VOXNAN Wash-Basin Mixer Tap

Contents

• Tools and Spare Parts
• Illustration of Product, Parts, and Part Numbers
• Product Assembly

Safety and Installation Guidelines

? The installation must be carried out in accordance with industry regulations, such as Säker Vatteninstallation.

⚠️ Before changing the mixer tap, switch off the main shut-off valve.

This product is certified: TG 1348, 1913, EN 817, EN 1717.

Swedish RSK Number: 8275790

English RSK Number: 8275790

Tools and Parts Required

Tools:

• Sealant gun
• Wrench
• Coin (for aerator adjustment)
• Screwdriver (possibly Phillips head)
• Allen key (included)

Included Parts:

• VOXNAN mixer tap body
• Mounting screws (long)
• Mounting brackets
• Washers
• Nuts
• Flexible connection hoses
• Aerator/Flow Guide
• Allen key (110084)
• Screwdriver (126907)

Visit www.IKEA.com for more information.

Technical Specifications

Connection Size: G3/8 (R10)

Recommended Operating Temperature: Max. 60°C

Maximum Operating Temperature: Max. 80°C

Recommended Operating Pressure: 1-5 bar

Maximum Operating Pressure: 0.5-10 bar

Mounting Hole Diameter: Ø 34 - 37 mm (1 3/8" - 1 1/2")

Assembly Instructions

Step 1: Mount the Mixer Tap

Insert the long mounting screw (121842) through the base of the mixer tap and into the mounting surface.

Step 2: Secure and Seal

Sealing: Apply silicone sealant to the open surfaces around the tap base to prevent water from penetrating the worktop in case of leaks. Silicone sealant is not included. The sealant must be water- and mould-resistant and suitable for installation, compliant with EN 15651-3, Class XS1.

Securing: Use the provided mounting brackets, washers, and nuts to secure the tap to the surface. Ensure the pipe connection is flat and free from sharp edges.

Maximum thickness for sealing application: 50 mm (2 inches).

Step 3: Connect Water Hoses

Connect the flexible hoses to the mixer tap and the water supply points. Ensure connections are secure but do not overtighten, as this can damage hoses, pipes, and washers. Avoid sharp bends or kinks in the hoses.

⚠️ IMPORTANT! Do not tighten too hard: this can damage hoses/pipes and washers.

Step 4: Flush and Check

Before first use: Unscrew the Aerator/Flow Guide using a coin. Allow water to run freely for a few minutes to flush out any debris. Then, screw the Aerator/Flow Guide back into place until it stops. DO NOT OVERTIGHTEN.

? Check at regular intervals to ensure the installation is not leaking.