JBC CC2002 Cable Collector

Instruction Manual

For NAS & NAN Stations

Website: www.jbctools.com

Introduction

This manual corresponds to the reference: CC2002

Packing List

The following items are included:

Cable Collector for NAS & NAN Stations - 1 unit
Allen Key 1,5 mm - 1 unit (Ref. 0741610)
Manual - 1 unit (Ref. 0025685)

Assembly the Tool Holder

Follow these steps to assemble the tool holder:

Step 1: Attach the cable collector to the base. [Image: Cable collector base being attached to a unit, with a downward arrow indicating connection.]

Step 2: Insert the collector into its holder. [Image: Side view of the cable collector being inserted into a holder, with an arrow indicating the direction of insertion.]

Step 3: Secure the collector by tightening a screw. [Image: A screw being tightened with a tool, indicated by a circular arrow, to secure the collector.]

Replacing the Tool Holder

To replace the tool holder:

Step 1: Loosen the screw (labeled 1) with a circular motion. [Image: A screw being loosened (circular arrow) and the old tool holder being pulled upwards (upward arrow).]

Step 2: Withdraw the old tool holder (labeled 2). [Image: Upward arrow indicating removal of the old tool holder.]

Step 3: Insert the new tool holder (labeled 3). [Image: Downward arrow indicating insertion of the new tool holder.]

Step 4: Tighten the screw (labeled 4) to secure the new holder. [Image: A screw being tightened (circular arrow) to secure the new holder. The JBC NAU Control Unit is visible.]

These steps are shown in relation to the JBC NAU Control Unit.

Specifications

CC2002 Cable Collector for NAS & NAN Stations

Reference: CC2002

Net Weight: 42 g / 0.09 lb
Dimensions (L x W x H): 339 x 73 x 35 mm (13.35 x 2.87 x 1.38 in)
Package Dimensions / Weight (L x W x H): 235 x 40 x 40 mm / 70 g (9.25 x 1.57 x 1.57 in / 0.15 lb)

Complies with CE standards.

Warranty and Disposal

Warranty

JBC provides a 2-year warranty covering manufacturing defects, including replacement of defective parts and labor. The warranty does not cover product wear or misuse. For warranty validation, equipment must be returned, postage paid, to the dealer where it was purchased.

Disposal Information

This product should not be disposed of in general waste. In accordance with European directive 2012/19/EU, electronic equipment at the end of its life must be collected and returned to an authorized recycling facility.

Compliance Marks: CE, [WEEE recycling symbol], EAC