Shark Navigator HEPA Filter Replacement
Replace the HEPA filter
Written By: Heather Shanks
[iFixit Logo]
Introduction
When cleaning the HEPA filter does not improve your vacuum's suction, it is time to replace it.
Step 1 — HEPA Filter
[Image Description: A hand is shown pressing a white latch located on the bottom of the front vent of a Shark Navigator vacuum cleaner. The vacuum has "ANTI-ALLERGEN COMPLETE SEAL PROFESSIONAL" visible on its body.]
On the front of the vacuum, locate the latch on the bottom of the front vent.
Step 2
[Image Description: A hand is shown pressing a white latch located on the bottom of the front vent of a Shark Navigator vacuum cleaner. The vacuum has "ANTI-ALLERGEN COMPLETE SEAL PROFESSIONAL" visible on its body.]
Press up on the latch and remove the front vent.
Step 3
[Image Description: A hand is shown lifting a grey, rectangular HEPA filter out of the vacuum cleaner.]
Lift the HEPA filter out of the vacuum.
Reassembly
To reassemble your device, follow these instructions in reverse order.
This document was last generated on 2017-09-28.
