Resistex Miks LED Downlight Installation Guide

Safety Instructions

• Never work when voltage is present on the luminaire.
• The installation must be performed by a professional installer in compliance with the standards and regulations relating to electrical installations.
• Risk of electrostatic discharges (ESD Norm). Handle with precautions.
• Please observe the notes and steps described in the mounting instructions.

Maintenance Instructions

• Do not use chemicals or abrasives products to clean the fixture.
• Keep these instructions for dismantling or future maintenance.
• Additional information about RESISTEX luminaires is available on the website www.resistex-sa.com.
• RESISTEX cannot be responsible for any misuse of the product.

Installation Steps

1. Step 1: Prepare Ceiling Opening

   Cut a circular hole in the ceiling with a diameter of Ø69 mm (+/- 1 mm). A square cutout may also be needed for the driver/transformer.

2. Step 2: Insert Fixture

   Insert the main light fixture upwards into the prepared ceiling opening.

3. Step 3: Secure Fixture

   Rotate a part of the fixture to engage its securing mechanism, fixing it in place within the ceiling.

4. Step 4: Prepare Wiring Connection

   Feed the electrical cable through and prepare it for connection to the terminal block. The terminals are labeled L (Live), N (Neutral), and Earth (ground symbol).

5. Step 5: Open Connector

   Open the electrical connector, typically by lifting a lever or cover, to access the wire terminals.

6. Step 6: Insert Wires

   Insert the stripped ends of the electrical wires (Live, Neutral, Earth) into their corresponding terminals within the open connector.

7. Step 7: Close Connector

   Close the electrical connector to securely fasten the inserted wires.

8. Step 8: Final Fixture Placement

   Push the fixture fully into the ceiling. Spring clips or retaining mechanisms will engage to hold it securely.

9. Step 9: Electrical Test

   Verify the electrical connection and power supply. A correct AC input waveform is indicated by a checkmark ✔️, while an incorrect one is marked with a cross ❌.

10. Step 10: Final Check

    Ensure the fixture is correctly and securely installed, flush with the ceiling surface.