TOLLSJÖN Kitchen Mixer Tap

Important Information & Safety

[information] Installation shall be carried out in accordance with Industry Regulations Säker Vatteninstallation.

[warning] Switch off main shut-off valve before changing mixer tap.

Certifications: TG 1560, 1913, EN 817 | EN 1717. RSK No: 8312187.

Technical Specifications

Recommended Operating Temperature: Max. 60°C

Maximum Operating Temperature: Max. 80°C

Recommended Operating Pressure: 1-5 bar

Maximum Operating Pressure: 0.5-10 bar

Connection Type: G3/8 (R10)

Parts and Tools

Required Tools:

• Adjustable wrench
• Sealant gun (implied)
• Allen key

Included Parts:

• Mixer tap body with flexible hoses
• Mounting plate (triangular)
• Washers (C-shaped)
• Threaded rod
• Nut
• Small screw
• Part numbers visible in diagrams include: 126908, 110084, 120172, 120143, 120142, 120141, 120087, 10094939, 10094941.

Assembly Steps

Step 1: Prepare the Mixer Tap

Illustration shows the mixer tap body with flexible hoses attached, ready for installation.

Step 2: Mount the Mixer Tap

Drill hole size required: Ø 34 - 37 mm (1 3/8" - 1 1/2"). Maximum worktop thickness: 50 mm (2").

[warning] Seal the open surfaces with silicone to prevent water from penetrating the worktop upon any leaks. Silicone is not included.

[warning] Use silicone sealant that is water- and mould-resistant, suitable for installation, and compliant with EN 15651-3, Class XS1.

Illustration shows applying silicone to the underside of the tap base and inserting it through the worktop hole. The mounting plate, washers, and threaded rod are used to secure the tap from underneath.

Step 3: Adjust Spout Rotation

Illustration shows adjusting the spout's rotation limits: 120° and 360°.

Step 4: Connect Water Supply

[information] Ensure the pipe connection is flat and free from sharp edges.

[warning] IMPORTANT! Do not tighten too hard; this can damage hoses/pipes and washers.

Illustrations show connecting the flexible hoses to the water supply points, with visual cues for correct and incorrect tightening methods.

Final Checks & Usage

[information] Before use: unscrew the hand spray and allow water to run freely for 5 minutes. Then screw the hand spray back in place.

[information] Check at regular intervals to ensure the installation is not leaking.