Resistex Miks Lighting Fixture

Product Overview

This document provides installation instructions and important safety information for the Resistex Miks lighting fixture. The Miks model is available in adjustable and low luminance versions.

Product Categories:

• Orientable / Adjustable: Fixtures designed for directional lighting.
• Basse Luminance / Low Light: Fixtures optimized for reduced glare and comfortable illumination.

Version: V1.1 - 09.22

Installation Instructions

Safety Notes

• ⚠️ Never work on the luminaire when voltage is present.
• The installation must be performed by a professional installer in compliance with the standards and regulations relating to electrical installations.
• Be aware of the risk of electrostatic discharges (ESD Norm). Handle with precautions.
• Please observe the notes and steps described in the mounting instructions.

Maintenance Instructions

• Do not use chemicals or abrasive products to clean the fixture.
• Keep these instructions for dismantling or future maintenance. Additional information about RESISTEX luminaires is available on the website www.resistex-sa.com.
• RESISTEX cannot be responsible for any misuse of the product.

Mounting Steps

1. Step 1: Preparation

   Identify the required ceiling cutout diameter: Ø69 mm (+/-1 mm).

   [Diagram showing dimensions for ceiling cutout and fixture]
2. Step 2: Fixture Insertion

   Insert the Resistex Miks fixture into the prepared ceiling opening.

   [Diagram showing the fixture being pushed upwards into the ceiling cutout]
3. Step 3: Securing the Fixture

   Rotate the fixture to engage its internal mounting mechanism and secure it in place.

   [Diagram showing the fixture being rotated to lock into the ceiling]
4. Step 4: Electrical Connector Detail

   Examine the electrical connector block, noting the terminals for Live (L) and Neutral (N).

   [Diagram showing the electrical connector block with L and N terminals clearly marked]
5. Step 5: Opening the Connector

   Open the electrical connector block to prepare for wire insertion.

   [Diagram showing the electrical connector block being opened]
6. Step 6: Wire Insertion

   Insert the electrical supply wires into the appropriate terminals within the connector block.

   [Diagram showing wires being inserted into the connector block terminals]
7. Step 7: Closing the Connector

   Close the electrical connector block securely to complete the connection.

   [Diagram showing the connector block closed]
8. Step 8: Spring Clip Engagement

   The fixture's integrated spring clips hold it firmly against the ceiling surface.

   [Diagram showing the fixture held in place by its spring clips]
9. Step 9: Polarity Verification

   Verify that the electrical connections are made with the correct polarity (Live to L, Neutral to N). An indicator shows correct wiring (✅) and incorrect wiring (❌).

   [Diagram illustrating correct and incorrect electrical polarity connections]
10. Step 10: Final Installation

    The fixture is now installed. An 'OFF' symbol indicates the current state of the connected switch.

    [Diagram showing the installed fixture in the ceiling, with an 'OFF' power symbol]