LUNDSKÄR
Wash-basin mixer tap
Brand: IKEA
Contents
- Tools and spare parts
- Illustration of product, parts and part numbers
- Product assembly
Important Information & Regulations
Installation Compliance
? Installation must be carried out in accordance with industry regulations Säker Vatteninstallation.
Safety Precaution
⚠️ Switch off the main shut-off valve before changing the mixer tap.
Certifications
Certified according to EN 817 | EN 1717. RSK No: 8275787.
Tools and Spare Parts
Required Tools
- Sealant gun
- Wrench (x2)
Visit www.IKEA.com for more information.
Included Parts
- Spring (x2)
- Allen key (x1)
- Nut (x2)
- Mounting bracket (x2)
- Connector piece (x1)
Product Overview
Faucet Components
Main faucet body with spout and handle.
Connection type: G3/8" (R10)
Operating Specifications
- Recommended Operating Temperature: Max. 60°C
- Maximum Operating Temperature: Max. 80°C
- Recommended Operating Pressure: 1-5 bar
- Maximum Operating Pressure: 0.5-10 bar
Product Assembly
Step 1: Positioning the Faucet
Insert the faucet body through the sink or countertop opening, aligning the mounting studs.
Step 2: Securing the Faucet
Attach the mounting screws (part 121842) to the mounting studs from underneath the sink or countertop.
Step 3: Sealing and Securing
Apply silicone sealant to the open surfaces around the faucet base to prevent water from penetrating the worktop. Note: Silicone sealant is not included. The sealant must be water- and mould-resistant and suitable for installation, according to EN 15651-3, Class XS1.
Ensure the hole diameter is between 34 - 37 mm (1 3/8" - 1 1/2"). The maximum worktop thickness is 55 mm (2 3/16").
Step 4: Connecting Water Hoses
Ensure the pipe connection points are flat and free from sharp edges.
⚠️ IMPORTANT: Do not overtighten the connections. Overtightening can damage hoses, pipes, and washers.
Diagram shows correct hose connection with seals in place and incorrect connections with damaged seals or misaligned pipes.
Final Checks and Usage
Before First Use
Unscrew the Aerator/Flow Guide. Allow water to run freely for a few minutes to flush the system. Screw the Aerator/Flow Guide back into place. Ensure it is tightened sufficiently to prevent accidental removal by hand.
Maintenance
? Check at regular intervals to ensure the installation is not leaking.
