Shark Navigator Lift-Away Deluxe NV360 Foam and Felt Filters Replacement
How to replace the foam and felt filters in Shark Navigator Lift-Away Deluxe NV360 vacuum.
Written By: Pramika Kumar
Introduction
Replacing these filters can help reduce abnormal noise and improve the smell of the vacuum.
Step 1: Foam and Felt Filters
Locate the latches on the side of the dust cup, the clear plastic chamber in the center of the vacuum.
Visual Description: The image displays the Shark Navigator vacuum cleaner. Red rectangular outlines highlight the release latches located on the sides of the dust cup, which is the transparent container in the center of the unit.
Step 2
- Pull the bottom of the latch with your hand in an upward direction.
- Lift the top of the latch up and away from the dust cup using your hand.
- Repeat the above steps with the latch on the other side of the dust cup.
Visual Description: This step features a sequence of three images. The first shows a hand pulling the lower part of a dust cup latch upwards. The second image depicts the upper part of the latch being lifted away from the dust cup. The third image illustrates the same procedure being performed on the latch on the opposite side of the dust cup.
Step 3
Lift the dust cup up and away by its handle on the top with your hands.
Visual Description: Two images show the dust cup being lifted from the vacuum cleaner by its handle.
Step 4
Lift the foam filter up, out, and away with your hands.
Visual Description: Three images show a hand reaching into the dust cup and lifting out a foam filter.
Step 5
Lift the felt filter up, out, and away with your hands by the tab on the top.
Visual Description: Three images show a hand grasping the tab on the felt filter and lifting it out of the dust cup.
Reassembly
To reassemble your device, follow these instructions in reverse order.
