Lighting Fixture Installation Guide

Warnings

WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A LICENSED ELECTRICIAN.

WARNING: SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.

INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL. ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.

Care and Maintenance

To clean the outside of the fixture, use a dry or slightly dampened clean cloth (use clean water, never a solvent) to wipe the surface of the fixture.

To clean the inside of the fixture, first disconnect power to the fixture by turning off the circuit breaker or by removing the fuse at the fuse box. Next, use a dry or slightly dampened clean cloth (use clean water, never a solvent) to wipe the interior surface of the fixture.

Notices & Important Safety Instructions

• Please make sure that you have all parts indicated before you begin assembly of this item.
• This item should be assembled on a soft surface to prevent scratching the finish during assembly.
• To reduce the risk of fire, electrical shock or injury to persons or property, please follow the guideline below for safe use and installation.
• The external flexible cable or cord of this lamp cannot be replaced.
• If the cord is damaged, the lamp shall be destroyed.

Part List and Hardware List

Preparation

Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware contents list. If any part is missing or damaged, do not attempt to assemble the product.

Estimated Assembly Time: 6 minutes.

Installation Instructions

1. Fix the mounting bracket(B) to the outlet box with machine screw(F).
2. Make wire connections, with wire connectors(A), following the reference chart listed below.

   Wiring Connections:

   Connect Outlet Supply Wire (Hot/Black or Red)	Connect Outlet Supply Wire (Neutral/White)
   Black * Parallel Cord (round & smooth)	White * Parallel Cord (square & ridged)
   Clear, Brown, Gold or Black without Tracer (colored stripes)	Clear, Brown, Gold or Black with Tracer (colored stripes)
   Insulated Wire (not green) with copper metal conductor	Insulated Wire (not green) with Silver metal conductor.

   *Note: When parallel wire (SPT I & SPT II) is used. The neutral wire is square shaped and ridged and the hot wire will be round in shape and smooth. (See Illustration on left.)

   Illustration Description: The illustration shows two types of parallel wires: one with a smooth, round outer jacket (hot wire) and one with a ridged, square outer jacket (neutral wire).

3. Grounding Instructions:

   a) For installation in the United States: Wrap ground wire from outlet box around green ground screw(D) on mounting bracket, no less than 2" from wire end. Tighten ground screw. If fixture is supplied with a ground wire, connect to outlet ground wire with a wire connector.

   b) For installation in Canada: If fixture is supplied with ground wire, wrap ground wire around green grounding screw on mounting bracket. Tighten ground screw.

4. Carefully remove packaging from fixture, adjust wire length to desired mounting height, Install canopy (G) to bracket using mounting screws (C) at the side of the canopy.

Diagram Description: The diagram shows the wiring connections between the outlet supply wires (Black, White, Ground) and the fixture wires (Black, White, Green/Ground) using wire connectors (A). It also illustrates the mounting bracket (B) attached to the outlet box, the ground wire connected to the ground screw (D), and the canopy (G) being attached with screws (C).

ENJOY YOUR LAMP