ACTIVESHOP Cosmetic Chair 557A User Manual

Introduction and Safety First Steps

Before using the cosmetic chair, read the instructions and perform the following steps:

1. Ensure all packaging materials have been removed.
2. Ensure the chair is technically sound.
3. Place the cosmetic chair in the location where it will be used.

Tip: Children and inexperienced persons are forbidden to use this device. Children must be supervised and must not play near the cosmetic chair.

Dimensions

A diagram illustrates the cosmetic chair with various dimensions indicated:

• Overall Length: 110 cm
• Seat Width: 51 cm
• Backrest Height: 70 cm
• Leg Rest Length: 60 cm
• Armrest Width: 40 cm
• Seat Height: Approximately 76 cm
• Tray Dimensions: 31 cm x 25 cm x 10 cm
• Frame Width: 51 cm
• Angle Adjustments: Backrest 0-65°, Leg Rest 0-45°

Assembly Instructions

Follow these steps to assemble the cosmetic chair:

Step 1: Assemble the Chair Frame

Lay the sofa on a flat, stable surface. Attach the chair frame to the sofa using screws. Sequentially place the flat bracket (1), then the connector (2), and the screw (3).

Step 2: Assemble the Tray Support

Place the tray support onto the frame and secure it with screws. Connect the tray support to the connecting pipe and tighten with screws as shown in the illustration.

Step 3: Attach the Connecting Rod

Secure the chair frame connecting rod to the 4 holes in the chair legs with screws.

Step 4: Install Armrest Adjusters

On both sides of the seat legs, assemble the backrest and leg rest adjuster with screws.

Step 5: Assemble Armrest Knob

Align the knob with the armrest mounting hole and tighten clockwise. Loosen the knob to change the armrest position as shown in the illustration.

Step 6: Install Armrests

Insert the armrest into the hole on the side of the backrest. The armrest must be firmly secured. Turn it clockwise or counter-clockwise to lock it in place.

Step 7: Assemble the Container

Slide the container into the guides located under the seat.

Seat Functions

1. Backrest Lifting

The angles of the backrest and leg rest can be adjusted using manual levers. Both the backrest and leg rest have separate levers, allowing independent height adjustment for each part. This customization ensures maximum client comfort. The chair can be reclined to a fully flat position. To lift the backrest, grasp the lever, lift it, and set the desired height.

2. Backrest Lowering

Hold the chair backrest, and with your other hand, grasp the lever handle and lower it until the desired position is reached. Release the lever once the desired height is achieved.

Cleaning and Disinfection

To maintain the chair's condition, regular cleaning is essential. Clean and disinfect the chair after each use. Thorough disinfection once a month is recommended.

I. Metal and Plastic Surfaces

Wipe metal and plastic surfaces and controls with a damp cloth. A small brush is useful for cleaning hard-to-reach areas or corners. Avoid using excessive liquid. Disinfect with a suitable disinfectant.

II. Stainless Steel Surfaces

Clean with a mild detergent solution. Ammonia and most solvents can remove stubborn stains. Avoid chlorine-based solutions.

III. Painted or Chrome Metal Surfaces

• Do not use water jets (showers, high-pressure water cannons).
• Do not clean at high temperatures or high humidity. Avoid storing the device in conditions that may cause liquid contamination.
• Do not use solvents or acids for cleaning.

IV. Chair Upholstery

Clean the chair upholstery evenly with a special leather cleaner and then wipe with a clean, soft cloth.

Troubleshooting

Safety Precautions

1. This is professional equipment intended for use in cosmetic procedures. Use by qualified cosmetic specialists helps prevent adverse outcomes during treatment.
2. Do not disassemble or attempt to use the device for purposes other than those specified in this manual. All servicing and repair work must be performed only by an authorized ACTIVESHOP Ltd. service technician.
3. Do not install or use the device near liquids, in damp areas, or with wet hands to prevent liquid ingress.
4. In the following cases, immediately unplug the device from the electrical outlet and contact authorized ACTIVESHOP Ltd. service: (a) liquid has entered the device, (b) the device emits a strange odor, smoke, or unusual noises, (c) the power cord is damaged, (d) the device has been overturned or its casing is damaged.
5. Do not place any objects on the cables. Do not install the unit where someone might step on the power cord.
6. For safety, unplug the power cord from the electrical outlet each time you finish working with the device.
7. Do not insert anything into the device openings. If a foreign object enters an opening, unplug the cord and contact the distributor or manufacturer.
8. Do not place the device on unstable trolleys, shelves, or vehicles. A dropped device may be damaged.
9. To ensure the device's intended lifespan, maintain a one-minute interval between pressing the power button (between switching on and off, and vice versa).
10. The power supply must comply with the technical specifications indicated on the nameplate. Failure to do so may result in improper operation, damage, or fire.

ATTENTION:

1. In case of power cord failure or other malfunctions, contact an authorized service center to avoid any danger.
2. This device may be used by children aged 8 and above, and by persons with reduced physical or mental capabilities, or lack of experience and knowledge, provided they are supervised or instructed on safe use and understand the associated risks.
3. The equipment is not intended for children to play with. Do not allow children to play with the device.
4. Do not leave the device unattended when children or persons unfamiliar with its operation are nearby.
5. This electrical device is not a toy. Improper use or contact with electrical equipment can cause injury or death; therefore, the device must be used and stored out of reach of children.

Disposal and Transport

Device Disposal

Dispose of used electrical devices, accessories, and packaging at recycling centers, adhering to environmental protection principles. Electrical devices must not be discarded in household waste bins. Follow the disposal regulations for this type of equipment.

To protect the environment, in accordance with Directive 2012/19/EU on waste electrical and electronic equipment (WEEE), used electrical devices must be collected separately and handed over to collection points for waste electrical and electronic equipment. Disused and old devices contain fully recyclable components and should be sent for recycling. Therefore, they should be handed over to appropriate collection points, including ACTIVESHOP Ltd.

Symbol Description: [crossed-out wheeled bin symbol]

Storage and Transportation

The unit must be transported in its original packaging within a temperature range of -20 °C to +50 °C. The unit should be stored in a well-ventilated room with relative humidity not exceeding 75%. The operating temperature range is +10 °C to +40 °C. During storage and transport, the device must not be thrown, dropped, subjected to mechanical impacts, or exposed to atmospheric conditions.