Hooke Road BXG-5300 Front Bumper
Installation Instruction
ATTENTION
Please verify all parts are present and read instructions carefully before starting installation. Please feel free to contact your distributor if you have any kind of question about your purchase.
CONTENTS
Left
[Image: Left side view of bumper components labeled B1]
A: Main Body
[Image: Main body component labeled A]
Right
[Image: Right side view of bumper components labeled B2]
B1&B2: Wings
[Image: Components labeled C1 and C2]
C1&C2: License Plate Bracket
[Image: Component labeled D]
D: Sensor Brackets
x4
| Qty | Part Name | Size(mm) | Picture | Qty | Part Name | Size(mm) | Picture |
|---|---|---|---|---|---|---|---|
| 6 | Hex Bolt | M12×30 | [Image: Hex Bolt M12x30] | 2 | Flat Washer | M6×12×1 | [Image: Flat Washer M6x12x1] |
| 2 | Button Bolt | M6×16 | [Image: Button Bolt M6x16] | 6 | Hex Nut | M12 | [Image: Hex Nut M12] |
| 8 | Button Bolt | M4×20 | [Image: Button Bolt M4x20] | 2 | Nylon Lock Nut | M6 | [Image: Nylon Lock Nut M6] |
| 6 | Split Lock Washer | D12 | [Image: Split Lock Washer D12] | 1 | L-Wrench | M4 | [Image: L-Wrench M4] |
| 6 | Flat Washer | M12×30×2 | [Image: Flat Washer M12x30x2] | 2 | EVA | [Image: EVA component] |
TOOLS REQUIRED
| [Image: Ratchet Handle] | Drive Ratchet Handle | [Image: 10mm, 19mm Wrench] | 10mm, 19mm Wrench |
| [Image: Hex Bit Socket] | 4mm Hex Bit Socket | [Image: Shallow Socket] | 19mm Shallow Socket |
INSTALLATION INSTRUCTION
Step 1
Place the vehicle in park, remove the factory bumper from the frame.
[Image: Front of a vehicle with the factory bumper highlighted for removal]
Step 2
First, stick the EVA to the main body. Assemble your Hooke Road bumper. Align the outer profile with the inner profile and tighten the hardware. Repeat this step on the other side of the bumper.
- (6) M12×30 Hex Bolts
- (6) D12 Split Lock Washers
- (2) EVA
- (6) M12×30×2 Flat Washers
- (6) M12 Hex Nuts
[Image: Exploded view of bumper assembly with EVA and hardware]
Step 3
Secure the bumper to the vehicle frame. Adjust the bumper to the desired position. Repeat this step on the other side of the vehicle. Finally, tighten all bolts.
- (6) Factory Bolts
[Image: Bumper being attached to the vehicle frame]
Step 3
Assemble the license plate bracket, then secure it to the bumper and tighten the hardware.
- (2) M6×16 Button Bolts
- (2) M6×12×1 Flat Washers
- (2) M6×12×1.3 Nylon Round Spacers
- (2) M6 Nylon Lock Nuts
Step 5
The installation is complete. We hope you enjoy a wonderful off-road life with this quality Hooke Road product!
[Image: Fully installed Hooke Road front bumper on a vehicle]
To view online instruction, please scan the QR code.
[QR Code: Link to online installation video/instructions]
