Rialaitheoir Crios ZONEMIX4
“
Sonraíochtaí
- Supports up to 8 controllers per port
- Supports ONE audio input PER accessory port
- Supports up to 8 paging stations per port
- Maximum cable length per port: 100m – 500m depending on
gabhálais
Treoracha Úsáide Táirge
Step 1: Decide Port Wiring Layout
Decide if you need local audio inputs and allocate accessory
ports accordingly. One audio input can be used per port, while wall
controllers and paging stations can be connected to any port.
Step 2: Confirm Limits
Ensure you do not exceed the specified limits for cable length
and accessories per port as outlined in the provided table.
Step 3: Accessory Port Wiring
Follow the wiring guide provided for ZONEMIX and ZMPS wiring,
ensuring proper termination of cables to prevent signal
caimiléireacht.
Sreangú ZONEMIX AGUS ZMPS
Follow the T-568A wiring diagram for proper connections of
signal, paging audio, RS485, +24V DC, GND, and local input.
WP4R, WP10, WPVOL Wiring & WPBT Wiring
Follow the wiring instructions provided for each accessory port
to ensure correct connection of paging audio, RS485, +24V DC, GND,
and remote input.
Treoracha Foirceannadh
- Terminate the ZONEMIX accessory ports based on which ports you
use using the PORT TERM switches. - Cuir deireadh leis an accessory LAST RS485 ar an rith cábla calafoirt.
CCanna
Q: How many controllers can be connected per port?
A: The system supports up to 8 controllers per port.
Q: Can multiple wall panels and paging stations be connected on
the same accessory port?
A: Yes, multiple wall panels and paging stations can be
connected on the same accessory port.
“`
TREOIR WIRING
RÉAMHRÁ
Ceadaíonn na calafoirt cúlpháirtí ZONEMIX do nascadh painéil balla, stáisiúin glaoireachta agus foinsí ionchuir fuaime. Lean an treoir thíos le do thoil chun do chóras a shocrú.
eochair:
ZONEMIX 4
ZONEMIX 8
Wall Controllers Audio Sources
Tacaíonn suas le 8 rialtóir in aghaidh an chalafoirt. (féach leathanach 2 le haghaidh sonraí)
Tacaíonn ionchur fuaime AMHÁIN IN AGHAIDH port cúlpháirtí.
Supports up to 8 paging stations per port. (see page 2 for details) Note: Supports one active page at a time. Example setup: Lots of controllers, lots of paging stations and ONE audio input.
Tabhair faoi deara le do thoil go bhfuil cainéil ionchuir fuaime áitiúla calafoirt cúlpháirtí glasáilte go dtí an crios aschuir comhfhreagrach agus ní féidir ach ceann amháin a úsáid in aghaidh an chrios. Eg nascann ionchur áitiúil port Cúlpháirtí 1 le Crios 1. Mar sin féin, is féidir painéil balla iolracha agus stáisiúin glaoireachta a nascadh ar an gcalafort cúlpháirtí céanna.
australianmonitor.com.au
1
CÉIM 1: CÉIM A CHINNEADH AR Sreangú an Phoirt
Do you need local audio inputs?
Tá
Níl
Bain úsáid as calafort cúlpháirtí amháin in aghaidh an chrios. ie Port 1 go Crios 1, Calafort 2 go Crios 2 srl. Toisc go dteastaíonn a rith baile féin ó ionchur fuaime.
Only one audio input can be used per port. Wall controllers and paging stations can go on any port.
Use any port to any zone/s
CÉIM 2: DEIMHNIGH NACH BHFUIL TÚ TUAIRISCEÁN NÁ NA TEORAINNEACHA SEO A LEANAS
Maximum cable length per port Accessories per port Maximum Accessories in system
100m
8
130m
7
180m
6
24
250m
5
400m
4
500m
3
The maximum distances quoted in the table are due to DC current limitations. The paging stations and wall panels can be locally powered to increase the cable length to a maximum
of 500m. Please read the following additional document: Advanced accessory port wiring guide.
australianmonitor.com.au
2
CÉIM 3: Sreangú PORT SHEALACH
Wire the ZONEMIX and ZMPS paging stations as per the images below. · Category 5, 5e and 6 cabling supported. · T-568A wiring recommended. However, T-568B also supported.
ZONEMIX AND ZMPS WIRING 1
8
*T-568A wiring
1 2 3 4 5 6 7 8
Pin Colour 1 Green/White 2 Green 3 Orange/White 4 Blue 5 Blue/White 6 Orange 7 Brown/White 8 Brown
ZONEMIX
Signal Paging Audio + Paging Audio RS485 B +24V DC GND RS485 A Local Input + Local Input –
ZMPS
Sreangú Slabhraí DAISY ZMPS
ZONEMIX
Use an RJ45 splitter or terminal block if daisy chain wiring required
australianmonitor.com.au
3
CÉIM 3: Sreangú Port Cúnta (AR LEAN)
Wire the wall panels as per the images below. · Category 5, 5e and 6 cabling supported. · T-568A wiring recommended. However, T-568B also supported.
WP4R, WP10, WPVOL Sreangú
Sreangú WPBT
1
Paging Fuaime +
2
Fuaime Paging -
3
RS 485 A
4
+24V DC
5
GND
6
RS485 B.
7
Ionchur cianda +
8
Ionchur cianda -
*Unused if not daisy chaining
Sreangú slabhra Daisy
*Unused unless connecting to downstream ZMPS
Sreangú slabhra Daisy
australianmonitor.com.au
4
STEP 4: PORT TERMINATION DO NOT SKIP THIS STEP
The ZONEMIX uses the RS485 standard to communicate to wall panels and paging stations. RS485 requires that each end of the cable run is terminated to prevent signal corruption due to signal reflections in the cable. The Accessory Ports are grouped in Pairs. 1+2, 3+4, 5+6, 7+8. You must terminate the ZONEMIX and Accessories based on which ports you use.
1. Terminate the ZONEMIX accessory ports, as per the table, using the PORT TERM switches
SUÍOMH LASC TERMINAL PORT ACCESSORY
ONE PORT USED TERM BOTH PORTS USED TERM
Port 1 OR Port 2 used Port 3 OR Port 4 used
ON Port 1 AND Port 2 used OFF
ON
ON Port 3 AND Port 4 used OFF
Port 5 NÓ Port 6 a úsáidtear
ON Port 5 AND Port 6 used OFF
Port 7 NÓ Port 8 a úsáidtear
ON Port 7 AND Port 8 used OFF
2. Terminate the LAST RS485 accessory on the port cable run.
Foirceannadh stáisiún glaoireachta
Foirceannadh painéal balla
Examples:
ONE port used:
PORT TERM = ON
Terminate end points
BOTH Ports used:
PORT TERM = OFF
australianmonitor.com.au
5
CÉIM 5: WP4R, WP10 GPO Sreangú (ROGHNACH)
Tá 4 aschur ilchuspóireacha ag an WP10R agus WP3 araon ar féidir iad a rialú ó na cnaipí painéil balla chun feistí seachtracha cosúil le teilgeoirí a spreagadh.
Scéimre GPO
Is trasraitheoir bailithe oscailte é gach Aschur. Uasmhéid Voltage: 48V Uasmhéid doirteal Reatha: 250mA
Example: Relay Connection
24V
Internal Logic
OPG1
OPG2
OPG3
australianmonitor.com.au
GND 6
Doiciméid / Acmhainní
 |
ZONEMIX ZONEMIX4 Zone Controller [pdfTreoracha ZONEMIX4, ZONEMIX4 Zone Controller, Zone Controller, Controller |