⚙️ PARTS:
- Foam and Felt Filters (1)
1️⃣ Step 1 — Filter
A hand is shown lifting a grey tab on the side of the Shark Navigator's dust canister, demonstrating how to unclip it from the vacuum body.[Image: Hand unlatching dust canister tab]
The dust canister is partially detached from the vacuum body, revealing the filters inside.[Image: Dust canister partially removed]
The dust canister is fully detached, showing the foam and felt filters within.[Image: Detached dust canister with filters visible]
First unclip the dust canister from the body of the vacuum by lifting up the grey tabs on either side of the canister.
2️⃣ Step 2
The detached dust canister is shown. A hand is reaching inside to remove a large, plush filter from the bottom compartment.[Image: Hand removing large plush filter from canister]
At the base of the vacuum will be a large plush filter. This is one of two filters in this compartment. Take this filter out.
3️⃣ Step 3
The detached dust canister is shown. The large plush filter has been removed, revealing a thinner filter underneath at the base of the compartment.[Image: Thinner filter visible at the base of the canister after removing the larger filter]
The second filter is thinner and lies at the base of the vacuum. Replace this filter first before placing the larger replacement filter on top of it.
Reassembly
To reassemble your device, follow these instructions in reverse order.
