INSTALLATION Manual
ZD-IN
YAMBIRO YEKUTANGA
Shoko rokuti YAMBIRO rinotangirwa nechiratidzo 
inoratidza mamiriro kana zviito zvinoisa kuchengetedzwa kwemushandisi panjodzi.
Shoko rokuti ATTENTION rinotangirwa nechiratidzo inoratidza mamiriro kana zviito zvinogona kukanganisa chiridzwa kana mudziyo wakabatana. Warranti ichave isina maturo uye isina chinhu kana ikashandiswa zvisina kunaka kana tampering nemodule kana zvishandiso zvinopihwa nemugadziri sezvinodiwa pakushanda kwayo, uye kana mirairo iri mubhuku iri ikasateedzerwa.
|
YAMBIRO: Zvose zviri mubhuku rino zvinofanira kuverengwa kusati kwaitwa chero basa. Iyo module inofanirwa kushandiswa chete nevano gadzira magetsi. Mapepa chaiwo anowanikwa kuburikidza neQR-CODE inoratidzwa papeji 1. |
 |
Iyo module inofanirwa kugadziriswa uye yakakuvadzwa zvikamu zvinotsiviwa neMugadziri. Chigadzirwa chacho chinonzwa kune electrostatic discharges. Tora matanho akakodzera panguva chero ipi zvayo yekushanda. |
 |
Kurasa tsvina yemagetsi neyemagetsi (inoshanda muEuropean Union nedzimwe nyika dzine kudzokorora). Chiratidzo chiri pachigadzirwa kana kurongedzerwa kwacho chinoratidza chigadzirwa chinofanirwa kupihwa kunzvimbo yekuunganidza ine mvumo yekudzoreredza tsvina yemagetsi neyemagetsi. |
MODULE RAYOUT
ZVIRATIDZO VIA LED PAMBERI PANEL
| LED | STATUS | LED zvinoreva |
| PWR Green | ON | Chigadzirwa chacho chinofambiswa nemazvo |
| FAIL yellow | ON | Anomaly kana kukanganisa |
| FAIL yellow | Kupenya | Wrong setup |
| RX Tsvuku | ON | Kuongorora kwekubatanidza |
| RX Tsvuku | Kupenya | Kutambira pakiti kwapera |
| TX Red | Kupenya | Kutumirwa kwepaketi kwapera |
ZVAKAITIKA ZVINHU
| ZVIMBO |  https://www.seneca.it/products/z-d-in/doc/CE_declaration |
| KUSVIRA |  |
| MAGETSI | Voltage: 10 ÷ 40Vdc; 19 ÷ 28Vac; 50 ÷ 60Hz Kunyura: Yakajairika: 1.5W @ 24Vdc, Max: 2.5W |
| SHANDISA | Shandisa munzvimbo dzine dhigirii rekusvibisa 2. Iyo magetsi emagetsi anofanirwa kunge ari kirasi 2. |
| ZVINHU ZVAKAITIKA | Tembiricha: -10÷ + 65°C Humidity: 30% ÷ 90% pa 40°C noncondensing. Altitude: Kusvikira ku2,000 m pamusoro pegungwa Kuchengetedza tembiricha: -20÷ + 85°C Dhigirii rekudzivirira: IP20. |
| ASSEMBLY | IEC EN60715, 35mm DIN njanji munzvimbo yakatwasuka. |
| CONNECTIONS | 3-nzira inobviswa screw terminals, 5mm pitch, 2.5mm2 chikamu Rear connector IDC10 yeDIN bar 46277 |
| ZVINHU | |
| Rudzi rwekutsigirwa zvinopinda: |
Reed, Contatto, pedyo nePNP, NPN (ine kuramba kwekunze) |
| Nhamba yezviteshi: | 5 (4+ 1) inozvifambisa pa16Vdc |
| Totalizer maximum frequency |
100 Hz yezviteshi kubva pa1 kusvika ku5 10 kHz chete yekuisa 5 (mushure mekuseta) |
| UL (Chimiro AKADZIMWA) | 0 ÷ 10 Vdc, I <2mA |
| UH (status ON) | 12 ÷ 30 Vdc; Ini > 3mA |
| Kunyura ikozvino | 3mA (yega yega yega inoshanda) |
| Dziviriro | Nekuburikidza neTVS suppressors ye600 W/ms. |
CONFIGURATION OF FACTORY SETTINGS
| Yese DIP-inochinja mukati | DZIMA |
| Nhaurirano paramita yeModbus protocol: | 38400 8, N, 1 Kero 1 |
| Input status: | AKAREMERA |
| Digital sefa | 3ms |
| Totalizers | Kuverenga kusvika pakuwedzera |
| Channel 5 pa10 kHz | Yakaremara |
| Modbus latency nguva | 5ms |
Modbus CONNECTION RULES
- Isa ma module muDIN njanji (120 max)
- Batanidza mamodule ari kure uchishandisa tambo dzehurefu hwakakodzera. Tafura inotevera inoratidza kureba kwetambo data:
-Bhasi kureba: kureba kweiyo Modbus network zvinoenderana neBaud Rate. Uhwu ndihwo hurefu hwetambo dzinobatanidza ma modules maviri ari kure (ona Dhiagiramu 1).
-Kutora kureba: kureba kwakareba kwe2 m (ona Dhizaini 1).
Mufananidzo 1
| Kureba kwebhazi | Derivation urefu |
| 1200 m | 2 m |
Kuti uite zvakanyanya, zvinokurudzirwa kushandisa tambo dzakavharirwa dzakakosha seBELDEN 9841.
IDC10 CONNECTOR
Magetsi uye Modbus interface inowanikwa uchishandisa Seneca DIN njanji bhazi, kuburikidza IDC10 rear connector, kana Z-PC-DINAL2-17.5 accessory.
Rear Connector (IDC 10)
Zvinoreva mapini akasiyana paIDC10 chinongedzo chinoratidzwa mumufananidzo kana iwe uchida kupa masaini zvakananga kuburikidza nawo.
KUGADZIRA DIP-Switchches
Nzvimbo yeDIP-swichi inotsanangura iyo Modbus kutaurirana paramita yemodule: Kero uye Baud Rate.
Tafura inotevera inoratidza kukosha kweBaud Rate uye Kero zvinoenderana nekumisikidzwa kweDIP switch:
| DIP-Chinja chimiro | |||||
| SW1 POSITION | BAUD RATE |
SW1 POSITION | ADDRESS | POSITION | TERMINATOR |
| 1 2 3 4 5 6 7 8 | 3 4 5 6 7 8 | 10 | |||
| ————– |
9600 |  |
#1 | |
Yakaremara |
| ———— |
19200 | |
#2 | |
Yagoneswa |
| ———– |
38400 | ••••••• | #… | ||
| ———– |
57600 | |
#63 | ||
| ——- |
Kubva EEPROM |
|
Kubva EEPROM |
||
Cherechedza: Kana DIP ichichinja 3 kusvika 8 ZVINODZIMWA, marongero ekutaurirana anotorwa kubva kuchirongwa (EEPROM).
Cherechedza 2: Mutsetse weRS485 unofanirwa kugumiswa chete pamagumo etambo yekutaurirana.
Izvo zvigadziro zve-dip-switches zvinofanira kuwirirana nezvigadziro pane zvinyorwa.
Tsananguro yemarejista inowanikwa muUSER MANUAL.
KUKUNGAMIRIRA KWEMAGETSI
Magetsi:
Iyo yepamusoro miganho haifanirwe kudarika kuitira kudzivirira kukuvadza kwakakomba kune module.
Kana simba rekupa simba risina kudzivirirwa kubva pakuremerwa, fuse yekuchengetedza inofanira kuiswa mumutsetse wemagetsi ine kukosha kwakakodzera kune izvo mamiriro ezvinhu anoda.
Modbus RS485
Kubatanidza kweRS485 kutaurirana uchishandisa iyo MODBUS master system seimwe nzira kune Z-PC-DINx bhazi.
NB: Chiratidzo cheRS485 yekubatanidza polarity haina kumira uye mune mamwe maturusi anogona kudzoserwa.
ZVINHU
INPUT SETTINGS:
Default settings:
Kupinza #1: 0 – 100 Hz (16BIT)
Kupinza #2: 0 – 100 Hz (16BIT)
Kupinza #3: 0 – 100 Hz (16BIT)
Kupinza #4: 0 – 100 Hz (16BIT)
Kupinza #5: 0 – 100 Hz (16BIT)
Input #5 inogona kusetwa seyakazara:
Kupinza #5: 0 – 10 kHz (32BIT)
ATTENTION
Iyo yepamusoro magetsi ekupa miganho haifanirwe kudarika, nekuti izvi zvinogona kukonzera kukuvadza kwakakomba kune module. Dzima module usati wabatanidza zvinopinda uye zvinobuda.
Kusangana ne electromagnetic immunity zvinodiwa:
- shandisa tambo dzechiratidzo dzakadzivirirwa;
- batanidza nhovo kune yakasarudzika chiridzwa pasi system;
- fuse ine MAX. chiyero che0,5 A chinofanira kuiswa pedyo nemodule.
- patsanura tambo dzakadzivirirwa kubva kune dzimwe tambo dzinoshandiswa kuisirwa magetsi (mainverters, mota, mahovhoni ekupinza, nezvimwewo…).
- ita shuwa kuti module haina kupihwa ine voltage yakakwirira kudarika iyo inoratidzwa mune zvinyorwa zvehutano kuitira kuti irege kuikuvadza.
SENECA srl; Via Austria, 26 - 35127 - PADOVA - ITALY;
Tel. +39.049.8705359 -
Fax +39.049.8706287
CONTACT INFORMATION
Tsigiro yehunyanzvi
support@seneca.it
Product information
sales@seneca.it
Gwaro iri ndiro reSENECA srl. Makopi uye kudhirowa zvinorambidzwa kunze kwekunge kwabvumidzwa. Zviri mugwaro iri zvinoenderana nezvinotsanangurwa zvigadzirwa uye matekinoroji. Yakanyorwa data inogona kugadziridzwa kana kuwedzerwa kune tekinoroji uye / kana kutengesa zvinangwa.
Zvinyorwa / Zvishandiso
 |
SENECA ZD-IN Digital Input kana Output Modules [pdf] Bhuku reMirayiridzo ZD-IN, Digital Input kana Output Modules, ZD-IN Digital Input kana Output Modules |
