QUICK START GUIDE T5F01

V2S plus Smart Ynteraktive Terminal

Quick Start

1. NFC Reader (opsjoneel)
   Foar it lêzen fan NFC-kaarten, lykas loyaliteitskaarten.
2. Printer
   Foar it printsjen fan kwitânsjes as it apparaat oan is.
3. Scanknop/LED (opsjoneel)
   Short press to enable barcode scanning function,
4. Type-C
   Foar apparaat opladen en ûntwikkelders debuggen.
5. Micro 50 Card Slot/Nano SIM Card Slot
   Foar it ynstallearjen fan de Micro SD card en Nano SIM card.
6. Foarste kamera (opsjoneel)
   Foar fideokonferinsje, as foto / fideo nimme.
7. Power knop
   Koarte parse: meitsje it skerm wekker, beskoattelje it skerm.
   Long press: long press for 2-3 seconds to turn on the device when it is off. Long press for 2-3 seconds to select to power off or reboot the device when it is on. Long press for 11 seconds to reboot a device when the system is frozen.
8. Volume knop
   Foar folume oanpassing.
9. Scanner (opsjoneel)
   Foar it sammeljen fan barcodegegevens.
10. Rear Kamera
    Foar foto nimme en fluch 1D / 2D barcode lêzen.
11. Pogo pin
    Foar it ferbinen fan in barcode skennen accessoire, of in cradle foar kommunikaasje en opladen.
12. PSAM Card Slots (opsjoneel)
    Foar it ynstallearjen fan de PSAM kaarten.

Ynstruksjes foar printsjen

Dit apparaat kin laden in 80mm termyske ûntfangst of label papier roll, en swart label is ek opsjoneel.
The paper roll spec is 79 plus/minus 0.5 * mm * emptyset50mm
Please press to open the printer (see ①). Please do not force open the printer to avoid printhead gear wear;
Load the paper into the printer and pull some paper outside the cutter following the direction shown in 2;
Close the cover to complete paper loading (see 3).
Notice: If the printer prints blank paper, please check whether the paper roll has been loaded in the correct direction.
Tips: To clean a label printhead, it is recommended to use a cotton swab dipped in alcohol or a alcohol prep pad (75% isopropyl alcohol) to wipe the printhead.

Tabel foar nammen en ynhâldidentifikaasje fan giftige en gefaarlike stoffen yn dit produkt

Part Namme	Giftige of gefaarlike stoffen en eleminten
	Pb	Hg	Cd	Cr (VI)	PBB	PBDE	DEHP	DBP	BBP	DIBP
Circuit Board Component	X	0	0	0	0	0	0	0	0	0
Strukturele komponint	0	0	0	0	0	0	0	0	0	0
Packaging Component .	0	0	0	0	0	0	0	0	0	0

O: jout oan dat de ynhâld fan 'e giftige en gefaarlike stof yn alle homogene materialen fan' e komponint ûnder de limyt is spesifisearre yn SJ / T 11363-2006.
X: indicates that the content of the toxic and hazardous substance in at least one homogeneous material of the component exceeds the limit stipulated in Sj / T * 11363 – 2006 However, as for the reason, because there is no mature and replaceable technology in the industry at present.
De produkten dy't de libbensdoer fan miljeubeskerming hawwe berikt of grutter moatte wurde recycled en opnij brûkt neffens de Regeljouwing oer kontrôle en behear fan produkten foar elektroanyske ynformaasje, en moatte net willekeurich wurde fuorthelle.

Meidielings
Feiligens warskôging
Ferbine de AC-stekker oan 'e AC-socket dy't oerienkomt mei de markearre ynfier fan' e stroomadapter;
Om blessueres te foarkommen, moatte net autorisearre persoanen de stroomadapter net iepenje;
Dit is in klasse A-produkt. Dit produkt kin radio-ynterferinsje yn libbensomjouwings feroarsaakje.
Yn dat gefal kin de brûker ferplicht wurde om adekwate maatregels te nimmen tsjin ynterferinsje.
Batterij ferfanging:
1.Explosion danger may arise if replacing with the wrong battery
2.The replaced battery shall be disposed of by maintenance personnel, and please do not throw it into fire

Wichtige Safety Ynstruksjes
Ynstallearje of brûk it apparaat net tidens bliksemstoarmen om de potinsjele risiko's fan bliksemskok te foarkommen;
Skeakelje asjebleaft de krêft fuortendaliks út as jo in abnormale geur, waarmte of reek fernimme;
De papiersnijder is skerp, asjebleaft net oanreitsje

Suggestjes
Brûk de terminal net tichtby wetter of focht om te foarkommen dat flüssigens yn 'e terminal falle;
Brûk de terminal net yn ekstreem kâlde of hjitte omjouwings, lykas tichtby flammen of oanstutsen sigaretten;
Lit it apparaat net falle, goaie of bûge;
Use the terminal in a clean and dust-free environment if possible to prevent small items from falling into the terminal; Please do not use the terminal near medical equipment without permission.

Utspraken
It bedriuw nimt gjin ferantwurdlikens foar de folgjende aksjes:
Damages caused by use and maintenance without complying with the conditions specified in this guide; The Company will not assume any responsibilities for the damages or problems caused by optional items or consumables (rather than the initial products or approved products of the Company). The customer is not entitled to change or modify the product without our consent. The product’s operating system supports official system up-dates, but if you change the operating system into a third party ROM system or alter the system files troch systeem cracking, it kin feroarsaakje systeem ynstabiliteit en feiligens risiko 's en bedrigings.

Disclaimer
As a result of product upgrading, some details in this document may not match the product, and the actual product shall govern. The Company reserves the right of interpretation of this document. The Company also reserves the right toalter this specification without prior notice.

Konformaasje fan EU-regeljouwing
Hereby, Shanghai Sunmi Technology Co., Ltd. declares that this device is in compliance with the essential requirements and other relevant provisions of Radio Equipment Directive 2014/53/EU. The description of accessories and components, including software, which allow the radio equipment to operate as intended, can be obtained in the full text of the EU declaration of conformity is available at the following internet address: https://developer.sunmi.com/docs/read/en-US/maaeghjk480

BEPERKINGEN FAN GEBRUK
This product may be used in the following European member states subject to the following restrictions. For products that operate in the frequency band 5150-5350MHz and 5945-6425 MHz (If the product support 6e), wireless access systems (WAS), including radio local area networks (RLANs), shall be restricted to indoor use.
EU Representative: SUNMI France SAS 186, avenue Thiers, 69006 Lyon, France
Dit symboal betsjut dat it ferbean is om it produkt te ferwiderjen mei gewoan húshâldlik ôffal. Oan 'e ein fan' e produktlibbenssyklus moat ôffalapparatuer wurde nommen nei oanwiisde sammelpunten, weromjûn oan 'e distributeur by it keapjen fan in nij produkt, of nim kontakt op mei jo fertsjintwurdiger fan pleatslike autoriteiten foar detaillearre ynformaasje oer WEEE-recycling.

	AT	BE	BG	HR	CY	CZ	. DK
	EE	Fl	FR	DE	EL	HU	IE
	IT	LV	LT	LU	MT	NL	PL
	PT	PO	SK	SI	ES	SE	UK(NI)
	IS	LI	NEE	CH	TR
Note: In all EU member states, operation of 5150-5350MHz and 5945-6425MHz (If the product support 6e) restricted to indoor use only.

RF Exposure Statement (SAR)
Dizze apparatuer foldocht oan EU -limiten foar bleatstelling oan straling foar in net kontroleare omjouwing.
Sjoch de ynstruksje op SUNMI webside foar spesifike wearden.

Frekwinsje en macht foar EU:
Sjoch de ynstruksje op SUNMI webside foar spesifike wearden.

Band	Frekwinsje	Power (dBm)
GSM900	880-915	34
DCS1800	1710-1785	31
WCDMA Band I	1920-1980	24
WCDMA Band VIII	880-915	24
LTE -band 1	1920-1980	25
LTE -band 3	1710-1785	25
LTE -band 7	2500-2570	24.5
LTE -band 8	880-915	25
LTE -band 20	832-862	25
LTE -band 28	703-748	23
LTE -band 38	2570-2620	25
LTE -band 40	2300-2400	25
BT	2402-2480	9.39
BLE	2402-2480	5.34
WLAN	2412-2472	17.55
WLAN	5150-5350	15.98
WLAN	5470-5725	15.54
WLAN	5725-5850	13.02
GNSS	1559-1610
NFC	13.56	42.45dBμV/m@10m

ISED Kanada neilibjen ferklearrings
This device complies with ISED Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this devi must accept any interference, including interference that may cause undesired operation of the device. the device for operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems;

FCC konformiteitsferklearrings

Dit apparaat foldocht oan diel 15 fan 'e FCC-regels. Operaasje is ûnderwurpen oan de folgjende twa betingsten: (1) dit apparaat meie gjin skealike ynterferinsje feroarsaakje, en (2) dit apparaat moat alle ûntfangen ynterferinsje akseptearje, ynklusyf ynterferinsje dy't ûngewoane operaasje feroarsaakje kin.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorientearje of ferpleatse de ûntfangende antenne.
• Fergrutsje de skieding tusken de apparatuer en ûntfanger.
• Ferbine de apparatuer yn in outlet op in circuit oars as dat wêrmei de ûntfanger is ferbûn.
• Rieplachtsje de dealer of in betûfte radio / TV technikus foar help.

Foarsichtich: De brûker wurdt warskôge dat feroarings of oanpassingen dy't net eksplisyt goedkard binne troch de partij dy't ferantwurdlik is foar neilibjen, de autoriteit fan 'e brûker om de apparatuer te betsjinjen ûnjildige kinne.

Manufacture
Shanghai Sunmi Technology Co., Ltd.
Keamer 505, KIC Plaza, No.388 Song Hu Road, Yang Pu District, Shanghai, Sina

Dokuminten / Resources

Sunmi V2S plus Smart Ynteraktive Terminal [pdf] Brûkershânlieding T5F01N, 2AH25T5F01N, V2S plus Smart Ynteraktive Terminal, V2S plus, Smart Ynteraktive Terminal, Ynteraktive Terminal, Terminal

Referinsjes

• User Manual