லோச்சின்வர் CMP58 CPM-SP வரம்பை உள்ளடக்கியது.

பயனர் வழிகாட்டி
பொது
Lochinvar CPM கொதிகலன்கள் பின்வரும் ஃப்ளூ வகைகளில் பயன்படுத்த சான்றளிக்கப்பட்டுள்ளன:

அனைத்து நிறுவல்களும் தேவைகளுக்கு இணங்க வேண்டும்:
1. For appliances up to 70kW net input- BS5440-1:2023- Flueing and ventilation for gas appliances of rated input not exceeding 70 kW net (1st, 2nd and 3rd family gases). Specification for installation of gas appliances to chimneys and for maintenance of chimneys.
a. Refer to drawing 1 and table 1 for details of terminal locations.
2. For appliances over 70kW net input- IGEM/UP/10 Edition 4 +A: 2016 – Installation of flued gas appliances in industrial and commercial premises, specific attention should be paid to the following sections.
a. Refer to drawing 1 and table 1 for details of terminal locations.
b. Horizontal terminations shall be located according to the minimum distances given in table 1, and subject to the risk assessment criteria shown in table 2.
c. Horizontal flue terminations (other than for fan dilution systems) must not be installed for any single appliance or group of appliances with a total nett input exceeding 333kW net heat input.
d. For any single appliance or group of appliances with a total net heat input exceeding 333 kW, the general requirements of IGEM/UP/10 Edition 4 +A: 2016 shall apply and approval must be sought from the Local Authority prior to commencement of the installation.
3. 333kW நிகர உள்ளீட்டை விட அதிகமான நிறுவல்களுக்கான சுத்தமான காற்று சட்டம்.
BS5440-1-2023 இன் படி 1 பாய்லர் முனைய இடங்களை வரைதல்



IGEM/UP/10 பதிப்பு 4 +A படி 2 பாய்லர் முனைய இடங்களை வரைதல்: 2016


*CPM175 நிறுத்தம் குறித்த வழிகாட்டுதலுக்கு லோச்சின்வர் தொழில்நுட்ப ஆதரவைத் தொடர்பு கொள்ளவும்.
The table above should be used in conjunction with the following notes:
- Distances shown ensure the boiler will operate without problems under most conditions, these distances can be reduced in certain circumstances
- The above should be read in conjunction with the latest edition of BS5440-1 and IGEM UP10
- For boiler installation above 333kW nett input the table above should not be used, these installations are covered by the clean air act and must comply with its requirements in full, contact your local environmental health team for further guidance
மேலும் வழிகாட்டுதலுக்கு லோச்சின்வர் தொழில்நுட்ப ஆதரவைத் தொடர்பு கொள்ளவும்.
Table 4 risk assesment
கீழே உள்ள அட்டவணை IGEMUP10 இலிருந்து ஒரு பகுதி மற்றும் அந்த ஆவணத்துடன் இணைந்து பயன்படுத்தப்பட வேண்டும்
IGEM/UP/10 பதிப்பு 4 +A: 2016 பிரிவு 8 இல் உள்ள தேவைகளுக்கு மேலதிகமாக பிரிவு 8.7.3.3 மற்றும் படம் 7 இன் கீழ் பின்வரும் இடர் மதிப்பீடு கிடைமட்ட ஃப்ளூகளை நிலைநிறுத்துவதற்கான வழிகாட்டுதலை வழங்குகிறது. பணி தொடங்கும் முன் இந்தப் படிவம் பூர்த்தி செய்யப்பட்டு, இடர் மதிப்பீட்டை மேற்கொள்ளத் தகுதியுள்ள ஒருவரால் மேற்கொள்ளப்பட வேண்டும்.

கான்சென்ட்ரிக் ஃப்ளூ சிஸ்டம்ஸ்


சட்டவிரோத முனைய இடத்தை சரிசெய்ய ப்ளூம் கிட்டைப் பயன்படுத்தக்கூடாது.

CPM175 உடன் கான்சென்ட்ரிக் ஃப்ளூவைப் பயன்படுத்த முடியாது.

கணக்கிடப்பட்ட மொத்த அமைப்பு மின்தடை 200pa க்கும் குறைவாக இருக்க வேண்டும்.
ட்வின்-பைப் ஃப்ளூ சிஸ்டம்ஸ் வகை C53




வழக்கமான (எக்ஸ்ஹாஸ்ட் மட்டும்) ஃப்ளூ சிஸ்டம்ஸ் வகை B23



லோச்சின்வர் வகை C63 ஆல் வழங்கப்படாத ஃப்ளூவைப் பயன்படுத்தும் ஃப்ளூ அமைப்புகள்
பொதுவாக, பாய்லர்கள் அவற்றின் சொந்த நோக்கத்திற்காக வழங்கப்பட்ட கான்சென்ட்ரிக் அல்லது ட்வின் பைப் ஃப்ளூ அமைப்புகளுடன் சான்றளிக்கப்படுகின்றன, C63 சான்றளிக்கப்பட்ட உபகரணங்கள் பாய்லரை நிறுவும் போது நிறுவி மற்ற ஃப்ளூ அமைப்புகளைப் பயன்படுத்த அனுமதிக்கின்றன, இருப்பினும், அவை கீழே உள்ள அட்டவணையின்படி பொருத்தமான குறைந்தபட்ச தரத்தில் இருக்க வேண்டும்.

அலுமினியம் ஃப்ளூ பைப்பை இந்த சாதனத்தில் பயன்படுத்தக்கூடாது, ஏனெனில் இது வெப்பப் பரிமாற்றியின் முன்கூட்டிய செயலிழப்புக்கு வழிவகுக்கும் மற்றும் உத்தரவாதத்தை செல்லாததாக்கும்.
பொதுவான ஃப்ளூ அமைப்புகள்
Lochinvar ஒரு PP பொதுவான ஃப்ளூ ஹெடரை வழங்க முடியும் www.lochinvar.ltd.uk
மாற்றாக, பக்கம் 13 இல் காட்டப்பட்டுள்ள விவரக்குறிப்புகள் மற்றும் கீழே உள்ள அட்டவணையில் உள்ள தகவல்களைப் பயன்படுத்தி, C63 என்ற புகைபோக்கி பதவியின் கீழ் ஒரு தனி புகைபோக்கி அமைப்பை வடிவமைத்து வழங்க நிறுவி ஒரு புகைபோக்கி நிறுவல் நிபுணரைப் பயன்படுத்தலாம்.
C63 வகை புகைபோக்கியைப் பயன்படுத்தும் எந்தவொரு நிறுவல்களும் உள்ளூர் கட்டிடம் அல்லது திட்டமிடல் விதிமுறைகளுக்கு இணங்க வடிவமைக்கப்பட்டு நிறுவப்பட வேண்டும், ஆனால் இந்த அமைப்புகள் லோச்சின்வரால் வழங்கப்படாத புகைபோக்கி அமைப்பைப் பயன்படுத்துவதால், இந்த வகை புகைபோக்கி அமைப்பின் வடிவமைப்பு குறித்து லோச்சின்வர் கருத்து தெரிவிக்கவோ / ஆலோசனை வழங்கவோ அல்லது ஆதரவை வழங்கவோ முடியாது. அத்தகைய புகைபோக்கி அமைப்பை வடிவமைக்க, நிறுவி/ஒப்பந்ததாரர் தனி புகைபோக்கி அமைப்பின் வடிவமைப்பு மற்றும் நிறுவலுக்குப் பொறுப்பான ஒரு சிறப்பு புகைபோக்கி சப்ளையரை அணுக வேண்டும். C63 வகை புகைபோக்கி அமைப்பை வடிவமைக்கும்போது, பாய்லருடன் வழங்கப்பட்ட நிறுவல் கையேட்டில் உள்ள வழிமுறைகளை கணக்கில் எடுத்துக்கொள்ள வேண்டும். குறிப்பிட்ட அலகுகளுக்கான அழுத்தம் இழப்பு புள்ளிவிவரங்களை லோச்சின்வர் வழங்கும், ஆனால் அதைத் தவிர, பொதுவான புகைபோக்கி கோரிக்கைகளில் லோச்சின்வர் ஆதரவை வழங்க முடியாது, ஏனெனில் புகைபோக்கி சான்றிதழ் பக்கம் 2 இல் உள்ள அட்டவணையில் சான்றளிக்கப்பட்ட வகைகளுக்கு மட்டுமே. புகைபோக்கி அமைப்பு வடிவமைப்பிற்கான எந்தப் பொறுப்பையும் லோச்சின்வர் ஏற்க முடியாது.

The CPM boiler range does not have an internal Non Return Valve (NRV) as such any flue must be designed on zero or negative pressure unless a suitable NRV is fitted and if necessary interlocked to the appliance. Non Return Valves are included with the Lochinvar common flue header
ஆர்டர் படிவம் மற்றும் குறிப்புகள்


விவரக்குறிப்புகள்
- Models covered: CMP58 CPM77 CPM96 CPM116 CPM146 CPM176 (Does not include CPM-SP range)
- Certified for use on flue categories: B23, C13, C33, C43, C53, C63, C83
அடிக்கடி கேட்கப்படும் கேள்விகள்
கே: நிறுவல்கள் என்ன தரநிலைகளுக்கு இணங்க வேண்டும்?
A: All installations should comply with BS5440-1:2023 for appliances up to 70kW net input. Refer to drawing 1 and table 1 for terminal locations.
ஆவணங்கள் / ஆதாரங்கள்
![]() |
லோச்சின்வர் CMP58 CPM-SP வரம்பை உள்ளடக்கியது. [pdf] பயனர் வழிகாட்டி CMP58, CPM77, CPM96, CPM116, CPM146, CPM176, CMP58 CPM-SP வரம்பை உள்ளடக்கியதா, CMP58, CPM-SP வரம்பை உள்ளடக்கியதா, CPM-SP வரம்பை உள்ளடக்கியதா, CPM-SP வரம்பு |




