Hooke Road Front Bumper - BXG.4231
Installation Instructions
Attention
Please verify all parts are present and read instructions carefully before starting installation. Please feel free to contact your distributor if you have any kind of question about your purchase.
Contents
A: Main Body
B1 & B2: Mounting Brackets
C1 & C2 & C3: License Plate Bracket
M12*30 M10*25*1.5 M10*25 M6*12*1 M6*16 M6*12*1.3 D12 M12 D10 M6 M12*30*1.5 165| Qty | Part Name | Size(mm) | Picture | Qty | Part Name | Size(mm) | Picture |
|---|---|---|---|---|---|---|---|
| 10 | Hex Bolt | [Bolt] | 2 | Flat Washer | [Washer] | ||
| 2 | Hex Bolt | [Bolt] | 6 | Flat Washer | [Washer] | ||
| 6 | Button Bolt | [Bolt] | 2 | Nylon Round Spacer | [Spacer] | ||
| 10 | Split Lock Washer | [Washer] | 10 | Hex Nut | [Nut] | ||
| 2 | Split Lock Washer | [Washer] | 6 | Nylon Lock Nut | [Nut] | ||
| 10 | Flat Washer | [Washer] | 1 | Edge Trim | [Trim] |
Tools Required
- Drive Ratchet Handle
- 10mm, 14mm Wrench
- 4mm Hex Bit Socket
- 17mm, 19mm Wrench
To view online instruction, please scan the QR code.
Installation Instruction
-
Place the vehicle in park and remove the factory bumper and accessories from the frame. Keep the factory nuts.
[Image of vehicle front with factory bumper removed]
-
Push Edge Trim over the bumper edge. Cut Trim to fit.
[Image of edge trim being installed on bumper]
-
Assemble the license plate bracket, secure it to the bumper, and tighten the hardware.
- (4) M6x16 Button Bolts
- (4) M6x12x1 Flat Washers
- (4) M6 Nylon Lock Nuts
- (2) M6x12x1.3 Nylon Round Spacer
[Diagram showing license plate bracket assembly with bolts, washers, nuts, and spacers]
-
Install the mounting bracket onto the bumper. Repeat this step for the other side. Tighten the hardware.
- (10) M12x30 Hex Bolts
- (10) D12 Split Lock Washers
- (10) M12x30x1.5 Flat Washers
- (10) M12 Hex Nuts
[Diagram showing mounting bracket installation on bumper]
-
Install the bumper onto the vehicle. Repeat this step for the other side. Adjust the bumper to the desired position, then fully tighten all hardware.
- (6) Factory Nuts
[Image of bumper being installed onto vehicle frame]
-
The installation is complete. We hope you enjoy a wonderful off-road life with this quality Hooke Road product!
[Image of fully installed front bumper on the vehicle]
Google Hooke Road to find your parts.
Feel Free To Share Your Vehicle @HookeRoad4x4 With The Hashtag #hookeroad If You'd Like
[Social media icons: Facebook, Instagram, TikTok]
