DALSKÄR Wash-Basin Mixer Tap
IKEA
Important Safety Information and Installation Compliance
? The installation of this mixer tap must be carried out in accordance with industry regulations, specifically "Säker Vatteninstallation" (Safe Water Installation).
⚠️ Before commencing any work, ensure you switch off the main shut-off valve to prevent water flow.
This installation is accepted and certified according to standards:
- TG 1179
- KIWA 1913
- EN 817 | EN 1717
Swedish RSK Number: 8275781
English RSK Number: 8275781
Tools and Parts
Required Tools:
- Pliers [pliers]
- Wrench [wrench]
- Coin (for aerator adjustment)
Included Parts (refer to diagrams for visual identification):
- Mounting screws: 2x (part 124405)
- Nuts: 2x (part 121845)
- Mounting bracket/plate: 1x (part 110084)
- Washer: 1x (part 121844)
- Screwdriver: 1x (part 126907)
- Flexible hoses: G3/8 (R10)
Visit www.ikea.com for more information.
Technical Specifications
Hole Diameter for Installation: Ø 34 - 37 mm (Ø 1 3/8 - 1 1/2")
Water Connection: G3/8 (R10)
Recommended Operating Temperature: Max. 60°C
Maximum Operating Temperature: Max. 80°C
Recommended Operating Pressure: 1-5 bar
Maximum Operating Pressure: 0.5-10 bar
Assembly Instructions
Step 1: Positioning the Mixer Tap
Lower the mixer tap through the mounting hole in the sink or countertop.
Step 2: Securing the Mixer Tap
From underneath the sink/countertop, slide the mounting bracket (110084) onto the threaded studs of the tap. Then, thread and tighten the nuts (121845) onto the studs to secure the tap firmly in place. Ensure the tap is stable.
Step 3: Sealing the Installation
⚠️ Seal the open surfaces where the tap meets the countertop with silicone sealant to prevent water ingress and potential leaks. Silicone sealant is not included with the product.
The silicone sealant used must be water- and mould-resistant and suitable for this type of installation, complying with EN 15651-3, Class XS1.
Ensure the sealant is applied evenly around the base.
Step 4: Connecting Water Hoses
Connect the flexible water hoses to the corresponding inlets on the mixer tap. Ensure the pipe connection surfaces are flat and free from sharp edges to prevent damage to the seals.
⚠️ IMPORTANT! Do not overtighten the hose connections. Overtightening can damage the hoses, pipes, and washers.
The pipe connection needs to be flat and free from sharp edges.
Final Checks and Usage
Initial Use (Flushing)
Before regular use, unscrew the aerator/flow guide from the tap spout using a coin. Allow water to run freely through the tap for a few minutes to flush out any debris from the installation process. After flushing, screw the aerator/flow guide back into place until it stops. DO NOT OVERTIGHTEN.
Regular Maintenance
? Check at regular intervals to ensure that the installation is not leaking.
