KINGSTON

Tools Required

Parts

Installation Steps

1. Step 1. Locate where you would like to install the towel ring. Place a base onto the wall and trace around it with a pencil (Fig 1).
   Fig. 1: Shows the towel ring base positioned against a wall, with a pencil marking its outline.
2. Step 2. Place the mounting plate in the center of the pencil outline you just made and mark the location of the mounting screws (Fig 2). Drill holes at the marked locations (Fig 3).
   Fig. 2: Illustrates placing the mounting plate within the marked outline and marking screw positions. Fig. 3: Depicts drilling holes at the marked screw locations.
3. Step 3. Insert anchors into the holes with a hammer until flush with the wall (Fig 4).
   Fig. 4: Shows wall anchors being inserted into the drilled holes and hammered flush with the wall.
4. Step 4. Screw the mounting plate (with the lips facing out) to the wall with the mounting screws (Fig 5).
   Fig. 5: Demonstrates screwing the mounting plate to the wall using the mounting screws.
5. Step 5. Place the unit, with the small hole in the base underneath, over the mounting plate by tightening the slotted set screw with a flathead screwdriver until the base is tightly fixed (Fig 6).
   Fig. 6: Illustrates attaching the towel ring unit to the mounting plate by tightening the set screw.

Cleaning

Clean with a damp cloth only.

Avoid using metal or abrasive polishes.