QUICK START GUIDE T5F01

V2S plus Smart Interactive ebute

Ibẹrẹ kiakia

1. Oluka NFC (aṣayan)
   Fun kika awọn kaadi NFC, bi awọn kaadi iṣootọ.
2. Itẹwe
   Fun awọn owo titẹ sita nigbati ẹrọ ba wa ni titan.
3. Bọtini ọlọjẹ/LED (aṣayan)
   Short press to enable barcode scanning function,
4. Iru-C
   Fun gbigba agbara ẹrọ ati n ṣatunṣe aṣiṣe idagbasoke.
5. Micro 50 Card Slot/Nano SIM Card Slot
   Fun fifi kaadi Micro SD sori ẹrọ ati kaadi SIM Nano.
6. Kamẹra Iwaju (aṣayan)
   Fun apejọ fidio, tabi fọto/yiya fidio.
7. Bọtini agbara
   Tẹ kukuru: ji iboju, tiipa iboju naa.
   Long press: long press for 2-3 seconds to turn on the device when it is off. Long press for 2-3 seconds to select to power off or reboot the device when it is on. Long press for 11 seconds to reboot a device when the system is frozen.
8. Bọtini iwọn didun
   Fun atunṣe iwọn didun.
9. Scanner (iyan)
   Fun kooduopo data gbigba.
10. Kamẹra ẹhin
    Fun fọtoyiya ati kika koodu 1D/2D ni iyara.
11. Pogo pin
    Fun sisopọ ẹya ẹrọ iwoye kooduopo, tabi jojolo fun ibaraẹnisọrọ ati gbigba agbara.
12. Awọn iho kaadi PSAM (aṣayan)
    Fun fifi awọn kaadi PSAM sori ẹrọ.

Awọn ilana titẹ sita

Ẹrọ yii le ṣaja iwe-aṣẹ igbona 80mm tabi aami iwe yipo, ati aami dudu tun jẹ iyan.
The paper roll spec is 79 plus/minus 0.5 * mm * emptyset50mm
Please press to open the printer (see ①). Please do not force open the printer to avoid printhead gear wear;
Load the paper into the printer and pull some paper outside the cutter following the direction shown in 2;
Close the cover to complete paper loading (see 3).
Notice: If the printer prints blank paper, please check whether the paper roll has been loaded in the correct direction.
Tips: To clean a label printhead, it is recommended to use a cotton swab dipped in alcohol or a alcohol prep pad (75% isopropyl alcohol) to wipe the printhead.

Tabili fun Awọn orukọ ati Idanimọ akoonu ti Majele ati Awọn nkan eewu ninu Ọja yii

Orukọ apakan	Awọn nkan ti o majele tabi eewu ati Awọn eroja
	Pb	Hg	Cd	Cr (VI)	PBB	PBDE	DEHP	DBP	BBP	DIBP
Circuit Board paati	X	0	0	0	0	0	0	0	0	0
Apakan igbekale	0	0	0	0	0	0	0	0	0	0
Ohun elo apoti .	0	0	0	0	0	0	0	0	0	0

O: tọkasi pe akoonu ti majele ati nkan ti o lewu ni gbogbo awọn ohun elo isokan ti paati wa ni isalẹ opin ti a sọ ni SJ / T 11363-2006.
X: indicates that the content of the toxic and hazardous substance in at least one homogeneous material of the component exceeds the limit stipulated in Sj / T * 11363 – 2006 However, as for the reason, because there is no mature and replaceable technology in the industry at present.
Awọn ọja ti o ti de tabi ti kọja igbesi aye iṣẹ aabo ayika yẹ ki o tunlo ati tun lo ni ibamu si Awọn Ilana lori Iṣakoso ati Isakoso ti Awọn ọja Alaye Itanna, ati pe ko yẹ ki o sọnu laileto.

Awọn akiyesi
Ikilọ Abo
So plug AC pọ mọ iho AC ti o baamu si titẹ sii ti a samisi ti ohun ti nmu badọgba agbara;
Lati yago fun ipalara, awọn eniyan laigba aṣẹ ko gbọdọ ṣii ohun ti nmu badọgba agbara;
Eyi jẹ ọja Kilasi A. Ọja yii le fa kikọlu redio ni awọn agbegbe gbigbe.
Ni ọran naa, olumulo le nilo lati gbe awọn igbese to peye lodi si kikọlu.
Rirọpo batiri:
1.Explosion danger may arise if replacing with the wrong battery
2.The replaced battery shall be disposed of by maintenance personnel, and please do not throw it into fire

Awọn Itọsọna Aabo pataki
Maṣe fi sii tabi lo ẹrọ naa lakoko iji manamana lati yago fun awọn ewu ti o pọju ti mọnamọna monomono;
Jọwọ pa agbara naa lẹsẹkẹsẹ ti o ba ṣe akiyesi oorun ajeji, ooru tabi ẹfin;
Igi iwe jẹ didasilẹ, jọwọ maṣe fi ọwọ kan

Awọn imọran
Ma ṣe lo ebute nitosi omi tabi ọrinrin lati ṣe idiwọ omi lati ja bo sinu ebute naa;
Ma ṣe lo ebute naa ni otutu pupọ tabi awọn agbegbe ti o gbona, gẹgẹbi ina tabi awọn siga ti o tan;
Maṣe ju silẹ, jabọ tabi tẹ ẹrọ naa;
Use the terminal in a clean and dust-free environment if possible to prevent small items from falling into the terminal; Please do not use the terminal near medical equipment without permission.

Gbólóhùn
Ile-iṣẹ ko gba awọn ojuse fun awọn iṣe wọnyi:
Damages caused by use and maintenance without complying with the conditions specified in this guide; The Company will not assume any responsibilities for the damages or problems caused by optional items or consumables (rather than the initial products or approved products of the Company). The customer is not entitled to change or modify the product without our consent. The product’s operating system supports official system up-dates, but if you change the operating system into a third party ROM system or alter the system files nipasẹ fifọ eto, o le fa aisedeede eto ati awọn ewu aabo ati awọn irokeke.

AlAIgBA
As a result of product upgrading, some details in this document may not match the product, and the actual product shall govern. The Company reserves the right of interpretation of this document. The Company also reserves the right toalter this specification without prior notice.

Iṣọkan ilana ilana EU
Hereby, Shanghai Sunmi Technology Co., Ltd. declares that this device is in compliance with the essential requirements and other relevant provisions of Radio Equipment Directive 2014/53/EU. The description of accessories and components, including software, which allow the radio equipment to operate as intended, can be obtained in the full text of the EU declaration of conformity is available at the following internet address: https://developer.sunmi.com/docs/read/en-US/maaeghjk480

Awọn ihamọ LILO
This product may be used in the following European member states subject to the following restrictions. For products that operate in the frequency band 5150-5350MHz and 5945-6425 MHz (If the product support 6e), wireless access systems (WAS), including radio local area networks (RLANs), shall be restricted to indoor use.
EU Representative: SUNMI France SAS 186, avenue Thiers, 69006 Lyon, France
Aami yii tumọ si pe o jẹ eewọ lati sọ ọja ti o wa pẹlu idoti ile deede. Ni ipari igbesi aye ọja, ohun elo egbin yẹ ki o mu lọ si awọn aaye ikojọpọ ti a yan, da pada si olupin kaakiri nigba rira ọja tuntun, tabi kan si aṣoju alaṣẹ agbegbe rẹ fun alaye alaye lori atunlo WEEE.

	AT	BE	BG	HR	CY	CZ	. DK
	EE	Fl	FR	DE	EL	HU	IE
	IT	LV	LT	LU	MT	NL	PL
	PT	PO	SK	SI	ES	SE	UK(NI)
	IS	LI	RARA	CH	TR
Note: In all EU member states, operation of 5150-5350MHz and 5945-6425MHz (If the product support 6e) restricted to indoor use only.

Gbólóhùn Ìfihàn RF (SAR)
Ohun elo yii ni ibamu pẹlu awọn opin ifihan itọka EU ti a ṣeto fun agbegbe ti a ko ṣakoso.
Jọwọ tọka si itọnisọna lori SUNMI webojula fun pato iye.

Igbohunsafẹfẹ ati Agbara fun EU:
Jọwọ tọka si itọnisọna lori SUNMI webojula fun pato iye.

Ẹgbẹ	Igbohunsafẹfẹ	Agbara (dBm)
GSM900	880-915	34
DCS1800	1710-1785	31
Ẹgbẹ WCDMA I	1920-1980	24
WCDMA Band VIII	880-915	24
Ẹgbẹ LTE 1	1920-1980	25
Ẹgbẹ LTE 3	1710-1785	25
Ẹgbẹ LTE 7	2500-2570	24.5
Ẹgbẹ LTE 8	880-915	25
Ẹgbẹ LTE 20	832-862	25
Ẹgbẹ LTE 28	703-748	23
Ẹgbẹ LTE 38	2570-2620	25
Ẹgbẹ LTE 40	2300-2400	25
BT	2402-2480	9.39
BLE	2402-2480	5.34
WLAN	2412-2472	17.55
WLAN	5150-5350	15.98
WLAN	5470-5725	15.54
WLAN	5725-5850	13.02
GNSS	1559-1610
NFC	13.56	42.45dBμV / m @ 10m

Awọn alaye ibamu ISED Canada
This device complies with ISED Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this devi must accept any interference, including interference that may cause undesired operation of the device. the device for operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems;

Awọn alaye ibamu FCC

Ẹrọ yii ni ibamu pẹlu Apá 15 ti Awọn ofin FCC. Isẹ jẹ koko ọrọ si awọn ipo meji wọnyi: (1) Ẹrọ yii le ma fa kikọlu ipalara, ati (2) ẹrọ yii gbọdọ gba kikọlu eyikeyi ti o gba, pẹlu kikọlu ti o le fa iṣẹ ti ko fẹ.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient tabi tun eriali gbigba pada.
• Mu iyatọ pọ si laarin ẹrọ ati olugba.
• So ohun elo pọ si ọna iṣan lori Circuit ti o yatọ si eyiti olugba ti sopọ.
• Kan si alagbawo oniṣowo tabi redio ti o ni iriri / onimọ-ẹrọ TV fun iranlọwọ.

Išọra: A kilọ fun olumulo pe awọn iyipada tabi awọn iyipada ti ko fọwọsi ni pato nipasẹ ẹgbẹ ti o ni iduro fun ibamu le sọ aṣẹ olumulo di ofo lati ṣiṣẹ ohun elo naa.

Ṣe iṣelọpọ
Shanghai Sunmi Technology Co., Ltd.
Yara 505, KIC Plaza, No.388 Song Hu Road, Yang Pu DISTRICT, Shanghai, China

Awọn iwe aṣẹ / Awọn orisun

Sunmi V2S plus Smart Interactive Terminal [pdf] Afowoyi olumulo T5F01N, 2AH25T5F01N, V2S plus Smart Interactive Terminal, V2S plus, Smart Interactive Terminal, Interactive Terminal, Terminal

Awọn itọkasi

• Itọsọna olumulo