Resistex Miks LED Downlight

Product Overview

The Resistex Miks is an LED downlight designed for versatile lighting applications. It offers adjustable orientation and low luminance options, suitable for various interior settings.

Options and Accessories

Adjustable Orientation

The fixture can be adjusted for orientation. This typically involves rotating a component and securing it with a ring, allowing users to direct light as needed.

Low Luminance

The fixture is designed for low luminance applications and features integrated clips or springs for secure mounting.

Installation Instructions

Safety Notes

• Never work on the luminaire when it is live (under voltage).
• Installation must be performed by a professional installer in compliance with relevant electrical installation standards and regulations.
• Be aware of the risk of electrostatic discharges (ESD Norm). Handle components with necessary precautions.
• Observe all instructions and mounting steps carefully.

Maintenance Instructions

• Do not use chemical or abrasive products to clean the fixture.
• Keep these instructions for future dismantling or maintenance.
• Additional information on Resistex luminaires is available on the website www.resistex-sa.com.
• Resistex is not responsible for any misuse of the product.

Mounting and Installation Steps

1. Step 1: Cutout Preparation

   Prepare the mounting surface by cutting a hole with a diameter of 69mm (+/-1mm). A template is provided for accuracy.

2. Step 2: Insert Fixture

   Insert the LED downlight fixture into the prepared hole in the ceiling or mounting surface.

3. Step 3: Secure Fixture

   Rotate the fixture to engage its mounting mechanism and secure it firmly in place within the cutout.

4. Step 4: Electrical Connection - Wire Insertion

   Open the integrated terminal block. Insert the electrical wires (Live, Neutral, and Earth/Ground) into the corresponding terminals. Ensure correct polarity (L for Live, N for Neutral).

5. Step 5: Close Terminal Block

   Close the terminal block securely to ensure all wire connections are properly enclosed.

6. Step 6: Connect to Fixture

   Connect the wires from the terminal block to the internal connections of the LED downlight fixture.

7. Step 7: Terminal Block Diagram Reference

   Refer to the terminal block diagram showing connections for Live (L), Neutral (N), and Earth (ground) to confirm correct wiring.

8. Step 8: Final Insertion

   Gently push the connected fixture into the ceiling opening until it sits flush.

9. Step 9: Connection Verification

   Verify electrical connections. Ensure correct polarity and secure connections are made, as indicated by a green checkmark symbol [✔️]. Incorrect connections are marked with a red cross symbol [❌].

10. Step 10: Final Installation Check

    Confirm the installed fixture is flush with the ceiling surface, indicating a successful installation.

Certifications and Company Information

The product complies with the following standards:

• IP65: Protection against dust and water jets.
• IK07: Protection against mechanical impacts.
• Class II: Double or reinforced insulation.
• CE Marking: Conformity with health, safety, and environmental protection standards for products sold within the European Economic Area (EEA).
• RoHS: Restriction of Hazardous Substances, limiting the use of specific hazardous materials.

Resistex Exploitation

11 Quai de la Banquière CS 80010, 06730 Saint-André-de-la-Roche - France

Tel: 04 93 276 276 | Fax: 04 93 276 280

Email: contact@resistex-sa.com

Website: www.resistex-sa.com

Company Registration: APE 2740Z - Siret 487 593 477 00010 - SAS CAPITAL 649979 € - T.V.A. F.R. 73 487 593 477

Document Version: V1.1 - 09.22