Resistex Miks LED Downlight

Company Information

Resistex Exploitation
11 Quai de la Banquière CS 80010, 06730 Saint-André-de-la-Roche - France
Tel: 04 93 276 276 - Fax: 04 93 276 280
Email: contact@resistex-sa.com
APE 2740Z - Siret 487 593 477 00010 - SAS CAPITAL 649979 € - VAT FR 73 487 593 477

Website: www.resistex-sa.com

Installation Instructions (EN)

Safety Notes

• Never work when voltage is present on the luminaire.
• The installation must be performed by a professional installer in compliance with the standards and regulations relating to electrical installations.
• ⚠️ Risk of electrostatic discharges. (ESD Norm). Handle with precautions.
• Please observe the notes and steps described in the mounting instructions.

Maintenance Instructions

• Do not use chemicals or abrasives products to clean the fixture.
• Keep these instructions for dismantling or future maintenance. You can consult additional information about RESISTEX luminaires on the website www.resistex-sa.com.
• RESISTEX cannot be responsible for any misuse of the product.

Mounting / Installation Steps

The following steps detail the installation process for the Miks downlight.

1. Step 1: Preparation

   Shows a circular template with dimensions Ø69mm (+/-1mm) for ceiling cut-out.

   [Ceiling cut-out template with Ø69mm (+/-1mm) dimension]

2. Step 2: Positioning

   Illustrates the downlight fixture being positioned above a ceiling opening, with its spring-loaded mounting clips retracted or ready to be engaged.

   [Fixture positioned above ceiling opening, clips ready]

3. Step 3: Securing Fixture

   Depicts the fixture being pushed into the ceiling opening, causing the spring clips to expand and secure the fixture.

   [Fixture pushed into opening, clips expanding]

4. Step 4: Electrical Connection Preparation

   A close-up view of the electrical connector, showing how to insert the power wires (Live, Neutral) into the designated terminals. Arrows indicate the direction of insertion.

   [Close-up of connector, wires being inserted into terminals]

5. Step 5: Locking Wires

   Shows the electrical connector with wires inserted, and a lever mechanism that is closed to secure the wires.

   [Connector with wires, lever being closed]

6. Step 6: Terminal Identification

   The electrical connector terminals are clearly labeled 'L' (Live), 'N' (Neutral), and a ground terminal.

   [Connector terminals labeled L, N, Ground]

7. Step 7: Connecting Power

   Illustrates the process of connecting the Live and Neutral wires to their respective terminals within the connector.

   [Connecting Live and Neutral wires to terminals]

8. Step 8: Final Insertion

   Shows the downlight fixture being compressed and inserted into the prepared ceiling opening, with the spring clips ready to hold it in place.

   [Fixture compressed and inserted into ceiling opening]

9. Step 9: Wire Termination Check

   The fixture is now installed, with the spring clips fully engaged against the ceiling. Two diagrams show correct wire termination (green checkmark ✔️) and incorrect termination (red cross ❌), indicating proper stripping of insulation.

   [Fixture installed, clips engaged. Correct (✔️) vs Incorrect (❌) wire termination shown.]

10. Step 10: Installation Complete

    A final view of the installed Miks downlight in the ceiling, with an indication of an ON/OFF switch.

    [Installed Miks downlight in ceiling with ON/OFF indicator]

Product Certifications and Features

• [RoHS compliant]
• [Class II]
• [IP65 rated]
• [IK07 rated]
• [CRI 82]
• [5 Year Warranty]
• [CE Marked]