Resistex Miks LED Downlight

Safety Instructions

• Never work on the luminaire when it is live.
• Installation must be performed by a professional installer in compliance with the standards and regulations relating to electrical installations.
• Risk of electrostatic discharges (ESD Norm). Handle with precautions.
• Please observe the notes and steps described in the mounting instructions.

Maintenance Instructions

• Do not use chemicals or abrasive products to clean the fixture.
• Keep these instructions for dismantling or future maintenance.
• Additional information about RESISTEX luminaires is available on the website: www.resistex-sa.com.
• RESISTEX cannot be responsible for any misuse of the product.

Installation Steps

1. Prepare Mounting Hole: Cut a circular opening of Ø69 mm (±1 mm) in the ceiling material.
2. Insert Fixture: Place the downlight fixture into the prepared opening.
3. Secure Fixture: Rotate the fixture clockwise until it is firmly secured.
4. Connect Wiring: Ensure the power supply is disconnected. Prepare to connect the electrical wires.
5. Use Connector Block: Utilize the provided connector block for electrical connections.
6. Wire Connections: Insert the live (L), neutral (N), and earth wires into the correct terminals within the connector block.
7. Terminal Identification: The connector block is clearly marked with terminals for Live (L), Neutral (N), and Earth.
8. Adjust Orientation: Position the fixture as desired. The downlight offers adjustable orientation.
9. Test Functionality: Verify the electrical connection and performance.
10. Final Installation: The Miks LED downlight is now installed in the ceiling.

Certifications and Compliance

Company Information

Manufacturer: RESISTEX EXPLOITATION

Address: 11 Quai de la Banquière CS 80010, 06730 Saint-André-de-la-Roche, France

Contact: Tél. 04 93 276 276 - Fax 04 93 276 280 - contact@resistex-sa.com

Company Registration: APE 2740Z - Siret 487 593 477 00010 - SAS CAPITAL 649979 € - T.V.A. F.R. 73 487 593 477