Installation Manual
Safety Instructions
Please read this notice carefully and keep it all along the use of this product. Follow the instructions for a safe and correct installation and functioning of the fitting.
The manufacturer does not accept any responsibility for damage caused by improper installation and service.
Always isolate the power before commencing installation, maintenance or repair.
In case of doubts, please contact a qualified electrician.
This product is for indoor use only. Please do not use it on humid places. Do not put it in contact with water or any liquids or inflammable products. Always respect the minimal distance (indicated on the light) to inflammable products.
During installation, make sure that the cables will not be squeezed or damaged by sharp edges. If the external flexible cable is damaged, it needs to be replaced exclusively by the manufacturer, his service agent, or another qualified electrician. This is to avoid all risks.
Wiring and Mounting Diagram
The diagram illustrates the installation process for a lighting fixture. It details the mounting hardware, wiring connections, and recommended switch type.
Mounting and Canopy Wiring:
The fixture mounts to a ceiling using a Slope Ceiling Adapter. The main canopy houses the wiring connections. The following wires are connected within the canopy:
- Brass Wire: Ground connection.
- White Wire: Neutral (-) connection.
- Black Wire: Live (+) connection.
These wires connect to a terminal block inside the canopy.
Fixture Suspension:
The lighting fixture itself is suspended by rods, measuring 30cm (12 inches) in length, with four rods indicated (30cm(12")x4).
Electrical Connection to House Wiring:
The fixture's internal wiring connects to the house electrical supply. The diagram shows:
- Fixture's Red Wire (L+) connects to the house's Red Wire (L+).
- Fixture's Brown Wire connects to the house's Brown Wire.
- Fixture's Blue Wire (N-) connects to the house's Black Wire (N-).
Important! The polarity of the output wires needs to be matched. Otherwise, the fixture will not light on.
Recommended Switch:
The fixture is compatible with a Triac Dimming Lutron Switch.
