GLYPEN Mixer Tap
IKEA Design and Quality
About This Product
This document provides assembly instructions for the IKEA GLYPEN mixer tap. It includes information on required tools, parts, and step-by-step installation guidance.
Important Safety Information
ℹ️ The installation must be carried out in accordance with industry regulations, such as Säker Vatteninstallation.
⚠️ Before changing the mixer tap, switch off the main shut-off valve.
The product complies with EN 817 and EN 1717 standards.
Silicone sealant used for sealing must be water- and mould-resistant and suitable for installation according to EN 15651-3, Class XS1.
Recommended operating temperature: Max. 60°C. Maximum operating temperature: Max. 80°C.
Recommended operating pressure: 1-5 bar. Maximum operating pressure: 0.5-10 bar.
Tools and Spare Parts
Required tools may include a wrench and a screwdriver-like tool for assembly.
Parts List:
- Mixer tap body
- Spout
- Handle
- Flexible hoses (G3/8 R10)
- Mounting bracket/plate
- Securing nuts and bolts
- Aerator/Flow guide
- Part numbers referenced in diagrams: 110084, 120143, 120141, 120142, 120172, 120087, 126908, 124607, 190555.
Silicone sealant is not included.
Installation Guide
Step 1: Prepare the tap body and flexible hoses.
Step 2: Install the tap into the sink or countertop. Ensure the hole diameter is between 34-37 mm (1 3/8" - 1 1/2"). Seal open surfaces with silicone to prevent water ingress, especially around the mounting area (maximum thickness of 50 mm / 2").
Step 3: Secure the tap from underneath using the provided mounting bracket and nuts. Ensure proper alignment and rotation angles (e.g., 120°, 90°, 360° as indicated in diagrams).
Step 4: Connect the flexible hoses to the water supply lines. Ensure connections are secure but do not overtighten, as this can damage hoses and washers. The pipe connection must be flat and free from sharp edges.
Step 5: Attach the spout to the tap body.
Step 6: Final checks: Before use, unscrew the aerator/flow guide with a coin, let water run for a few minutes to flush the system, then screw the aerator back on, tightening only up to the stop. Regularly check the installation for leaks.
Product Information
Connection: G3/8 (R10)
For more information, visit www.IKEA.com.
