fuse ene-MAX. isilinganiso se-0,5 A kufanele sifakwe eduze kwemojula.
- hlukanisa izintambo ezivikelwe kwezinye izintambo ezisetshenziselwa ukufaka amandla (ama-inverter, ama-motor, ama-oven okungenisa, njll…).
- qiniseka ukuthi imojula ayinikeziwe ngevolthi yokunikezelatagiphakeme kunaleyo ekhonjiswe kuzicaciso zobuchwepheshe ukuze ingalimazi.
I-SENECA srl; Nge-Austria, 26 - 35127 - PADOVA - ITALY;
Ucingo. +39.049.8705359 -
Ifeksi +39.049.8706287
ULWAZI LOKUXHUMANA
Ukusekela kwezobuchwepheshe
support@seneca.it
Ulwazi lomkhiqizo
sales@seneca.it
Le dokhumenti iyindawo ye-SENECA srl. Amakhophi nokukhiqizwa kabusha akuvunyelwe ngaphandle uma kugunyaziwe. Okuqukethwe kulo mbhalo kuhambisana nemikhiqizo echazwe kanye nobuchwepheshe. Idatha eshiwo ingashintshwa noma yengezwe ngezinjongo zobuchwepheshe kanye/noma zokuthengisa.
Amadokhumenti / Izinsiza
 |
I-SENECA ZD-IN Digital Input noma amamojula okukhiphayo [pdf] Incwadi Yeziqondiso I-ZD-IN, Okokufaka Kwedijithali noma Amamojula Okukhiphayo, Okokufaka Kwedijithali ye-ZD-IN noma amamojula okukhiphayo |
