Contents
- Tools and spare parts
- Illustration of product, parts and part numbers
- Product assembly
Safety and Installation Guidelines
[info] Installation must be carried out in accordance with Industry Regulations Säker Vatteninstallation.
[warning] Switch off main shut-off valve before changing mixer tap.
Certifications: TG 1672, EN 817, EN 1717, KIWA 1913.
RSK Numbers: 8312192, 8312194.
Tools and Parts
Required tools include pliers and an adjustable wrench (2x).
The product includes various components for mounting: a mounting bracket, a threaded rod, washers, nuts, and an Allen key. Specific part numbers are indicated in the product illustration.
For more information and product details, visit www.IKEA.com.
Specifications
| Recommended Operating Temperature | Max. 60°C |
| Maximum Operating Temperature | Max. 80°C |
| Recommended Operating Pressure | 1-5 bar |
| Maximum Operating Pressure | 0.5-10 bar |
| Connection Size | G3/8 (R10) |
The faucet spout can swivel 360°.
The faucet handle movement is limited to 120°.
Assembly Instructions
Step 1: Preparation
The faucet is shown ready for the initial mounting steps.
Step 2: Mounting the Faucet
[info] Seal the open surfaces with silicone sealant to prevent water from penetrating the worktop upon any leaks. Silicone sealant is not included.
The silicone sealant must be water- and mould-resistant and suitable for installation, according to EN 15651-3, Class XS1.
Drill hole diameter required: Ø34-37 mm (Ø1 3/8 - 1 1/2").
Maximum worktop thickness: 50 mm (2").
A specific component has a maximum thickness of 3 mm (1/8").
Step 3: Connecting Hoses
Ensure the pipe connection is flat and free from sharp edges.
[warning] IMPORTANT! Do not tighten too hard: this can damage hoses/pipes and washers.
Diagrams illustrate correct hose connections. Several types of flexible hoses are depicted, with a cross symbol indicating that they are not suitable for use with this faucet.
Step 4: Final Checks and Usage
Before initial use: Unscrew the aerator/flow guide with a coin and allow water to run freely for a few minutes. Then screw the aerator/flow guide back in place up to the stop. DO NOT OVER TIGHTEN.
[info] Check at regular intervals to make sure that the installation is not leaking.
