VERA DREAM BED ASSEMBLY INSTRUCTIONS
Vendor Information
Vendor Name: LSMX1
Vendor Code: V-005852
Living Space Information
Vendor Collection: VERA DREAM
Parts List
| ITEM | DESCRIPTION | QUANTITY |
|---|---|---|
| 1 | VERA DREAM HEADBOARD | 1 |
| 2 | VERA DREAM RAILS/SLATS | 1 |
| 3 | VERA DREAM FOOTBOARD | 1 |
Hardware
- HEADBOARD (1)
- RAILS/SLATS (2)
- FOOTBOARD (1)
A: 5/16-18X1" SCREW BUTTON HEAD CAP (8)
B: WASHER 5/16 PLAIN (8)
C: 3/16 SHORT ARM HEX KEY (2)
Hardware bag included behind the headboard with red ribbon to be located.
Assembly Instructions
Step 1: Attach Side Rails to Headboard
Attach the side rails (2) to the headboard (1) using Wrench (C), 4 Screws (A), and 4 Washers (B).
Diagram Description: Shows the headboard standing upright. Two side rails are positioned to connect to the sides of the headboard. Arrows indicate inserting screws (A) through holes in the rails into the headboard, with washers (B) placed on the screws. The hex key (C) is shown for tightening.
Step 2: Attach Footboard to Side Rails
Attach the footboard (3) to the side rails (2) using Wrench (C), 4 Screws (A), and 4 Washers (B).
Diagram Description: Shows the headboard and side rails assembled. The footboard is positioned at the other end of the side rails. Arrows indicate inserting screws (A) through holes in the footboard into the side rails, with washers (B) placed on the screws. The hex key (C) is shown for tightening.
Step 3: Attach Support Legs
Attach the support legs with levelers to the center slat. Adjust the levers on the bottom of the support legs as necessary. Turn right only use the hand.
Diagram Description: Shows the center slat (part of item 2) with support legs being attached. The legs have adjustable levelers at their base. A note indicates to turn the leveler right. An icon resembling a timer shows "0:30".
Step 4: Place U-shaped Piece
Place the piece from top to bottom into the U-shaped slot.
Diagram Description: Illustrates the assembled frame (headboard, footboard, side rails). A U-shaped slot is indicated on the frame. The center slat with attached support legs is shown being lowered into this U-shaped slot.
Step 5: Unroll Slats
Unroll the slats onto the center slat, starting at the footboard and ending at the headboard.
Diagram Description: Shows the bed frame with the center slat in place. A bundle of individual slats is shown being unrolled sequentially across the width of the bed frame, resting on the side rails and center slat. Arrows indicate the direction of unrolling.
Step 6: Verify Slat Installation
Verify the slats are installed properly and the legs are perpendicular to the floor for full support.
Diagram Description: A side view of the completed bed frame showing the slats evenly spaced and resting on the side rails. The support legs are shown making contact with the floor, indicating proper support.
