ZONEMIX4 Zone Controller
“
Mga detalye
- Supports up to 8 controllers per port
- Supports ONE audio input PER accessory port
- Supports up to 8 paging stations per port
- Maximum cable length per port: 100m – 500m depending on
mga accessories
Mga Instruksyon sa Paggamit sa Produkto
Step 1: Decide Port Wiring Layout
Decide if you need local audio inputs and allocate accessory
ports accordingly. One audio input can be used per port, while wall
controllers and paging stations can be connected to any port.
Step 2: Confirm Limits
Ensure you do not exceed the specified limits for cable length
and accessories per port as outlined in the provided table.
Step 3: Accessory Port Wiring
Follow the wiring guide provided for ZONEMIX and ZMPS wiring,
ensuring proper termination of cables to prevent signal
korapsyon.
ZONEMIX UG ZMPS WIRING
Follow the T-568A wiring diagram for proper connections of
signal, paging audio, RS485, +24V DC, GND, and local input.
WP4R, WP10, WPVOL Wiring & WPBT Wiring
Follow the wiring instructions provided for each accessory port
to ensure correct connection of paging audio, RS485, +24V DC, GND,
and remote input.
Mga Instruksyon sa Pagtapos
- Terminate the ZONEMIX accessory ports based on which ports you
use using the PORT TERM switches. - Tapuson ang KATAPUSAN nga RS485 accessory sa port cable run.
FAQ
Q: How many controllers can be connected per port?
A: The system supports up to 8 controllers per port.
Q: Can multiple wall panels and paging stations be connected on
the same accessory port?
A: Yes, multiple wall panels and paging stations can be
connected on the same accessory port.
“`
GIYA SA WIRING
PASIUNA
Ang ZONEMIX accessory ports nagtugot sa koneksyon sa mga wall panel, paging station ug audio input sources. Palihug sunda ang giya sa ubos aron ma-set up ang imong sistema.
yawe:
ZONEMIX 4
ZONEMIX 8
Wall Controllers Audio Sources
Nagsuporta hangtod sa 8 nga mga controller matag pantalan. (tan-awa ang pahina 2 para sa mga detalye)
Nagsuporta sa ONE audio input KADA accessory port.
Supports up to 8 paging stations per port. (see page 2 for details) Note: Supports one active page at a time. Example setup: Lots of controllers, lots of paging stations and ONE audio input.
Palihug timan-i nga ang accessory port nga lokal nga audio input channels gi-lock sa katumbas nga output zone ug usa ra ang magamit matag zone. Eg Accessory port 1 lokal nga input nagkonektar sa Zone 1. Apan, daghang mga wall panel ug paging station mahimong makonektar sa samang accessory port.
australianmonitor.com.au
1
LAKANG 1: DESISYON ANG PORT WIRING LAYOUT
Do you need local audio inputs?
Oo
Dili
Gamit ug usa ka accessory port kada zone. ie Port 1 ngadto sa Zone 1, Port 2 ngadto sa Zone 2 ug uban pa. Kay ang mga audio input nagkinahanglan sa ilang kaugalingong home run.
Only one audio input can be used per port. Wall controllers and paging stations can go on any port.
Use any port to any zone/s
LAKANG 2: KUMPIRMA NGA DILI KA MOLABAW SA MASUNOD NGA LIMITASYON
Maximum cable length per port Accessories per port Maximum Accessories in system
100m
8
130m
7
180m
6
24
250m
5
400m
4
500m
3
The maximum distances quoted in the table are due to DC current limitations. The paging stations and wall panels can be locally powered to increase the cable length to a maximum
of 500m. Please read the following additional document: Advanced accessory port wiring guide.
australianmonitor.com.au
2
LAKANG 3: ACCESSORY PORT WIRING
Wire the ZONEMIX and ZMPS paging stations as per the images below. · Category 5, 5e and 6 cabling supported. · T-568A wiring recommended. However, T-568B also supported.
ZONEMIX AND ZMPS WIRING 1
8
*T-568A wiring
1 2 3 4 5 6 7 8
Pin Colour 1 Green/White 2 Green 3 Orange/White 4 Blue 5 Blue/White 6 Orange 7 Brown/White 8 Brown
ZONEMIX
Signal Paging Audio + Paging Audio RS485 B +24V DC GND RS485 A Local Input + Local Input –
ZMPS
ZMPS DAISY CHAIN WIRING
ZONEMIX
Use an RJ45 splitter or terminal block if daisy chain wiring required
australianmonitor.com.au
3
LAKANG 3: ACCESSORY PORT WIRING (CONT.)
Wire the wall panels as per the images below. · Category 5, 5e and 6 cabling supported. · T-568A wiring recommended. However, T-568B also supported.
WP4R, WP10, WPVOL WIRING
WPBT WIRING
1
Paging Audio +
2
Paging Audio -
3
RS485 A
4
+ 24V DC
5
GND
6
RS485 B
7
Hilit nga Input +
8
Hilit nga Input -
*Unused if not daisy chaining
Daisy chain wiring
*Unused unless connecting to downstream ZMPS
Daisy chain wiring
australianmonitor.com.au
4
STEP 4: PORT TERMINATION DO NOT SKIP THIS STEP
The ZONEMIX uses the RS485 standard to communicate to wall panels and paging stations. RS485 requires that each end of the cable run is terminated to prevent signal corruption due to signal reflections in the cable. The Accessory Ports are grouped in Pairs. 1+2, 3+4, 5+6, 7+8. You must terminate the ZONEMIX and Accessories based on which ports you use.
1. Terminate the ZONEMIX accessory ports, as per the table, using the PORT TERM switches
ACCESSORY PORT TERMINAL SWITCH SETTING
ONE PORT USED TERM BOTH PORTS USED TERM
Port 1 OR Port 2 used Port 3 OR Port 4 used
ON Port 1 AND Port 2 used OFF
ON
ON Port 3 AND Port 4 used OFF
Port 5 O Port 6 gigamit
ON Port 5 AND Port 6 used OFF
Port 7 O Port 8 gigamit
ON Port 7 AND Port 8 used OFF
2. Terminate the LAST RS485 accessory on the port cable run.
Pag-undang sa istasyon sa paging
Pagtapos sa panel sa dingding
Examples:
ONE port used:
PORT TERM = ON
Terminate end points
BOTH Ports used:
PORT TERM = OFF
australianmonitor.com.au
5
LAKANG 5: WP4R, WP10 GPO WIRING (OPTIONAL)
Ang WP4R ug WP10 parehong adunay 3 nga kinatibuk-ang katuyoan nga mga output nga mahimong kontrolado gikan sa mga buton sa panel sa dingding aron ma-trigger ang mga eksternal nga aparato sama sa mga projector.
GPO Schematic
Ang matag Output usa ka bukas nga kolektor transistor. Maximum nga Voltage: 48V Maximum Sink Current: 250mA
Example: Relay Connection
24V
Internal nga Logic
GPO1
GPO2
GPO3
australianmonitor.com.au
GND 6
Mga Dokumento / Mga Kapanguhaan
![]() |
ZONEMIX ZONEMIX4 Zone Controller [pdf] Mga instruksiyon ZONEMIX4, ZONEMIX4 Zone Controller, Zone Controller, Controller |