Vendor Information
Vendor Name: LSMX1
Vendor Code: V-005852
Vendor Collection: VERA DREAM
Parts List
| ITEM | DESCRIPTION | QUANTITY |
|---|---|---|
| 1 | VERA DREAM HEADBOARD | 1 |
| 2 | VERA DREAM RAILS/SLATS | 1 |
| 3 | VERA DREAM FOOTBOARD | 1 |
Hardware
| Ref | Description | Quantity |
|---|---|---|
| A | 5/16-18X1" SCREW BUTTON HEAD CAP | X8 |
| B | WASHER 5/16 PLAIN | X8 |
| C | 3/16 SHORT ARM HEX KEY | X2 |
Hardware bag included behind the headboard with red ribbon to locate.
Assembly Steps
Step 1: Attach Side Rails to Headboard
Attach side rails to headboard using Wrench(C), 4 Screws (A) and Washers (B).
Diagram for Step 1 shows two side rails (labeled '2') connecting to the headboard (labeled '1'). Use four screws (A) and four washers (B) per side rail, tightening with the provided hex key (C). A hardware bag is indicated.
Step 2: Attach Footboard to Side Rails
Attach Footboard to side rails using Wrench(C), 4 Screws (A) and Washers (B).
Diagram for Step 2 shows the footboard (labeled '3') connecting to the side rails (labeled '2'). Use four screws (A) and four washers (B) to attach the footboard to each side rail, tightening with the hex key (C).
Step 3: Attach Support Legs
Attach the support legs with leveler to the center slat. Adjust the levers on bottom of support legs when necessary.
Diagram for Step 3 illustrates attaching support legs with adjustable levelers to the center slat (labeled '3'). The instruction 'TURN RIGHT ONLY USE THE HAND' indicates how to adjust the levelers.
Step 4: Place Frame into U-shaped Slot
Place the piece from top to bottom into the U-shaped slot.
Diagram for Step 4 shows the bed frame being lowered into a U-shaped slot, likely a base support or frame component.
Step 5: Unroll Slats
Unroll the slats onto the center slat staring at the footboard and ending at the headboard.
Diagram for Step 5 depicts unrolling the bed slats. The slats should be laid out starting from the footboard end (labeled '2') and progressing towards the headboard end (labeled '1'), resting on the center slat (labeled '3').
Step 6: Verify Slats and Support
Verify the slats are installed properly the legs are perpendicular to the floor for full support.
Diagram for Step 6 shows a side view of the bed, emphasizing that the slats and support legs should be perpendicular to the floor to ensure proper support.
Estimated assembly time: [30 minutes]
Assembly requires [two people recommended].
