ENSEN Wash-basin Mixer Tap
Brand: IKEA
Important Information & Safety
[info] Installation must be carried out in accordance with industry regulations, such as Säker Vatteninstallation.
[warning] Before changing the mixer tap, switch off the main shut-off valve.
This product is accepted as a mounting instruction (2021:1) and complies with EN 817 and EN 1717 standards. It is certified by KIWA TG 1180 1913.
Swedish RSK Number: 8275782
Tools and Parts Required
Tools:
- Sealant gun
- Wrench
Included Parts:
- Flexible hoses (2x)
- Mounting brackets/plates (2x)
- Washers/seals (1x)
- Nuts (2x)
- Screw (1x)
- Allen key (1x)
Part numbers for reference: 121846, 121842, 121845, 110084, 121844.
For further assistance and product information, visit www.IKEA.com.
Product Specifications
Connection type: G3/8 (R10)
Operating Conditions:
- Recommended Operating Temperature: Max. 60°C
- Maximum Operating Temperature: Max. 80°C
- Recommended Operating Pressure: 1-5 bar
- Maximum Operating Pressure: 0.5-10 bar
Assembly Instructions
Step 1: Preparation
Attach the flexible hoses and mounting components to the mixer tap body as shown in the diagrams.
Step 2: Sealing the Worktop
[info] Seal the open surfaces around the tap hole with silicone sealant to prevent water from penetrating the worktop in case of leaks. Silicone sealant is not included.
The silicone sealant must be water- and mould-resistant and suitable for installation, conforming to EN 15651-3, Class XS1.
Step 3: Mounting Hole Requirements
The diameter of the mounting hole in the worktop should be between 34 mm and 37 mm (approximately 1 3/8" to 1 1/2").
Step 4: Installing the Mixer Tap
Insert the mixer tap through the prepared hole in the worktop. Secure the tap from underneath using the provided mounting brackets, nuts, and washers.
Step 5: Pipe Connection Preparation
Ensure the pipe connection point is flat and free from any sharp edges to ensure a proper seal.
Step 6: Connecting Flexible Hoses
Connect the flexible hoses to the water supply lines. [warning] IMPORTANT: Do not overtighten the connections, as this can damage the hoses, pipes, or washers.
Step 7: Initial Flush and Aerator Check
Before first use, unscrew the aerator (flow guide) from the spout. Allow water to run freely for a few minutes to flush out any debris. Then, screw the aerator back into place. Ensure it is tightened sufficiently to prevent it from being easily removed by hand.
Step 8: Leak Check
Periodically check the installation to ensure there are no leaks.
Step 9: Attaching the Handle
Attach the mixer tap handle to the main body. Insert the screw (110084) through the handle mechanism and into the tap body to secure it.
